FCC ID: PQTDORM46 315 MHz Keyfob Transmitter

PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE Programming Instructions:

Disclaimer: All currently programmed and new remotes must be reprogrammed to vehicle. Please have all remotes in hand at time of programming. Once plugging in the programmer you will have 2 minutes to program all new and existing remotes to vehicle. After 2 minutes your session will time out and your vehicle will no longer be in programming mode. Programmer will work for no more than 3 sessions. 1. 2. 3. 4. 5. Close and lock doors. Insert Key into ignition and turn to IGN ON (Do not crank). Insert Programmer into your vehicles OBD2 Port. This port is typically located underneath the dashboard below the steering wheel. It may be covered by a faceplate that will easily pop off. Once the Programmer is inserted, wait for a chime or orange light on the Programmer to come on. This will indicate that the unit is ready to program the first remote. Press and hold the lock and unlock button on the remote simultaneously until you hear a chime, buzzer, or the door locks cycle (approximately 10-

15 seconds). To program additional remotes, repeat step 4. 6. 7. When all remotes are programmed wait 60 seconds for buzzer to sound continuously, then remove programmer from OBD2 Port. FCC WARNING Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the users authority to operate the equipment. IC WARNING FVIN 6399105IC PROGRAMMING ADDITIONAL REMOTES REQUIRE AT LEAST ALREADY PROGRAMMED REMOTE This device contains licence-except transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1) This device may not cause interference. 2) This device must accept any interference, inclduing interference that may cause undesired operation of the device. Cet appareil contient des metteurs / rcepteurs sans licence qui sont conformes aux RSS exempts de licence d'Innovation, Sciences et Dveloppement conomique Canada. Son fonctionnement est soumis aux deux conditions suivantes: 1) Cet appareil ne doit pas provoquer d'interfrences. 2) Cet appareil doit accepter toute interfrence, y compris les interfrences pouvant entraner un fonctionnement indsirable de l'appareil.

Note:LabellocationisidenticalonallmodelslistedforPQTDORM46. Labeltextwillbelaseretchedontokeyfob.

Jor EE DORMART NEW SINCE 1918 To: Federal Communications Commission Authorization and Evaluation Division From: Joseph Braun, Senior Vice President, General Counsel Subject: Agent Authorization for certification of FCC ID: POTDORM46 Dear Sir or Madam:

Dorman Products hereby appoints Richard Reitz of Retlif Testing Laboratories to act as our agent in the matter of FCC filings for the certification of FCC ID: PETDORM46 Dorman Products further attest that no party to the application is subject to denial of federal benefits pursuant to section 5301 of the Anti-Drug Abuse Act of 1988, 21 USA 853(a). Sincerely, Joseph Braun Senior Vice President, General Counsel Dorman Products, Inc. Date: 3/2/2020

NEW SINCE 1918 Subject: Confidentiality Request regarding application for certification of FCC ID:

PQTDORM46 Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

TH Dit ta yo File Name Operational Description PQTDORM46 OpDes.pdf No ilovit lite PQTDORM46 Schem.pdf Part List PQTDORM46 PartsLst.pdf Block Diagram PQTDORM46 BlkDia.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Pursuant to DA04-1705 June 15, 2004 of the Commissions public notice, we also request temporary confidential treatment of information accompanying this application as outlined Lord Coh Exhibit Type CET None None Sincerely, Joseph Braun Senior Vice President, General Counsel Dorman Products, Inc. Rev 11/20/07 Federal Communications Commission Authorization and Evaluation Division

EEE Eee RORMANT NEW SINCE 1918 Dear Sir or Madam:

The application for FCC ID: PQTDORM46 will cover 3 unique part numbers. The only differences are in the plastic case containing the PCB. Each PCB is equipped with multiple solder pads to accommodate the variety of button configurations. DESCRIPTION KEYLESS ENTRY REMOTE ESSE a aon KEYLESS ENTRY REMOTE NEW PRODUCTS. NEW SOLUTIONS. NEW OPPORTUNITIES. 2ANN Fact Walnut Strasat a Colmar DA 12016-12NN e@ Ciuctamar GSarvira: 1-890-592-7407 Fav: ROQ.G647_7n1N Joseph Braun Senior Vice President, General Counsel Dorman Products, Inc.