Front 55 X 440 MM 80g Smart Button Specication Dimension 2 1 Power supply: Battery CR2032 3V DC Communication: ZigBee 3.0*
Bluetooth Low Energy*
Control distance: 25m open area Ingress Protection: IP55 Dimensions: 45 X 45 X 12.5mm Operating temperature: -10 C~45 C Working Humidity: <90%RH Life of battery: 1 years (General use)
CR2032 1. Remove the screw 2. Install the CR2032 battery 3 Hold 6s V1.5A 55 45 12.5
*Available for selected model 3. HoldRESETto 6s, LED will start ashing 4. Install the cover Gateway is required to connect device 55 Rear Install the battery / Reset / Pairing Connet to Network 4 5 Add Device 5.1 Add Device 5.2 Remote mode (Default mode) Scan the QR code to download APP ZigBee model Bluetooth model ZigBee model Only 5.3 Remote mode 5.4 Remote mode 5.5 Mode swap 5.6 Scene mode 5.7 Scene mode 5.8 Scene mode 5.9 FCC Warning 6 FCC Warning ZigBee model Only ZigBee model Only ZigBee model Only B. Control description under remote mode UI or functions may change according to rmware or APP version Single Press On Dual Press O Single Press Change preset light mode when light up Long Press >3s Dimming 3click Note: The above functions may be dierent depending on the model of the smart bulb Remote mode Scene mode To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20 cm supported by the operating and installation transmitter and its antenna(s). between the radiator and your body, and fully congurations of the This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Note: The Grantee is not responsible for any changes or modications not expressly approved by the party responsible for compliance. such modications could void the user's authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement.