2011.8. Rev0.0 For the reason of exclusive equipment for Nomura Engineering, this manual that includes only regulatory statements is prepared. KXN-RF24-01 Installation Manual FCC ID: Z3D00KXN024W001A Affix [Contains FCC ID: Z3D00KXN024W001A] label to end product FCC Warning Changes or modifications not expressly by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1)this device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency(RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF energy that are deemed to comply without testing of specific absorption ratio(SAR).
- 1 -
2011.8. Rev0.0 For the reason of exclusive equipment for Nomura Engineering, this manual that includes only regulatory statements is prepared.
(1) Solder a KXN-RF24-01 module on a base PCB. Base PCB Solder a module on the base PCB.
(2) Install the base PCB into a case Install the (1) base into a case. Screw the base to the case with 4-M2x3mm flat heads.
(3) Connect a cable and an antenna. Connect a cable and an antenna.
- 2 -