User's Manual Bluetooth System ECEN ELECTRONICS CO., LTD. No.26-13-1 Fongle Road, Beitun District. Taichung City, 40673, TAIWAN. TEL:+886-4-2422-3369 FAX:+886-4-2422-4360 e-mail:ecen@ms8.hinet.net http://www.ecen.com.tw LINK MIN MAX LANG Bluetooth LINK MIN MAX LANG A- LINK:pairing (turn on/off the bluetooth module power) B- :play / stop C- LANG.: language selection Instruction:
A.Press LINK button for 4 seconds, enter to pairing setting. B. the red/blue light flash, automatically searching device pairing in 10 mins. Pairing matched blue light is keeping flash. No pairing match the light will shut off after 10 mins automatically. C.Press LANG button 2 seconds for setting up language, introduction Language in order of English / Chinese / Spanish / French / German. For setting the demand language, press LANG button again when the language is playing.
**Suggestion: When language is set, please turn off the power for memory system to set completely. Specifications Frequency range:2402~2480 (ISM BANDS) MODULATION METHOD:GFSK,/4-DQPSK, 8-DPSK Transmission power:Typical 2.66dBm, Peak value:3.16dBm Sensitivity: -89.5dBm (GFSK, 0.1% BER, 1Mbps) RF input impedance: 50 ohm Baseband crystal OSC: 26MHz Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.
(Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.