1523 26th St. Santa Monica, CA 90404 Suppliers Declaration of Conformity Compliance Information Statement Unique Identifier:
Ring Retrofit Alarm Kit Responsible Party and Party issuing Suppliers Declaration of Conformity Ring LLC dba Ring 1523 26th Street Santa Monica, CA 90404 U.S.A. www.ring.com / Legal@ring.com FCC Compliance Statement (for products subject to Part 15) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/
TV technician for help. Innovation, Science and Economic Development Canada (ISED) Compliance This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device. Conformit Innovation Sciences et Dveloppement conomique Canada
(ISDE) Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
Lappareil ne doit pas produire de brouillage. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. CAN ICES-3 (B)/NMB-3(B) AVERTISSEMENT : Tout changement ou modification cet appareil qui na pas fait lobjet dune autorisation expresse par la partie responsable de sa conformit pourrait annuler le droit pour lutilisateur doprer lquipement. CAUTION: To reduce the risk of electrical shock, DO NOT open the unit. There are no user serviceable parts inside the unit. Refer to customer support for any repairs. ATTENTION : Pour rduire le risque dlectrocution, NE PAS ouvrir lappareil. Aucune pice interne nest rparable par lutilisateur. Veuillez vous rfrer au service la clientle pour toute rparation. In accordance with FCC requirements of human exposure to radio frequency fields, the radiating element shall be installed such that a minimum separation distance of 20 cm is maintained from the general population. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of the used batteries according to the manufacturers instructions. Conformment aux exigences dIndustrie Canada en matire dexposition humaine aux champs de radiofrquences, llment rayonnant doit tre install de telle sorte quune distance minimale de 20 cm soit maintenue par rapport la population gnrale. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. ATTENTION : Danger dexplosion si la pile nest pas remplace correctement. Remplacez la pile uniquement par une pile identique ou par une pile du mme type que celle recommande par le fabricant. Suivez les instructions du fabricant pour jeter les piles uses.