E D I U G T R A T S K C I U Q X X X X
-
X X X
-
X X X t a s u l l a c r o m o c
. s m e t s y t n e v o c e
@
t r o p p u s t a s u l i l a m E
?
p e h d e e N 1 LAUNCH APP Our app will guide you through the complete install, step by step. Use your mobile device. Search for "Ecovent"
Use the included tablet. It comes pre-loaded with the Ecovent app. 5 min 2 minConnect the smart hub to your home's WiFi router using the included ethernet cable. Then plug in the power cord and youre good to go.Installing vents and sensors happens one room at a time.If you already have a Nest thermostat installed.If you purchased a Sensi thermostat through Ecovent and need to install it2345 min15 min per room20-45 minSETUPTHERMOSTATCONNECT HUBROOM-BY-ROOMINSTALLIncluded Changes or modications not expressly approved by Ecovent could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. WARNING! This equipment complies with FCCs and ICs RF radiation exposure limits set forth for an uncontrolled environment under the following conditions: This equipment should be installed and operated such that a minimum separation distance of 20cm is maintained between the radiator (antenna) & users/nearby persons body at all times. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. THIS ECOVENT PRODUCT CONTAINS OPEN SOURCE SOFTWARE. FOR LICENSING, COMPLIANCE, AND OTHER IMPORTANT INFORMATION, PLEASE VISIT HTTPS://WWW.ECOVENTSYSTEMS.COM/PRODUCT-INFO.