Regulatory & Warnings section of Ducati vehicle manual Radio components Certifications EU Directive 2014/53/EUmplified EU declaration of conformity Your vehicle is equipped with a range of radio equipment. The manufacturers of these radio equipment declare that equipment comply with Directive 2014/53/EU where required by law. The full text of the EU declarations of conformity are available at the following internet address:
certifications.ducati.com Radio equipment installed in the vehicle Frequency band Bluetooth 2402 MHz 2480 MHz DSB 120 KHz 140 KHz Max Transmission Power 4,4mW
<66dBA/m (10m) Radio Manufacturers' addresses All radio components pursuant to 2014/53/EU must bear the manufacturer's address. For components that, due to their size or nature, cannot be furnished with a sticker, the respective manufacturers' addresses as required by law are listed here:
Radio equipment installed in the vehicle Manufacturers' addresses DSB EGICON Via Posta Vecchia, 36, Mirandola (MO) - Italy FCC/ISED certifications The manufacturers of these radio equipment declare that devices comply with the FCC and ISED regulations. Radio equipment FCC ID IC ID DSB 2ANYI-ZDM1604D00 23285-ZDM1604D00 To comply with FCC and ISED RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of these devices and all nearby persons. Regulatory & Warnings section of Ducati vehicle manual FCC Certification ISED Certification This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-
exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) Lappareil ne doit pas produire de brouillage; (2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Brazil Certification ANATEL - Certificao ANATEL Este produto est homologado pela ANATEL, de acordo com os procedimentos regulamentados pela Resoluo 242/2000, e atende aos requisitos tcnicos aplicados. Para maiores informaes, consulte o site da ANATEL www.anatel.gov.br Modelo: ZDM1604-D-00, ZDM1604-F-00