User manual 1 Functionalschematicdiagram THREE MOTORS 1. Description of Power Host is equipped with Switching power supplyDC12V1.25A.This machine is the maximum current not more than 1.2A when the rated load weight.When current more than 1.2A : Buzzer will alarm in the host, and one second later ,SCM detect the fault andthen disconnect motor power automatically to protect the Host. 2. Instructions 1) Turn on the power, the TV Mount will turn back to midpoint automatically,then contraction, return and turn off. 2) Press the button OPEN on the remote, the TV Mount will extend and stop. 3) Press the button LEFT,RIGHT,DOWN to adjust the angle that you want. 4) Hold the button MEMORY long time and adjust the angle you want, then press the button MEMORY again, the red light turn off and this angle is saved. 5) Press the button OPEN again, the TV Mount will turn back to midpoint automatically, then contraction, return and turn off; if you want to turn on again, press the button MEMORY only, then the TV Mount will restore the angle that you saved before turn off. FCC ID: VII-MCL-08 IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules:
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipments. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV Technician for help.