unbekannt unbekannt Products Solutions Services Special Documentation Bluetooth module (BT10) Accessory Application Remote operation of HART devices via Bluetooth wireless technology Suitable for the following device versions Device Communication Firmware version Device revision Levelflex FMP5x Micropilot FMR5x Micropilot FMR6x HART HART HART 01.03.zz or higher 01.02.zz or higher 01.00.zz or higher 4 3 1 When using the Bluetooth module the minimum supply voltage increases by up to:
3 V for FMR5x 2 V for FMP5x/FMR6x Your benefits Quick and easy commissioning via SmartBlue (app) No additional tools or adapters required Signal curve via SmartBlue (app) Encrypted single point-to-point data transmission (tested by Fraunhofer institue) and password protected communication via Bluetooth wireless technology Range under reference conditions: >10 m (33 ft) Registered trademarks Bluetooth The Bluetooth word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Endress+Hauser is under license. Other trademarks and trade names are those of their respective owners. Apple, the Apple logo, iPhone and iPod touch are trademarks of the Apple Inc., which are registered in the USA and other countries. App Store is a service mark of the Apple Inc. Apple Android Android, Google Play and the Google Play logo are trademarks of Google Inc. DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) Declaration of Conformity Restrictions in case of retrofitting Depending on the approval of the transmitter, application of the Bluetooth module may be restricted. A device may only be retrofitted with a Bluetooth module if the option NF
(Bluetooth) is listed in the associated Safety Instructions (XA) under Optional specifications. 2 V. 2, Rev. 2, 11-06-2018 Endress+Hauser DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) Endress+Hauser V. 2, Rev. 2, 11-06-2018 A0036640 3 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) 4 V. 2, Rev. 2, 11-06-2018 A0036641 Endress+Hauser DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) Endress+Hauser V. 2, Rev. 2, 11-06-2018 A0036642 5 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Europe Canada and United States Bluetooth module (BT10) Radio approvals This device meets the requirements of the Telecommunications Directive RED 2014/53/EU:
EN 300 328 V2.1.1 EN 301 489-1 V2.1.1 EN 301 489-17 V3.1.1 EN 62311: 2008 English This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications made to this equipment not expressly approved by Endress+Hauser SE+Co. KG may void the FCC authorization to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Radiofrequency radiation exposure information This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Franais Le prsent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :
L'appareil ne doit pas produire de brouillage, et L'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Les changements ou modifications apportes cet appareil non expressment approuve par Endress+Hauser SE+Co. KG peut annuler l'autorisation FCC d'utiliser cet appareil. Dclaration d'exposition aux radiations Cet quipement est conforme aux limites d'exposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. Ce transmetteur ne doit pas tre plac au mme endroit ou utilis simultanment avec un autre transmetteur ou antenne. Japanese Radio Law and Japanese Telecommunications Business Law Compliance. This device is granted pursuant to the Japanese Radio Law () and the Japanese Telecommunications Business Law (). This device should not be modified (otherwise the granted designation number will become invalid). V. 2, Rev. 2, 11-06-2018 Endress+Hauser Japan 6 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) Operation via Bluetooth wireless technology 1 1 2 3 Possibilities for remote operation via Bluetooth wireless technology Transmitter power supply unit Smartphone / tablet with SmartBlue (app) Transmitter with Bluetooth wireless technology Preparing installation of the Bluetooth module A0034939 A0036446 Note down the ID of the Bluetooth module. The ID serves as the initial device password in SmartBlue. Opening cover 1. Loosen the screw of the securing clamp of the electronics compartment cover using an Allen key (3 mm) and turn the clamp 90 counterclockwise. 2. Unscrew cover and check lid gasket, replace if necessary. A0021430 Endress+Hauser V. 2, Rev. 2, 11-06-2018 7 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT123ID:ID:2.1.3 mm Bluetooth module (BT10) Mounting the Bluetooth module 1 2 3 4 A0021431 A0036086 A0036452 A0036453 8 V. 2, Rev. 2, 11-06-2018 Endress+Hauser DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT Bluetooth module (BT10) 5 For FCC / IC applications: If not yet present, affix the "FCC / IC approval" sticker to the display. A0036672 Closing electronics compartment cover 1. 2. Screw back firmly electronics compartment cover. Turning securing clamp 90 clockwise and tighten the clamp with 2.5 Nm using the Allen key
(3 mm). A0021451 Commissioning via SmartBlue (app) Requirements Device requirements Commissioning via SmartBlue is only possible if the device has a Bluetooth module. System requirements SmartBlue SmartBlue is available as download for Android devices from the Google Play Store and for iOS devices from the iTunes Store. iOS devices:
iPhone 4S or higher from iOS9.0; iPad2 or higher from iOS9.0; iPod Touch 5th generation or higher from iOS9.0 Devices with Android:
from Android 4.4 KitKat and Bluetooth 4.0 Initial password The ID of the Bluetooth module serves as the initial password used to establish the first connection to the device. It can be found:
on the information sheet which is supplied with the device. This serial number specific sheet is also stored in W@M. on the nameplate of the Bluetooth module. Endress+Hauser V. 2, Rev. 2, 11-06-2018 9 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFTESCOPENOPEN2.2,5 Nm3 mm1. Bluetooth module (BT10) 2 1 2 Device with Bluetooth module Electronics housing of the device Nameplate of the Bluetooth module; the ID on this nameplate serves as initial password. A0036790 All login data (including the password changed by the user) are not stored in the device but in the Bluetooth module. This must be taken into account when the module is removed from one device and inserted into a different device. Commissioning Download and install SmartBlue 1. To download the app, scan the QR code or enter "SmartBlue" in the search field 3 Download link 2. Start SmartBlue 4 SmartBlue pictogram 3. Select device from displayed livelist (available devices only) A0033202 A0029747 A0029502 5 Livelist Only one point-to-point connection can be established between one sensor and one smartphone or tablet. 10 V. 2, Rev. 2, 11-06-2018 Endress+Hauser DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT12 Bluetooth module (BT10) 4. Perform login 6 Login Enter user name -> admin Enter initial password -> ID of the Bluetooth module Change the password after logging in for the first time 5. 6. 7. 8. By wiping from the side, additional information (e.g. main menu) can be dragged into the image A0029503 A0029504 7 Main menu Envelope curves can be displayed and recorded Additionally to the envelope curve, the following values are displayed:
D = Distance L = Level A = Absolute amplitude In the case of screenshots, the displayed section (zoom function) is saved In video sequences, always the whole area without zoom function is saved It is also possible to send envelope curves (video sequences) using the relevant smartphone or tablet functions. Endress+Hauser V. 2, Rev. 2, 11-06-2018 11 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFTadmin Envelope curve display (example) in SmartBlue; Android view 8 1 2 3 4 5 Move time on time axis Record video Create screenshot Navigation to mapping menu Start / stop video recording Bluetooth module (BT10) A0029486 A0029487 Envelope curve display (example) in SmartBlue; IoS view 9 1 2 3 4 5 Move time on time axis Record video Create screenshot Navigation to mapping menu Start / stop video recording 12 V. 2, Rev. 2, 11-06-2018 Endress+Hauser DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT1234545123 DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT *unbekannt*
unbekannt www.addresses.endress.com DRAFTDRAFT DRAFT DRAFT DRAFT DRAFT DRAFTDRAFT DRAFT DRAFT