Users Manual and Installation Instructions for Model 400 Phone Interrupter, which is part of Energy Technologies Group LLC S3E security and energy savings system. Mounting: Unit is to be mounted to the wall using two (2) #4 screws. Wiring: Unit shall be connected to the telephone jack located on the wall via a telephone patch cord, connected to the room telephone via the telephones patch cord (unplugged from telephone jack on the wall), and have a 12 volt DC power source connected to terminal block J1 with the positive wire connected to terminal 1 and the negative wire connected to terminal 2. Adjustments: There are no adjustments on this model device. Identity Programming: After the unit has been installed it will require identity programming to make the unit active. This unit has a programming port used to load room numbers, operational characteristics. Please refer to Identity programmers manual for further details on identity programming. Operation: After completion of mounting, wiring and identity programming the unit is ready for use. A Model 100 Security Thermostat is required for operation. Limitation of liability - Neither Energy Technologies Group or its suppliers shall be liable for the loss of use of this product, loss of income, inconvenience, or any other damages whether direct, indirect, or consequential, arising out of the use or inability to use this Energy Technologies Product. Limited 1 Year Warranty - The Model 400 Phone Interrupter product is warranted by Energy Technologies Group, LLC for a period of 1 year from date of initial installation. This warranty protects against defects in materials or workmanship when exposed to normal use. This warranty is void if installation and or identity programming is performed by someone other than an authorized Energy Technologies Group installer. This limited warranty does not cover damage, failure or mal-function caused by or attributable to acts of God. This limited warranty is only available to the original purchaser. This warranty does not cover damages due too abuse, improper installation, misuse or abnormal usage. Customer Service Installation If problems are encountered during installation contact (1-877-400-
0003) and request assistance. Operation If problems arise during operation contact (1-877-400-0003) and request assistance. Warranty Repair If a warranty repair arises please contact (1-877-400-0003) and request a returned material authorization. FCC Compliance This device complies with part 15 of the FCC rules. Operation is subject to the following two (2) conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the users authority to operate the equipment.