INSTRUCTION MAN USE UNDER SUPERVISION OF AN ADULT RADIO CONTROL PLEASE READ CAREFULLY BEFORE STARTING TO OPERATE FLHSH LEM iA
@FULLY DIRECTIONAL
@WHEEL ALIGNMENT
@WITH SUSPENSION
@WITH WORKING HEADLIGHTS:
AND TAILLIGHTS
@WITH LIGHTS ON BOTTOM
@WITH LIGHTS ON WHEELS
, NO. 1716 int. i CAUTION: ELECTRIC TOY Not Recommended for children NO. 17169 jearcnies inciuveo) under 8 years of age. As with all BATTERIES REQUIREMENTS:
electric products, precautions 7.2V RECHARGEABLE BATTERY x IPc.circiu=:
should be observed during handling + CHARGER x 1 (hiclided) and use to prevent electric shack. + 5x "AA BATTERIES (Included) 4X WARNING: ENE C-OKING HAZARD~Smal aarts (Reain packaging s It contains Not for Children under 3 years Enertec Enterprises Ltd mportart Infomation.) 7.2V POWER SET POWER SET INCLUDES: 1 x 7.2V RECHARGEABLE BATTERY PACK 1 x CHARGER CAUTION: THIS IS AN ELECTRICAL SYSTEM, READ INSTRUCTIONS CAREFULLY BEFORE USE. ADULT SUPERVISION RECOMMENDED.
* CHARGE THE RECHARGEABLE BATTERY PACK WITH THE CHARGER.
+ APPROX. 4 HOURS CHARGE TIME.
* DO NOT CHARGE FOR MORE THAN THE RECOMMENDED TIME. BATTERY INSTALLATION FOR VEHICLE
+ OPEN THE BATTERY COMPARTMENT ON THE BOTTOM OF THE CHASSIS WITH A SCREWDRIVER.
+ FLAP OPEN AND REMOVE THE BATTERY LID AT THE BOTTOM OF THE VEHICLE.
* CONNECT THE PLUG FROM THE BATTERY PACK TO. THE BATTERY COMPARTMENT AS SHOWN.
* PUT THE BATTERY LID BACK IN PLACE.
* CLOSE AND TIGHTEN THE BATTERY COVER WITH A SCREWDRIVER.
* IMPORTANT!
SWITCH TO "OFF" POSITION AFTER USE TO AVOID DRAINAGE OF BATTERIES. FOR TRANSMITTER UNSCREW AND SLIDE OUT THE BATTERY COVER USING A SCREWDRIVER.
+ INSTALL 5 X "AA" BATTERIES.
+ ENSURE THE POLARITY SIGNS MATCH THOSE ON BATTERY.
* SLIDE THE BATTERY COVER BACK IN PLACE AND PLACE BACK THE SCREW WITH A SCREWDRIVER. SCREW THE ANTENNA IN THE CAVITY OF THE TRANSMITTER, AND ENSURE IT IS FULLY EXTENDED WHEN IN USE. HOW TO OPERATE 1. TURN ON/OFF SWITCH AT BOTTOM OF VEHICLE TO. ON POSITION. NEUTRAL 2. FORWARD, ENGAGE LEFT JOYSTICK TO POSITION 1, NEUTRAL 3. REVERSE. ENGAGE LEFT JOYSTICK TO POSITION 2. 4, STEERING, MOVE RIGHT JOYSTICK IN EITHER DIRECTION TO TURN LEFT OR RIGHT. JOYSTICK AUTOMATICALLY RETURNS TO NEUTRAL WHEN RELEASED. RED CONTROL LED DISPLAY ea TT errs NOTE: TRANSMITTER TURNS ON AUTOMATICALLY AND OFF WHEN NOT IN USE. WHEEL ALIGNMENT IMPORTANT NOTICE:
Th ADJUST THE DIRECTION TRIMMER ON UNDERSIDE OF VEHICLE WITH A SCREWDRIVER IF THE VEHICLE DOES NOT RUN STRAIGHT, TURN TO LEFT OR RIGHT UNTIL YOUR DESIRED ALIGNMENT IS REACHED, Do not mix old and new batteries 2. Do not mix alkaline, standard (Carbon Zinc) or rechargeable
(Nickel-Cadmium) batteries. Batteries should be replaced by adults because of small parts. Batteries are to be inserted with correct polarity, Non-echargeable batteries are not to be charged. Only batteries of the same or equivalent type as recommended are to be used. Expired batteries are to be removed from the toy and disposed of safety. Don't operate your car in dangerous places, CO OPNOARY Don't put your car and transmitter near any source of HEAT. 10. Don't run through water, including pools or puddles. 11. Avoid alll possible collisions. Check the road ahead and watch for obstacles, 12. Avoid your car and transmitter antennas touching each other. 13, Don't operate your car in the vicinity of another radio-controlled car with the same frequency. 14, Don't leave your car and transmitter outside overnight. Night dampness will cause harm. 15, Don't forget fo remove batteries from your car and transmitter if you are not going to operate the car again soon. 16. If malfunction occurs, replace batteries. 17, The supply terminals must not to be short-circuited. 18. Do not try to dismantle the charger and/or battery pack. 19. Do not charge the battery if it is still hot from usage. Wait until it has cooled down. 20. Changes or modifications to any part of the vehicle not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 21. Recharging of battery must be carried out under adult supervision. 22. Rechargeable batteries are to be removed from the toy before being charged. Note: The charging devices or transformers used with the toy are to regulary exomined for demoge to the cord, plug, enclosure ond other ports, and that, in the event of such damage, the toy must not be used with this charging device or transformers until the damaged parts has been repaired. Hereby, Enertec declares that this 17169 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. nce deco anit So oases Oper weak a Peary Reins ace Meng CoLiC ce) ey tts FE: FCC Compliant res Pato ea 3 hat ian sd) ce FCC ID: OGM17169TX-27 eee Sametteensamreat tug FCC ID: OGM17169TX-49 en 0 Foret ecig This equipment has been tested and found to comply with the limits for a 4 5 Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are ~~ Reorient or relocate the receiving antenna. designed to provide reasonable protection against harmful interference in a - Increase the separation between the equipment and residential installation. This equipment generates, uses and can radiate receiver. i 7 as radio frequency energy and, if not installed and used in accordance with the - Connect the equipment into an outlet on a circuit instructions, may cause harmful interference to radio communications. different from that to which the receiver is connected. However, there is no guarantee that interference will not occur in a - Consult the dealer or an experienced radio/TV particular installation. If this equipment does cause harmful interference to technician for help. radio or television reception, which can be determined by turning the Changes or modifications not expressly approved by the equipment off and on, the user is encouraged to try to correct the party responsible for compliance could void the user's interference by one or more of the following measures: authority to operate the equipment.