ap Mme gp uene go for a drive Turn_switch on bottom of vehicle to On" position before playing. 5b. Press on left transmitter control to move vehicle forward or backward. Press on right control to turn right or left. Note: Transmitter turns on and off automatically during operation. Transmitter LED glows to indicate that signal is transmitting. FULL FUNCTION Nee 5c. a If car does not drive straight, move Len) the steering trim (on bottom of vehicle) to adjust the wheel alignment. Note: Be sure to turn vehicle to "Off"
position when not in use. FIG 5b: TRANSMITTER CONTROLS Nene E27 Transmission LED Forward/Reverse Control Bee FIG 5a & 5c: VEHICLE UNDERSIDE Power Switch Steering Trim (5c)
(27MHz Or 49mHz) to vehicle bil frequency: See MHZ stickers located-on;-each component. Ai CT VERY IMPORTANT: ae, ae Match controller frequency _ re 49 L W_|
S222 seneeee aan rem
Be eackeatadeceke eee ae Bee See ZA\ WARNING:
CHOKING HAZARD - Small Parts. Not for children under 3 years. SAFETY AND PLAYING TIPS Vehicles are designed to run only on smooth, clean surfaces. When driving, avoid long pile carpet, pet hair, and dirty surfaces. Never drive your Racer on streets. Do not play outdoors during thunderstorms. Do not drive your Racer in sand or through water or snow. Be careful not to drive out of transmitter frequency range- you may lose control of your vehicle. Wipe clean with a dry towel after play. Do not use chemicals or detergents as they can damage the body. Do not store vehicles or transmitter in direct sunlight. Keep fingers, hair, and loose clothing away from the spinning wheels. Operation of multiple vehicles in close proximity may cause interference or poor performance. High voltage power lines may cause radio interference. If your Racer appears to lose range or power, try recharging Racer or replacing charger batteries ENERTEC 1632/4-49 ron, Ee Tested To Comply
; FE: FCC Compliant with FCC standards FCC ID: OGM-1632-4-27 ee FOCID: OGM-1632-4.49 | FOR HOME OR OFFICE USE USA This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver. i - Connect the equipment into an outlet on a circuit different from that to |
a which the receiver is connected.
== - Consult the dealer or an experienced radio/TV technician for help. MODIFICATIONS NOT AUTHORIZED BY THE MANUFACTURER MAY VOID i USERS AUTHORITY TO OPERATE THIS DEVICE See eee
#20698 ne
i
[zee eee
| | | ff} | jf | | |
P44 eee esse ae oo 8 AUDI M&S 8