JQ01TX INSTRUCTION MANUL OPERATION:
1. Open the battery cover on the side of the JQ01TX. Put 1pc of CR2032 batteries into. Notice the positive side up, and then put the battery cover back on the correct position. Then the transmitter can be used;
2. When turn on, press the "ON" button on the transmitter aimed to the receiver socket. The LED light on the transmitter will be flashed, which means the signal has been sent;
3, When turn off , press the OFF button on the transmitter aimed to the receiver socket. The LED light on the transmitter will be flashed, which means the signal has been sent;
SPECIFICATION:
VoltageDC3V 1* CR 2032 battery Frequency433.92MHZ Batter Life1 Year Caution:
This device complies with Part 15 of the FCC. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.