User Manual Product Name: Tablet Model: MC-100 Manufacture: Estone Group LLC User Manual Page 1 Dimensions Front and Side View Rear View Connector Hardware Specifications Features OS Processor Memory EMMC Wi-Fi Antennas Display Touch Panel Battery Buttons Motion Detection Speakers Microphone USB HDMI Audio DC Jack Micro SD Docking connector Front Camera Rear Camera Description Win 10 Intel Z8350 1.44GHz 2GB DDR3L 32GB Wi-Fi 802.11 b/g/n 2.4G WiFi internal embedded antenna 10in (800*1280) IPS LCD 300 nits LED backlight brightness 10-point Capacitive 4300 mAh/7.4V Power Button/VOLButton G-sensor Stereo, min 1W per channel speaker support. Low noise, suitable for voice capture Micro USB X 1 Micro HDMI X 1 3.5mm Audio Jack X 1 2.5mm DC Jack X 1 Micro SD slot X 1 5 Pin PoGo pin connector X 2 2Mega Pixels 5 Mega Pixels WLAN Provide as far as 300 feet WLAN (100 M) wireless network access range. If you want to use the Tablet of WLAN, you have to connect to wireless access point or "hot spots". NOTICE: The availability of WLAN signal coverage and will depend on the quantity, infrastructure, and other signals penetrate the object and decide. Open the WLAN and connect to a wireless network 1. Press the Home key, click on Setting-> Wireless & networks. 2. Select WLAN check box, to open Wi-Fi. The phone will automatically scan can be used a wireless network. 3. Click on the Wi-Fi settings. Then WLAN network will display a list of WLAN to find the network of the name and security Settings. 4. Touch one of the WLAN network to connection. When you select open network, Tablet will be connected to the network. If selected is WEP, WPA/WPA2 encryption network, it must first corresponding input password, and then the touch connection Connect to other WLAN networks 1. Wireless and network on the screen, touch the WLAN settings. Find WLAN networks will be displayed in the WLAN network list. 2. Touch other WLAN networks can be connected to the network. Regulatory Information FCC Caution. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. .