Quick Start Instructions Blue Pump Technology 123 NOTE: 1. Fully chary by the charging cable (located in the packs pump compartment) into the Micro-USB port on the side of y pack. Charge is indicated by one to four illuminated lighy pack. 2. Add water; pump is self-priming, but may take a few moments to siphon, open purge valve for quicker priming. To add water to reservp, open reservoir, and Ensure reservoir is sealed before fully closing blue latches - do not force them into place. 3. Clip mist hose to the front of the pack. Clip remote to any acc to change the speed of mist as desired. May trim hose to desired length. 4. Fill reservoir with clean water, turn PCS on, and youre ready to mist!
Pack Features Safety Features:
Emergency Whistle
Reve Strips Bite Valve with on/o Lever Z-Straps to Adjust Pack Size
(4) Easy Access Stretch Pockets Adjustable, Sliding Sternum Straps for Ideal Fit
rPurge Valve w/ Mist Nozzle 2L Reservior with Insulated Cover Bounce-Free Wireless Remote Storage Pockets
PCS Pump is NOT waterproof.
Pump lasts up to 1500 usage hours. Pump Warranty: 1 year from purchase date. To Learn More: www..com
Wireless Remote Guide
access. More Less Stop Start Battery Pack Guide NOTE:
charging.
USB Power-bank R Micro USB charge port L Water Usage Per Hour 1 cup = 237ml PUMP SPEED LOW SPEEDS MEDIUM SPEEDS HIGH SPEEDS CUPS PER HOUR 1.5 to 2 cups/hr 2.5 to 5 cups/hr 5 to 6.5 cups/hr
* Water usage increases slightly with 0.20mm nozzle head. PCS MISTING HYDRATION BACKPACK User Manual Congratulations on the purchase of your new ExtremeMist Personal Cooling System (PCS) Backpack. The Ultimate Outdoor 2-n-1 Drinking and Misting Backpack. Use the PCS anywhere, in or out of the pack to greatly extend your summer outdoor activity. This guide contains all the information youll need to Master the Mister!
System Includes A D H K System Includes Areme B. Water eservoir w Hite alve C. PCS Pump wyemote Control D. Y Connector Plug B C E. E F G FNo
G. Purge alve wConnector H. Y C I. Hose Clip Jr K. Hose Clip Tips & Troubleshooting Check all hose connections to make sure they are fully seated. If desired, un-clip hose and aim mist directly at head/neck area for optimal cooling. 2 Nozzles included with kit. Use .015mm nozzle for water conservation on longer outings. Use
.020mm for a more liberal mist spray for shorter outings. Position mist nozzle in front of you. Twist the nozzle fitting so that it is pointing into the breeze, ensuring that the mist will be blown back at you rather than away from you. Adjust the nozzle as the breeze changes direction. Aim nozzle up or down as desired. If hiking on level ground, consider aiming the nozzle at a level position directly in front of you. If hiking uphill, aim the nozzle slightly up; if hiking downhill, aim the nozzle slightly down. Make sure all hoses are fully seated otherwise they may leak. Check all connections when first turned on. If leak persists, trim leaking hose and re-seat. Upon first use, system may take a few moments to prime. To speed up the process, open Purge Valve to allow water to flow freely, close valve to allow water to fill hoses and begin misting. Never pull hoses out of Quick-Disconnect fittings without first depressing the gray or white Quick-Disconnect rings to release hose. If PCS loses its prime (vapor lock) twist open Purge Valve to allow water to flow freely, then close. After ensuring input line is fully seated, and Pump doesnt draw water, remove hose from mist nozzle connector, turn Pump to high and draw (like a straw) on released hose to help prime Pump. Store in dry, convenient location for easy access. Charge PCS battery every 6 months if unused. Drain any remaining water from pump & hoses if storing in freezing conditions. IF MIST NOZZLE CLOGS disconnect nozzle from the fitting, with Nozzle Head facing down on a solid surface, try tapping to clear any mineral crystals from Nozzle Head. If tapping is unsuccessful, unscrew Nozzle Head portion of nozzle (
). Gently probe hole in white ceramic disk from portion of cap with fine needle. Nozzles can clog from minerals in tap water. If you cant clear the nozzle, soak per instruction of CLR or similar product to melt mineral crystals from nozzle. If still not spraying, unscrew Filter Section of nozzle, blow through the unscrewed bottom portion to clear Micro Filter. Filter may be removed for thorough cleaning. NOTE:
WARNING:
care not to deplete drinking water. Store and use above freezing temperatures. I L J M LH FCC ID: 2ATNCEXTREMEMISTPCS M. Straight ladder Connector PERSONAL MISTING SYSTEM Scan for Scan for Scan for
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
equipment.