FCC ID: IDH-ZION01 Wireless Charging Pod

CUSTOMER SERVICE & SUPPORT www.fellowes.com U.S.: 1-800-955-0959 Canada: 1-800-665-4339 Mexico: 001-800-514-9057 Declaration of Conformity Fellowes, Inc. Unit 2 Ontario Drive, New Rossington, Doncaster, DN11 0BF, England declares that the product model Rapido Wireless Charging Pod conforms with the requirements of the Restriction of Hazardous Substances Directive (2011/65/EU & 2015/863/EU), the Radio Equipment Directive (2014/53/EU), the WEEE directive (2012/19/EU), and below harmonized European EN Standards. Rapido Wireless Charging Pod EN 62368-1:2014+A11:2017 EN 55032:2015 EN 55035:2017 EN 61000-3-2:2014 EN 61000-3-3:2013 Draft ETSI EN 301 489-1 V2.2.1 (2019-03) ETSI EN 301 489-3 V2.1.1 (2019-03) ETSI EN 303 417 V1.1.1 (2017-09) EN 62311:2008 Safety:

EMC:

RF:

Year Affixed: 19 Itasca, Illinois, USA January 1, 2019 John Fellowes W.E.E.E. This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic Equipment (WEEE) Directive and in compliance with local laws relating to this directive. For more information on the WEEE Directive please visit www.fellowes.com/WEEE 1789 Norwood Avenue, Itasca, Illinois 60143 1-800-955-0959 www.fellowes.com 2019 Fellowes, Inc. | Part # 411662 Rev C PLEASE READ THESE INSTRUCTIONS BEFORE USE. DO NOT DISCARD: KEEP FOR FUTURE REFERENCE. ENGLISH PARTS PROVIDED A Stand B Charging Pod C Power Supply SAFETY INSTRUCTIONS/WARNING Read and follow all instructions and warnings before use. Rapido Wireless Charging Pod is for charging Qi compatible smartphone only. Only use the power supply that was supplied with this product. It is normal for the wireless charging surface to get warm during charging. If there is an issue while charging, the indicator lights will flash. Keep flammable materials away from charging surface. Only use the wireless charger for its intended purpose. Improper use, or use of incompatible devices may result in a risk of fire, explosion, or other hazard. DO NOT attempt to charge a device that is damaged or an open battery case or a device that is not Qi compatible. DO NOT attempt to disassemble or repair the wireless charger. DO NOT use if power cord or transformer is damaged. Keep the wireless charging surface clean and dry. Use a soft, clean, dry cloth to clean the surface of the wireless charger. For indoor use only. INSTALLATION STEP 1 Plug in power supply to charging pod. STEP 2 Plug power cable into the nearest outlet. STEP 3 (OPTIONAL) Place charging pod onto provided stand. STEP 4 Place charging pod with or without stand onto table or sit-stand workstation. CAPABILITIES Port 1 2 3 4 Description Barrel Connector USB Port (Type A) Fast Charging USB Port (Type C) Fast Charging Wireless Charging Pad Specifications Power (12V, 3A) 5V,9V,12V, Max 2.4A 5V,9V,12V, Max 2.4A 5V~9V, Max 10W The frequency range is 110KHZ ~ 205KHZ. The Maximum H-Field is 42dBuA/m 2 3 4 1 STEP 5 Place your Qi-enabled device onto the charging pad or use the USB ports to charge your device. Review your devices manual to see if its Qi-enabled. Standby Charging Foreign Object Detected White LED OFF On Flash 2 3 FELLOWES LIMITED WARRANTY Fellowes, Inc. (the Company) warrants this product to be free from defects in material and workmanship appearing within one (1) year from the date of the original purchase of the product. If such a defect appears during the warranty period, the Company will (at its sole option) either repair or replace the defective product with no charge for service or parts or refund the purchase price. The Company may require that the product be returned at the customers expense to a location designated by Customer Service. This warranty applies only to the initial retail purchaser and does not cover claims resulting from misuse, failure to follow instructions on installation and use, neglect, use of unauthorized attachments, commercial use, use on a current or voltage other than specified on the product, or unauthorized service during the warranty period on conditions otherwise covered by warranty. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS EXPRESSLY LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. UNLESS REQUIRED BY APPLICABLE LAW, THE CUSTOMERS EXCLUSIVE REMEDY FOR BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY OR OF ANY OTHER OBLIGATION ARISING BY OPERATION OF LAW OR OTHERWISE SHALL BE LIMITED AS SPECIFIED HEREIN TO REPAIR, REPLACEMENT OR A REFUND OF THE PURCHASE PRICE, AT THE COMPANYS SOLE OPTION. UNDER NO CIRCUMSTANCE WILL THE COMPANY, ITS AFFILIATES, SUBSIDIARIES, RELATED ENTITIES, RESELLERS OR THEIR RESPECTIVE OFFICERS, DIRECTORS OR EMPLOYEES OR THOSE PERSONS FOR WHOM THEY ARE BY LAW RESPONSIBLE, BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SUSTAINED IN CONNECTION WITH THE PRODUCT. THE COMPANY AND THESE OTHER PARTIES DO NOT ASSUME OR AUTHORIZE ANY REPRESENTATIVE OR OTHER PERSON TO ASSUME FOR ANY OF THEM ANY OBLIGATION OR LIABILITY OTHER THAN AS IS EXPRESSLY SET FORTH HEREIN. The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions or conditions may be required by local law. FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 & 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 15 cm from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. 4 5

Fellowes Inc 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA Confidentiality Request Letter Federal Communications Commission Authorization and Evaluation Division FCC ID: IDH-ZION01 Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

1. Block Diagram 2. Schematics 3. Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Rule 0.457, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, _________________ Name: Michael Kelley Position: Compliance Manager Date: 2019-11-21

Fellowes Inc 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA Declaration of Authorization We Name: Fellowes Inc Address: 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA Declare that:

Name Representative of agent: Marlin Chen Agent Company name:

Address:

City:

Country:

is authorized to apply for Certification of the following product(s):

Product:

FCC ID:

Model:

Sincerely, _________________ Wireless Charging Pod IDH-ZION01 Fellowes Rapido Wireless Charging Pod MRT Technology (Suzhou) Co., Ltd D8 Building, Youxin Industrial Park, No.2 Tian'edang Rd., Wuzhong Economic Development Zone Suzhou China Name: Michael Kelley Position: Compliance Manager Date: 2019-11-21

Fellowes Inc 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA Wireless Charger Approval Cover letter We Name: Fellowes Inc Address: 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA Declare that the product as bellow meet the special requirements of KDB680106 D01 v03 section 5(b). Product:

FCC ID:

Model:

Wireless Charging Pod IDH-ZION01 Fellowes Rapido Wireless Charging Pod COMPLY Yes. Wireless operating frequency range: 110kHz ~

205kHz Yes. Wireless maximum transmitted power: 10W Max. Yes. The transfer system includes 3 coils, But in practice, only one coil that is closest to the client device will be working. Yes. Placed directly. Yes. Mobile exposure conditions only. Yes. EQUIPMENT APPROVAL CONSIDERATIONS 1) Power transfer frequency is less than 1 MHz 2) Output power from each primary coil is less than or equal to 15 watts. 3) The transfer system includes only single primary and secondary coils. This includes charging systems that may have multiple primary coils and clients that are able to detect and allow coupling only between individual pairs of coils. 4) Client device is placed directly in contact with the transmitter. 5) Mobile exposure conditions only (portable exposure conditions are not covered by this exclusion). 6) The aggregate H-field strengths at 15 cm surrounding the device and 20 cm above the top surface from all simultaneous transmitting coils are demonstrated to be less than 50% of the MPE limit. Sincerely, _________________ Name: Michael Kelley Position: Compliance Manager Date: 2019-12-22 Fellowes Inc 1789 Norwood Avenue Itasca, Illinois 60143-1095, USA