1 x Wireless Charging Dual LED Activating Mouthpiece 1 x Wireless Charging Dock 1 x Desensitizing Wand 3 x Whitening Wands 1 x Maximum Strength Whitening Wand P O W E R I N G T H E C R A D L E Plug the micro USB cable into the Cradle in location shown Plug the open end of the cable into a standard 5V @ 1A USB charging brick (not included) C H A R G I N G T H E M O U T H P I E C E Open the lid of the charging Cradle and place the mouth piece into the Cradle. Ensure the mouth piece is properly seated and level. Close lid to begin charging the mouth piece T R O U B L E S H O O T C H A R G I N G If the mouth piece is not properly seated when the lid is closed, the Snow Flake will flash for 30 seconds and turn red. If this happens, open the lid and reposition the mouth to ensure its fully seated and level. Once the charging cycle begins, the Snow Flake will turn blue and begin a breathing animation. The charge time is approximately 3 hours depending on usage. Once the mouth piece is fully charged the breathing animation will stop and the Snow Flake will glow a steady blue. FCC Statement 1. This device complies with Part 18 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. Note: The grantee is not responsible for any changes or modications not expressly approved by the party responsible for compliance. Such modications could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a FCC Part 18, pursuant to part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.