User Guide Insert the receiver into USB jack of the host computer. 1. 2. Open the cover for battery cell on the mouse, and install two charged batteries into the cell, then close the cover of battery cell. 3. Turn the mouse down side up, and switch the button for power to ON. 4. Start operating mouse (The operating method is the same as normal 3D optical mouse). 5. unable to operate mouse, please follow below steps.
(1).Operate above 1 to 4 steps again.
(2).Press the ID button on the receiver for 1 or 2 seconds. At this moment, the LED on the receiver will flash slowly for one minute.
(3).Please immediately press the linking button (during 1 minute) on the bottom of mouse for 1 or 2 seconds. If the LED on receiver side flashes quickly for 2 seconds, it shows that the link is successful. If the LED on receiver side doesnt flash for 2 seconds, please repeat step (2) and (3). 6. Trobleshooting
(1). After mouse is installed, wireless mouse cannot operate normally or is without signals. a. Make sure you have connected the receiver into the computers USB port b. Make sure you have installed the batteries correctly, and power has been switched on. c. Establish link between the receiver and the RF function mouse. Press the connect ID button on the receiver first, then press the connect ID button on the RF function mouse. FCC Requirements Radio & Television interference WARNINGThis equipment has been tested and found to comply with the Limits for a Class B digital devicepersuant to Part 15 of FCC RulesThese limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generatesuses and can radiate radio drequency energyand if not installed and used in accordance with the instructionsmay cause harmful interference to radio communicationsHoweverthere is no equipment does cause harmful Interference to radio or television receptonwhich can be determined by turning the equipment off and onthe user is encouraged to try to correct The interference by one or more of the following measures 1Reorient or relocate the receiving antenna 2Increase the distance between the equipment and receiver 3Connect the equipment into a separate power outlet from which the receiver is connected 4Consult the dealer or an experienced radioTV technician for soulution Note 115.21 Change or modifications are not experessly approved by the manufacturer could void the users authority to operate the equipment 215.19 This device complies with part 15 of the FCC RulesOperation is subject to the following two conditions 1This device may not cause harmful interferenceand 2this device must accept any interference receivedincluding interference that may cause undesired operation