Sma artfan nlightc contro llerspe ecificat tion
Product tIntrodu uction
This
produ uct use es 2.4G G wirel less dig gital re emote
contro l
technol ogy, re emote
control l one-t to-one
contro l, simp d
ple and conveni ientope eration,
stronga anti-inte erferenc ceability y.
Technic calParam
meters Wall sw witch se egment
sequen ceAll
bright
light
/ white e light /
w
/ yellow Inputvo Powerf Output
oltage factor voltage 200V-2 0.9
e90-20 00VDC 240VAC 50Hz
LEDOu tputPow wer25 5-60W
Motorr ratedpo ower<
25W
Control lereffic iency
>84%
Windve elocity 1-6gea ars
Timing 1hour r/2hou urs
Receivin ngmeth hodRF F2.4G
Remote e contr rol dis stance 0
8-20 meters
Remote e contro ol batte eryNu 7
mber 7
1.5VX2 Remote e contr ol mat tching
code Turn on n the p power a and pre d
ess and holdthe elights switchb buttonfo oralong gtimew within5
second e
dsofthe lighton n,Wheny youhea arabee porali ightflas shes,the ecodem s
matchis success ful.Ifyo ouneed
tomatc chthec codeas second
time,yo d
ouneed to wait
30 sec conds b efore tu urning o on the
power
and rep e
peat the aboveo operatio on.
CAUTION:
The electronic switch is not an isolated product and needs to be
operatedbyprofessionalpersonnelduringinstallation.
The electronic switch is triggered by the remote control, and the
wirelessfrequencyoftheremotecontroltransmitteris2.4GHz.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.