FCC ID: 2AQUQGB17274 Outdoor Fixed Security Light with Wifi module

Outdoor Fixed Security Light with Wifi module MODEL:17000274 INTRODUCTION The Light incorporates a PIR (Passive Infra Red) sensing device which continuously scans a preset operating zone and immediately switches the light on when it detects movement in that area. This means that whenever movement is detected within the range of the sensor the light will switch on automatically to illuminate pathways, steps, patios, porches, or whatever area you have selected to light for reasons of safety, convenience or security. While there is movement within range of the unit the light will remain on. WHILE TO FIT YOUR LIGHT To achieve best results, we suggest you account points:

Ideally the Light should be mounted 1.8 to 2.5 meters (6 to 8ft) the following above the area to be scanned To avoid damage to unit-do not aim the sensor towards the sun. To avoid nuisance triggering, the sensor should be directed away from heat sources such as barbecues, Air-conditioners, other outside lighting, moving cars and flue vents. To avoid nuisance triggering, keeping away from the area of strong electromagnetic disturbance. Do not aim towards reflective surfaces such as smooth white walls, swimming pools, etc. The Security light scanning specifications (Max. 15 meters at 240) may vary slightly depending on the mounting height and location. The detection range of the unit may also alter with temperature change. Before selecting a place to install your light you should note that movement across the scan area is more effective than movement directly toward or away from the sensor. (refer Figure). If movement is made walking directly towards or away from the sensor and not across, the apparent detection range will be substantially reduced. fuse. 1. Mounting the mounting support onto the Junction box 2. Connect the main cable to the terminal 3. Mounting the mounting panel onto the mounting support 4. Mounting the main light onto the mounting panel. 5. Switch the main power on. FITTING THE UNIT Installation by a licensed electrician and according to IEC wiring Regulation. Before commencing any electrical work, ensure mains supply cables are isolated by switching off and removing the relevant IMPORTANT:

1. Never attempt to remove the lens cover as this will damage the sensor and render all guarantees invalid. 2. Before touching the light, please switch off first and then let it cool after activation UNDERSTANDING THE CONTROLS (referring to the Figure) ADJUSTING THE ON TIME: The length of switched on TEST,1min,5min,20min . Note:

1. Once the light has been triggered by the PIR sensor any subsequent detection will start the timed period again from the beginning. TEST, the light will turn on about 5s whether day or night 1min,5min,20min:The light only turn on at night. time that remains between adjusted 2. 3. can be ADJUSTING THE DURATION SENS: The sensitivity means the Maximum distance which PIR Sensor can be triggered by movement body. This device complies with Part 15 of the FCC Rules. Operation is Address: 150 Av. Oneida, Pointe-Claire, QC H9R 1A8 Canada subject to the following two conditions: (1) this device may not cause Telephone Number: (514) 694-0444 harmful interference, and (2) this device must accept any CAN ICES-005 (B)/NMB-005 (B) ADJUSTING THE Brightness LEVEL: The brightness of the light can be adjusted between high and low interference received, including interference that may cause ADJUSTING THE Dual Brite: The Dual brightness of the light can be adjusted between OFF ,6h ,Dusk to Dawn. OFF: No dual brightness 6h: The light will turn on at low brightness at night, then off after 6 hours or going to day, in this time, When the signal is sensed, the lights will turn on high brightness. Dusk to Dawn: The light will turn on at low brightness all the night,, in this time, When the signal is sensed, the lights will turn on high brightness. RESET: Press the reset button more than 5s, the wifi will Restore to factory settings TECHNICAL DETAILS :

Voltage:108-132 VAC ~ 60Hz Wattage: 22W LED Lumen: 2200LM Color temperature:4000K Detection range: 240 and Max. 15 meters Duration time: TEST,1min,5min,20min Weatherproof: IP44 ProtectionClass Suitable for indoor and outdoor use Company GUANGDONG LTD AUROLITE AUTOTECH Address No. 1 Jinsheng 1 Road, Hualong Town, Panyu District, Guangzhou, China undesired operation. RF warning for Mobile device:

Warning: Changes or modtifications to this unit not expressly This equipment complies with FCC radiation exposure limits set approved by the party responsible for compliance could void the forth for anuncontrolled environment. This equipment should be inst users authority to operate the equipment. alled and operated with minimum distance 20cm between the Note: This equipment has been tested and found to comply with the radiator & your body. limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection This device contains licence-exempt transmitter(s)/receiver(s) that against harmful interference in a residential installation. This comply with Innovation, Science and Economic Development equipment generates, uses and can radiate radio frequency energy Canadas licence-exempt RSS(s). Operation is subject to the and, if not installed and used in accordance with the instructions, following two conditions:

may cause harmful interference to radio communications. However,

(1) This device may not cause interference. there is no guarantee that interference will not occur in a particular

(2) This device must accept any interference, including interference installation. If this equipment does cause harmful interference to that may cause undesired operation of the device. radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the Cet appareil contient des metteurs / rcepteurs exempts de interference by one or more of the following measures:

licence conformes aux RSS (RSS)d'Innovation, Sciences et

- Reorient or relocate the receiving antenna. Dveloppement conomique Canada. Le fonctionnement est

- Increase the separation between the equipment and receiver. soumis aux deux conditions suivantes :

- Connect the equipment into an outlet on a circuit different from that

(1) Cet appareil ne doit pas causer d'interfrences. to which the receiver is connected.

(2) Cet appareil doit accepter toutes les interfrences, y compris

- Consult the dealer or an experienced radio/TV technician for help. celles susceptibles de provoquer un fonctionnement indsirable de This device contains licence-exempt transmitter(s)/receiver(s) that l'appareil. comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). avertissements radio pour les appareils portables :

Operation is subject to the following two conditions:

L' quipement a t valu et satisfait aux exigences gnrales 1. This device may not cause interference. d'exposition par radiofrquence. L'appareil peut tre utilis sans 2. This device must accept any interference, including interference restriction dans des conditions d'exposition portables. that may cause undesired operation of the device. FCC Responsible Party Name:Globe Electric Company Inc.

17000274 Outdoor Fixed Security Light with Wifi module 120V 60Hz, sowMlax, Non-replaceable LED Ma 60Hz , DEL non remplacable d'un 4}

AXIMUM ce 22, As 420V60H2, DEL de aw Iaximo no reemplazable Intertek FCCID: 2AQUOGB17274 5020668 IC: 8290A-GB17274 Made in Vietnam / Fabriqu en Vietnam / Hecho en Vietnam AWL1056A-I-W_17000274

Globe Electric Company Inc.

(Date):2023.8.18 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Celine.zhu to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Sincerely,

<Signature>

Name Celine.zhu Title Senior project manager Company Globe Electric Company Inc.

Globe Electric Company Inc.

(date)2023.8.18 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for (2AQUQGB17274)

[Globe Electric Company Inc.] (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely,

<Signature>

Name Celine.zhu Title Senior project manager Company Globe Electric Company Inc. Globe Electric Company Inc.

(date)2023.8.18 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for (2AQUQGB17274)

[Globe Electric Company Inc.] (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely,

<Signature>

Name Celine.zhu Title Senior project manager Company Globe Electric Company Inc.

Globe Electric Company Inc.

(date)2023.8.18 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (Outdoor Fixed Security Light with Wifi module/17000274/AND FCC ID:2AQUQGB17274) To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the Schematics Block diagram Operation description required to be submitted with this application be permanently withheld from public review. These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our Please contact me if there is any information you may need. Sincerely,

<Signature>

Name Celine.zhu Title Senior project manager Company Globe Electric Company Inc.

C5266091_X23_Ed.1 US AGENT LETTER OF ATTESTATION US Agent:

Company Name: Globe Electric Contact Name: Celine Zhu Address:2264 East 6th Street San Bernardino, CA 92410 United States Telephone No: (514)694-0444 Email:Email:celinez@globe-electric.com FRN: 0033436957 TO:

Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 This letter is to confirm that we have accepted the responsibility to act as US agent representative on behalf of the (Globe Electric Company Inc. noted below for all future FCC certification/registrations obtained during the period of this agreement, which ends at the specified date below. As per US agent, we are aware of the requirements involved as outlined in FCC Equipment Authorization Program in their Report and Order FCC 22-84 and the clause 2.911 Application requirements. Applicant Company name: Globe Electric Company Inc. Grantee code:

2AQUQ 2AQUQGB17274 150 Oneida, Montreal, Quebec, Canada, H9R 1A8 u FCC ID:

Address:

Name: Celine Zh Phone: +86-755-25192522 Email: celinez@globe-electric.com TheApplicantacknowledgetheacceptanceofitsobligationtomaintainanagentfor service of process in the United States for no less than one year after either the granteehaspermanentlyterminatedallmarketingandimportationoftheapplicable equipment within the U.S., or the conclusion of any Commission-related administrativeorjudicialproceedinginvolvingtheequipment,whicheverislater. Date: 2023.8.18 Applicants Name: Celine Zhu u US Agents Name:Celine Zh Signature Signature 1/1