2 PACK DRONES & FLAG DRONE RACER SET 12+
Getting to Know Your Drone PLEASE READ ALL WARNINGS AND INSTRUCTIONS PRIOR TO USE. KEEP THIS DOCUMENT AS IT CONTAINS IMPORTANT INFORMATION ABOUT YOUR DRONE. 1. PREPARE FOR FLIGHT Drone must be charged before each use
(Cable included) Indicator light will turn off once fully charged Install batteries in remote 2. PAIR YOUR DRONE Before each flight pair the remote with the drone:
1. Turn your drone on and place on a flat, level surface 2. Turn on the remote on and move the left joystick up, then down 3. The beep will indicate successful pairing 4. Repeat steps 1 and 2 if necessary 3. DIRECTIONAL LIGHTS White lights indicate the front of the drone Red lights indicate the back of the drone Not applicable in auto-orientation mode QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WERE HERE TO HELP CUSTOMER SERVICE
(800) 374-2744 Before calling please locate the 10-digit code printed on the back of your remote 4. REMOTE CONTROL OVERVIEW Practice flying your drone below 10 feet and at low speeds until comfortable with all controls to avoid unnecessary damage or injury Left joystick: left/right controls spin and Up/Down controls elevation Right joystick: controls flight direction Direction Trim: use to eliminate drift To cut power to drone, move left joystick to down position ADULT ASSEMBLY, CHARGING, AND BATTERY INSTALLATION IS REQUIRED. ADULT SUPERVISION IS REQUIRED. WARNING:
CHOKING HAZARD - Small Parts. Not for Children under 3 years. 2017 MerchSource, LLC. All rights reserved. Distributed by MerchSource, LLC, Irvine, CA 92618. For technical support, please visit www.merchsource.com or call 1-800-374-2744. The artwork and design of this manual are protected by US copyright law and may not be reproduced, distributed, displayed, published or used for any purpose without prior written permission. It is not permitted to alter, remove or reproduce any trademarks or copyright notice from this manual. KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE. Due to continuous product improvements, the picture on the manual may differ slightly from the actual product. PATENT PENDING Printed in China. 2 PACK DRONES & FLAG DRONE RACER SET INTRODUCTION Congratulations on your purchase of the Rechargeable 2.4 GHz 2 Pack Drones &
Flag Drone Racer Set. Get ready to soar to new heights. Master the art of drone flying with remote control maneuverability. These lightweight drones will provide hours of fun. SPECIFICATIONS Drone Battery: 350 mAh Li-po Remote Controller Battery: 6 x 1.5V AA Charging Time: 100 minutes Maximum Recommended Altitude: 150 ft. TABLE OF CONTENTS General Warnings Contents, Remote Battery Installation, Battery Warnings Charging LiPo Battery and Replacing Propellers Remote Overview Operating Drone Auto Orientation and Tips Obstacle Course Setup Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Printed in China. i observed during handling and use to reduce the risk of electrical shock. 2 PACK DRONES & FLAG DRONE RACER SET READ ALL WARNINGS AND PRECAUTIONS BEFORE USE SAFETY WARNINGS Not recommended for children under 12 years of age. As with all electrical products, precautions should be Adult supervision is required at all times Drive drone only on smooth flat surfaces Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of The drone shall never be modified or used for anything except its intended purpose. Before each use, an adult should review the product and battery to determine that no damage or hazards exist DO NOT TOUCH SPINNING PROPELLERS Do not allow anything to intentionally make contact in any way with spinning propellers Use caution and pay attention to your surroundings while operating drone Do not fly drone into animals, people, or inanimate objects Keep drone away from power lines, buildings, trees, public areas, and any other potentially hazardous areas. Do not operate in rain, heavy wind, and or any type of severe weather Do not land drone on wet surfaces Never touch or allow others to touch drone while it is flying Always turn drone off when it is not in use Always fly drone in large open areas The drone will lose controlling capabilities if fly distance is more than maximum recommended altitude of 100 ft. o Prevent contact with spinning blades by turning off remote prior to handling drone crashes. others. Keep below 100 ft. to avoid potential crashing risk. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Fly-aways are the responsibility of the individual pilot and will not be replaced by the manufacturer. Drone is powered by a rechargeable 3.7V 350mAh Li-Po battery (included). Transmitter requires 6 AA batteries (not included). Colors and styles may vary. *This drone weighs 0.192 lbs (87g). As of December 21, 2015, the Federal Aviation Administration (FAA) only requires registration on unmanned aircrafts weighing more than 0.55 lbs. Visit www.faa.gov/uas/registration/ for more information. Although the FAA does not require this drone to be registered, ongoing compliance with federal, state, and local laws is an owners sole responsibility. Always fly safely and respect the privacy of others. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Printed in China. TROUBLESHOOTING:
When remote switch is turned on, the remote light does not illuminate:
1) Check that batteries in the remote are installed correctly OR 2) Replace with new batteries When the remote is switched on, the remote LED is flashing and remote is beeping:
1) Remote batteries are low; replace them with new batteries Drone and remote properly pair, but the drone will not lift-off:
1) Drone Li-Po needs charging. Use charging cable to connect the drone to power source. After trimming the drone, the drone flight is very unstable and cannot fly properly:
1) One or more blades are most likely damaged;
2) Turn off the drone and remote. 3) Replace with the proper number replacement blade and try flying again. After impact, the drone is unstable:
1) Put the left remote control lever to the left bottom and put the right remote control lever to the right bottom at the same time which connected to the drone (diagram to right). 2) If the above does not resolve the issue, reboot the drone and controller and pair again. Remote Controller and Drone can not be paired:
1) Check Point: Remote Controller must be closed to Drone, not exceed 4 meters. Note: If there are 2 sets of Drones within 4 meters for Pairing, you must pair one successfully before pairing the second set. 1 2 PACK DRONES & FLAG DRONE RACER SET CONTENTS Mach Drone x2 AUTO ORIENTATION LAND SPRINT TRIM 60 100 ON OFF DIRECTION TRIM Drone Controller x2 Racing Flag Start/
Finish Line Charge Cable x2 Replacement Propellors REMOTE BATTERY INFORMATION 1. Slide open the remotes battery compartment. 2. Install 6 AA batteries as shown in the diagram above. 3. Replace and close battery compartment. LITHIUM-POLYMER BATTERY WARNING There is a risk of fire and personal injury if Li-Po battery is punctured, damaged or misused. Never expose battery to extreme temperatures or moisture. Do not subject battery to strong impacts Always keep battery away from flammable materials. Only use manufacturer specified batter(ies), charger(s), and/or adapters, if applicable. Battery is not serviceable. Let battery cool to room temperature before charging. While charging, never leave battery unattended. Recycle or dispose of battery according to federal, state and local laws. KEEP THIS INSTRUCTION MANUAL FOR REFERENCE BATTERY WARNING - ALKALINE (AA) Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries. Insert batteries using the correct polarity. Do not short-circuit the supply terminal. Only use manufacturer specied batter(ies), charger(s), and/or adapters, if applicable, specied by the manufacturer. Always use, replace, and recharge (if applicable) batteries under adult supervision. Printed in China. 2 2 PACK DRONES & FLAG DRONE RACER SET Insert the Charge Cable into a power source CHARGING BATTERY Note: The Battery Charger will light up when it is charging the battery and turn off when the battery is fully charged. Charge time is approximately 100 minutes. 1. Turn off the drone before charging. 2. Connect the Battery Charger Cable to the port found on the rear of the drone 3. Connect USB connector to the power source. Connect the Charge Cable to the Drone Replacing Propellers 1. Follow diagram. 2. Remove screw from top of Propeller. 3. Remove broken Propeller and replace with new Propeller. 4. Make sure you installed the correct blade. Each blade has a number written on it. Match the blades with the corresponding number on the drone 5. Insert screw into top of Propeller NOTE: Blade 1 turns counter clockwise and Blade 2 turns clockwise Printed in China. 3 2 PACK DRONES & FLAG DRONE RACER SET REMOTE OVERVIEW Power indicator light Auto orientation Throttle Joystick:
Increases or decreases drone elevation left/right controls spin Auto takeoff Auto land AUTO ORIENTATION AUTO TAKEOFF AUTO LAND 60 100 ON OFF DIRECTION TRIM Forward/ Backwards Adjustment: Slide up to adjust forward and slide down to adjust backwards Multi Directional Joystick Side to Side Adjustment:
Slide left to adjust to the left and slide right to adjust to the right Speed control ON/OFF Remote switch Printed in China. 4 2 PACK DRONES & FLAG DRONE RACER SET OPERATING DRONE Step 1 Pre-Flight Checklist Read all warnings and instructions Install remote batteries, page 2 . Charge batteries, page 3. Make sure that drone and remote are powered off. Step 4 Lift Off 1. Slowly and carefully bring the throttle up. Propellers will begin to spin and drone will begin to elevate. You can compensate for some of the drones drifting by using the Multi Directional Button or by following step 5. You may need to practice this step several times before successfully getting drone into the air. Step 2 Choosing a location Drone is designed to be flown/driven indoors Always make sure you have enough space to and outdoors fly drone Always follow warnings, page 1. Step 3 Starting Drone 1. Making sure your remote is off, slide drone switch to ON. Drone lights will begin to flicker 2. Choose a flat even surface and follow the diagram 3. Turn remote on. Bring the Throttle all the way up then bring it all the way down. Remote will beep and drone lights will flicker rapidly then turn on permanently once paired. 4. Drone is ready for flight. 10 FEET 10 FEET 5 FEET 10 FEET 10 FEET Fig. 1 Step 5 Drone Begins to Drift Follow this step if your drone begins to drift while take off or during flight Drone drifts backwards: Slide the Forward/Backwards Adjustment up Drone drifts forwards: Slide th Forward/Backwards Adjustment down Drone drifts left: Slide the Side to Side Adjustment to the right. Drone drifts right: Slide the Side to Side Adjustment to the left. Drone spins clockwise (viewing drone from top): Slide the Spin Adjustment to the left Drone spins counter-clockwise (viewing drone from top): Slide the Spin Adjustment to the right. Always turn off remote prior to retrieving or picking up drone. This will help you avoid accidently activating propellers. Step 6 Operating Drone in Flight The drones range is approximately 150 feet Read and be aware of all warnings found on Maintain your desired elevation by using the page 1. Throttle Use the Throttle joystick in a circle motion to spin the drone Use the Multi Directional Joystick to move forwards, backwards, and side to side Review step 5 if your drone begins to drift Printed in China. 5 2 PACK DRONES & FLAG DRONE RACER SET OPERATING DRONE (Cont.) Step 7 Landing Drone Make sure you have achieved level, balanced flight, where the drone is neither climbing nor descending. This mode allows you to safely and slowly land your drone without having to control the speed. The ideal auto landing height is 25-30ft. Press the land button to trigger auto land. Remote will beep continuously until you exit the auto land mode. To steer the drone during landing, use the right control until drone has reached the ground. Press the land button again to exit auto landing mode. NOTE: Please make sure the throttle joystick is on down position before exit auto landing mode. the propellers on. Step 8 Retrieving Drone 1. Turn off your remote by pressing the Power Button. This will stop you from accidentally turning 2. Make sure the propellers have stopped spinning then pick up your drone. Note: You will need to pair your drone again before your next flight. Auto Orientation Button Auto Orientation default setting is off. To enter this mode press Auto Orientation button. Remote After drone success paired, the 2 white LED lights toward orientation will be the original forward orientation, when drone is in auto orientation mode, whatever the drone spin, the forwar dorientation will be previous original forward orientation. Remote will beep every 6s to indicate the drone is in Auto Orientation mode. To exit mode, press the button. Remote will sound 1 long beep indicating that it has exited Auto will beep twice. Orientation mode. Tips Do not crash drone into sand or dirt. Drone gears may become clogged When first learning to fly, practice lifting off and hovering Stay several feet from walls and buildings. Printed in China. 6 2 PACK DRONES & FLAG DRONE RACER SET OBSTACLE COURSE SETUP Printed in China. 7