This device complies with part 15 of the FCC rules. Operation is subject to the following two is connected. conditions:
Consult the dealer or an experienced radio/TV technician for help. 1. This device may not cause harmful interference Important: Changes or modications to this product not authorized by Gradus Group 2. This device must accept any interference received, including interference that may your authority to operate the product. This product has demonstrated EMC compliance could void the electromagnetic compatibility (EMC) and wireless compliance and negate cause undesired operation. under conditions that included the use of compliant peripheral devices and shielded cables between system components. It is important that you use compliant peripheral Note: This equipment has been tested and found to comply with the limits for a Class B devices and shielded cables between system components to reduce the possibility of digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide causing interference to radios, televisions, and other electronic devices. reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed Radio Frequency Radiation Exposure and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a This device is a mobile transmitter and receiver that uses an internal antenna to send and particular installation. If this equipment does cause harmful interference to radio or receive low levels of radio frequency (RF) energy for data communications. The device television reception, which can be determined by turning the equipment off and on, the emits RF energy below the published limits when operating in its maximum output power user is encouraged to try to correct the interference by one or more of the following mode. To comply with RF exposure compliance requirements, the device should be measures:
Reorient or relocate the receiving antenna. installed and operated with a minimum of 1 mm (0.04 in.) between the device and your body. The device should not be used in other congurations. This device must not be Increase the separation between the equipment and receiver. co-located or operated in conjunction with any other transmitter or antenna. Connect the equipment to an outlet on a circuit different from that to which the receiver