POCKET DRONE NEVER LEAVE IT UNATTENDED WHILE CHARGING THIS CAN BE A FIRE HAZARD. WE ARE NOT RESPONSIBLE FOR MISUSE. Batteries:
*Use "AAA" non-rechargeable battery or "AAA" rechargeable battery.
*Only use batteries of the same or equivalent type as recommended
*Batteries are to be inserted with correct polarity.
*Do not short cut the supply terminals.
*Lithium-ion battery could be flammable if misused.
*Do not mix old and new batteries.
*Do not mix alkaline batteries, standard (carbon-zinc), or rechargeable (Nickel-Cadmium) batteries.
*Ramove ayhariicted hatteriac BATTERY INSTALL/RAM CARD INSTALL oS f Cu) Step1 | Dich the ewitch according tn the arrowe'c Battery Cover Step2| Inctall hattary than cover the hatteary cover Inetal!
CONNECT THE QUADCOPTER & START TO FLY Step1 Turn on the switch of the quadcopter, the LED lights start to blink. Step2 Turn on the remote transmitter, the power light is on. _ mc _|
ON - . _ . EE EE EE EE nnn en Nh Ep | a |
*Take out the batteries when not in use. |
direction, take out the battery cover. the SD Card according to the arrows's direction.
*Rechargeable batteries are to be removed from the toy before being charged.
*If you do not fly the Quadcopter for a long time, take out the batteries inside the controller to avoid battery OPERATE THE POCKET DRONE leakage which would damage the product.
*Photos are for reference only; the appearance of the actual product is based on what it is.
*When the controller/helicopter is underpowered, the control distance will be shortened. This will also result in difficulty of taking off and low flight altitude.
*Do not crash or allow helicopter to fall from high altitude. Helicopter will break and service life may be reduced Please retain this information for future reference Step3| Pull the throttle stick (left stick) up to the top then pull it down to the bottom , the remote transmitter begins to search and connect f l with the quadcopter, the power light on transmitter blinks fast. Connection is completed once the power light and the LEDs on the quadcopter stop blinking. Ite ready to fiv 0 ae ~ Step1 | Take out the propellers from four sides Step2 | Pull the motor part then turn it up as picture. i Ww as picture. THROTTLE STICK PHOTO veo | SS pReroN STICK a7 | = =) RO 1D) 10} CT BATT = RV RE iz RE 1 |
AUTO HOVER ALTITUDE MODE:
SMART HEADLESS FLIGHT i) Step1 Step2 AUTO-BACK RETURN lel Se tthe Battery | Picturet. Vv Picture2. Press the Hover ON/OFF button Ss ery Carefully remove battery from . : :
SPEED SETTING @ wires from the battery also note slot as pictured being careful not to Pull the throttle stick (left stick ) upwards in to start or stop the motors Ce hat beer mishtbelnetlt pull battery by the wires otherwise ] order to make the quadcopter fly higher in P :
9 L removing after use, in this case you could disconnect or break one Sec oD y hig 1_| Sky POCKET DRONE as sere Saing aan of the wires (As Picture2). altitude . Pull the throttle stick ( left stick ) 2. | 2.4GHz Remote Transmitter downwards in order to make the quadcopter WARNING BATTERY BOX COVER JOYSTICK BOX fly lower in altitude. 3 | USB Cable for Battery Charging POWER SWITCH Suitable for Children 14+. Adult supervision is always recommended. ie ee _ _ _ _ [Step3] _ Once start the motors, Connect the battery's power cable to the USB charging cable. Then connect the USB to the computer as picture. The light will light up red when the connection is completed, the battery begins to be charged.
*This product contains small parts which are a choking hazard. Keep away from small children. : = yy ey YO Y Pull the throttle stick ( left stick ) upwards or
*Keep Quadcopter at least 10 feet away during use. 5 | Extra Rotor Blades Ss XY downwards to the proper altitude , Release
*Correctly install the Quadcopter and fly it under the guidelines of the instruction manual, small parts should be 6 | 468 SD card _ the throttle stick , the quadcopter will be assembled by an adult. ee ing i i hovering in the altitude. Manufacturers and dealers disclaim all responsibility for damage caused by misuse. Z\ caution 3.7V 550mAh X S@
*Keep hands, hair, and loose clothing away from rotors when powered on to prevent damage to the helicopter TRANSMITTER BATTERY INSTALLATION HOW TO STOP FLYING:
or serious injury to self. 8 Pull out the joysticks 8 When charging thru the included USB cable: Fc on hiarnaeialaten : Pull the throttle stick (left stick) downwards to Thi i LED light is red indicating it is ch ee Fee eer eae or near a Pool controler according to LED light i ea indicating enarainaisiaens the proper altitude. Press the Hover ON/OFF we : oo. th tors.
*When cleaning it, ensure that the helicopter is disconnected from the charger. the arrows's direction button to stop the motors
*To prevent injury, do not point the antenna directly to faces, eyes, or other people. Se. 28 rt NOTE ON THE BATTERY eo)
@o) ENVIRONMENT FOR FLIGHT I le
) 1.If using outside please fly on a sunny day, without wind if possible Flying in extreme heat and/of cold will affect flying control. ems Son This product is furnished with a battery pack, please pay attention to the following safety instructions:
@ Only use the charger provided by the factory for charging.
@ When charging the battery: If the battery is too hot, it means the battery is overcharged. In suca case, users should stop charging the battery immediately. Overcharging could damage the battery eternally.
@ After flying the helicopter, the battery temperature may be relatively high. Users are advised to wait about 10 minutes until the battery has cooled before recharging. Open the battery box cover and Joystick box cover according to the arrows's direction. Please use 4 AAA sized batteries, installed based on polarity 2.Lay the SKY POCKET DRONE on the ground after indi ; ; ; connecting the battery. please wait for the digital gyro to indicated. Please do not mix batteries of different types. take 5-7 seconds to electronically stabilize. Push the throttle up and then back down to connect the remote to
@ Turn off the helicopter whenever it is not in use. If you don't plan on flying the helicopter for along time, Z\caution If transmitter is not to be used for a long the SKY POCKET DRONE the lights should stop blinking charge the battery for about 1 hour before storing it. duration,please remove batteries for storage. and you are now set to fly!
Caution: Risk of explosion if battery is replaced by an incorrect type. Warning: if the AA batteries are left in the transmitter, potential leakage could Dispose of used batteries according to the local laws in your state Z\ WARNING: occur which may damage the transmitter,and create fire hazards.
-1- -2- -3- -4-
CONTROL METHOD Take the left throttle stick and gradually raise it in the upward direction to desired altitude. HEADLESS MODE cu f When signal connection is finished as picture below ( the directions of the drone and player are THE SAME) , Press the headless mode button for 3 seconds to enter headless mode , no matter what direction the head of the drone towards , it will fly forward when you push the control stick forward , it will fly backward when you pull the control stick hackward. AUTO-BACK FLY MODE FRONT bq This function helps you to fly it back in case of any lost. Its very easy to operate. When pressing this button for 3 seconds, the drone will automatically fly backward. Quit the mode when pushing the right control stick towards any direction. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to proviae reasonable protection against Narmftul interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Take the left throttle stick and lower it in the downward direction to decrease altitude and stop propellers from moving. Fly forward : Push the right throttle stick Please notice that : Situation 1. However, there is no guarantee that interference will not occur in a particular forward Fly backward : Pull the right throttle stick Once signal connection is finished, Please notice that : installation. If this equipment does cause harmful interference to radio or backward the direction of THE DRONE(BUT NOT THE PLAYER) will be Fly leftwards : Push the right throttle stick marlnd ee television reception, which can be determined by turning the equipment off and ee In this case (same direction), enter headless mode, Push the control stick forward , it will fly towards the direction which is marked FRONT when signal connection. Push the control stick back / left / right to fly back / left / right. ee (NN AEE NREE ED ES SEIN CA MON TE Wee for 3 seconds on, the user is encouraged to try to correct the interference by one or more of the it will fly CLOSE TO tomatically. nd anaes following measures:
towardsleft =
Fly rightwards : Push the right throttle stick towards right Turn left : Push the lent throttle stick = Reorient or relocate the receiving antenna. towards left Turn right : Push the left throttle stick Increase the separation between the equipment and receiver. towards right i i HEADLESS MODE AUTO-BACK FLY MODE Connect the equipment into an outlet on a circuit different from that to which When signal connection is finished as picture below (the This function helps you to fly it back in case of any lost. Its very the receiver is connected. directions of the drone and player are OPPOSITE) ,Press ] RACK ] easy to operate . When pressing this button for 3 seconds , the PACK IM) Coaneiilt tha daalar ar an aynariancrad radin/TV tachnician for haln HOW TO TRIM THE QUADCOPTER FOR BETTER FLYING ~ fa es When the quadcopter leans towards one side, you need to trim it as follow Put the quadcopter on the FLAT ground, then connect the quadcopter with remote transmitter, Push the left stick and right stick both towards left 45 corner for 3 seconds until the LED lights blink and permanently light up, Push the left stick and right stick both towards right 45 corner for 3 seconds until the LED lights blink and permanently light up, Trim operation is completed, the flying experience will be better. the headless mode button for 3s econds to enter headless mode, no matter what direction the head of the drone towards, it will fly CLOSE TO YOU, when you push the control stic forward, it will fly AWAY FROM YOU, when you pull the control stick backward. Please notice that :
drone will automatically fly backward. Quit the mode when pushing the right control stick towards any direction. Situation 2. ae
=e Pee sare eee Headless Mode Once signal connection is finished, the direction of THE DRONE(BUT NOT THE PLAYER) will be marked. In this case(opposite direction), enter headless mode, Push the control stick forward, it will fly towards the direction which is marked FRONT when signal connection.(NOW THE FRONT IS THE OPPOSITE DIRECTION OF THE PLAYER) Push the control stick back / left / right to fly forward/ right /
left.(NOW THE DIRECTIONS ARE ALSO OPPOSITE TO THE PLAYS) Headless Mode Please notice that :
In this case (opposite direction), press the auto-back fly button for 3 seconds it will fly AWAY FROM YOU automatically.