Power button HOW TO TURN ON WIFI FUNCTION:
After connecting the power supply (do not turn on the power button), press and hold the timer button for 5 seconds. A beep will appear accompanied by a light blue light flashing, indicating that it has entered the connection state. After the connection is successful, the light will stop flashing.
(Note: If no connection is made, the light blue light will continue to flash for 3 minutes and then turn off automatically. If you need to connect again, please repeat the above operations) Power button:
Press 1st time: Power on, unit work with Low mist, L indicator light stays on. Press 2nd time: Power off, unit stop working. Mist button:
Note: only power is on, mist button can work. Press 1st time: unit work with Middle mist, M indicator light stays on. Press 2nd time: unit work with High mist, H indicator light stays on. Press 3rd time: unit work with Low mist, L indicator light stays on. Continuous cycle Press and hold for 3S to enter sleep mode. The colored lights are off and the gear indicator light is off. Light button:
Note: only power is on, light button can work. Press 1st time: eight-color light cycle. Press 2nd to 9th time: Single-color light mode. Press 10th time: Turn off the light. Press and hold for 3S to turn off the lights Note: Under any single-color light mode, press and hold the light button for 3 seconds to turn off the light. Timer button:
Press 1st time: unit work 2H, then stop after 2H, 2H indicator light stays on. Press 2nd time: unit work 4H, then stop after 4H, 4H indicator light stays on. Press 3rd time: unit work 8H, then stop after 8H, 8H indicator light stays on. Press 4th time: Turn off the Timer and the unit will keep working until there is water shortage and it will stop automatically. PLEASE ATTENTION Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference.
(2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s). HMCW-25US