FCC ID: 2BB22-TD-10MWK Smart Access Control Terminal

QUICK START GUIDE Smart Access Control Terminal Applicable Model: TD-10MWKTD-10MWT TD-10MAKTD-10MAT Version : 1.0 Date : June 2023 Touching the future 1Product Overview Parameter:

Input DC12V10%

Swipe distance 0~4CM Working current 200MA Card reading type IC card Working mode TCP/IP networking/offline issuing mode management platform card issuing Working temperature

-20~70 Relative humidity 20% ~ 93%

Open mode swipe card, APP, remote, password (optional) size Installation method control box:273 * 232 * 67mm reading head :86 * 86 * 8MM Control box: hanging installation reading head : 86 box embedded installation.86 box requires a depth of 50MM inside 2Controller interface description TCP/IP Network port Interface description:

Location Function Description J4 J5 J6 J1 Power and relay output interface Exit button and door magnetic detection interface 485 bus communication interface LAN cable crystal head interface SW1(0 means no dialing, 1 means dialing to ON) Mode selection( 00TCP/IP LAN networking,01:Offline) Interface Name Function Description

+12V GND NC COM NO EXIT DSW Power and relay output interface Exit button and door magnetic detection interface 485 bus communication interface LAN cable crystal head interface Relays normally open Exit key signal detection Door magnet signal detection 485A/B 485 bus A/B interface 3System wiring references:

4Wiegand Reader Installation diagram:

(a) Connect the signal line in the back of the read head device as shown in the figure below. Back Signal wire interface

(b) Install the reading head device into the 86 box, (note that you need to use the embedded wall inside the depth of 50MM style 86 box), lock the screws to fix, as shown in the figure below. Front Fixing screws

(c) Read the head panel and read the head body snap together, first from the upper snap down and then press the lower and bottom screw hole alignment; finally in the bottom of the anti-theft screw hole screwed on the countersunk head machine wire within the plum security screws fixed,as shown in the figure below. Bottom Locking plum security screw hole 5Multi-door Controll Function Description 5Multi-door Controll Function Description Operating mode selection Switch Setting Indicates Switch Setting Indicates Offline working TCP/IP LAN networking 01 00 Startup status TCP/IP LAN networking : When the power is on, the blue LED flashes, indicating that it is looking for the network. When normally connected to the network, the buzzer "tick ~ tick" two short beeps, the LED red light is always on, indicating that the cloud access control has started normally;

when 20 seconds later is not normally connected to the network, the buzzer "tick tick tick" three beeps, the LED red light is always on, indicating Connection network failure, the controller forced to start. After the controller is normally connected to the network, the LED green light will flash once every 20 seconds, indicating that there is data and the cloud platform interactive communication. Offline working: When the power is started, the buzzer "beep" a short beep, the LED red light is always on, indicating that the cloud access control has started normally. Unlock status When the lock is opened legally, the buzzer of the controller and the reading head will be "beep" at the same time, accompanied by a green LED flashing once, and the corresponding relay will be jumped, which means that the lock is opened successfully; when the lock is opened illegally, the buzzer of the controller and the reading head will be "beep beep beep" three times at the same time, accompanied by a red LED flashing three times, which means that the lock is opened and failed. Unlock method The device can be unlocked by swipe card, remote APP, out door button, management center platform remote, cloud server platform remote, password (optional), and many other ways. 6Multi-door Controll Configuration Management Center Add Controller Connect the controller to the PC with a network cable, open the controller management software, and click Add Controller by Search. At this time, the management software can automatically search for the multi-door controllers connected to the LAN and assign them to the corresponding IP. Then configure the controller to the corresponding area. Click to confirm that the controller can be bound to the corresponding regional access control. Add user and configure his permissions In the management center, add users to configure the rights of the corresponding area controllers for them. After the configuration is completed, users can open the door in the room where these controllers are installed by swipe card, APP, password, etc. More detailed controller management and Add User:

Configuration Permissions:

7Remote control controller Remotely open doors and view access records After you open Trudian APP and log in the user you have added in the management center, the APP home page shows all the controllers that the current user can control. You can open the door remotely in APP, and you can also view all the door opening information recorded by the controller in APP. View access records with APP Open the door remotely with APP www.trudian.com/en/

HQ Add: Farbell Technology Park,Yixian Road, Nanlang, Cuiheng New District, Zhongshan City, Guangdong Province, China. Zip Code:528451 Phone: +86 0760 - 23689666 E-mail: sales@trudian.com If the problem is not solved properly,please send the mail to:

support@trudian.com FCC Caution This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Guangdong Trudian Technology Co., Ltd. 2023.07.26 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Shenzhen BCTC Testing Co., Ltd to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Clients signature:

Clients name / title : Bowen Wang / Manager Contact information / address: Farbell Technology Park, Yixian Road, Nanlang, Cuiheng New District, Zhongshan City, Guangdong Province, China, 528451

Guangdong Trudian Technology Co., Ltd. 2023.07.26 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for FCC ID: 2BB22-TD-10MWK

[Guangdong Trudian Technology Co., Ltd.] (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely,

(Applicant signature)

(Applicant printed name) Bowen Wang Guangdong Trudian Technology Co., Ltd. 2023.07.26 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for FCC ID: 2BB22-TD-10MWK

[Guangdong Trudian Technology Co., Ltd.] (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely,

(Applicant signature)

(Applicant printed name) Bowen Wang

Guangdong Trudian Technology Co., Ltd. 2023.07.26 Eurofins Electrical and Electronic Testing NA, Inc. 914 W. Patapsco Avenue Baltimore, MD 21230 USA RE: CONFIDENTIALITY REQUEST FOR EUT NAME: Smart Access Control Terminal Trademark: N/A MODEL : TD-10MWK, TD-10MWT, TD-10MAK, TD-10MAT, TD-12MWK, TD-

12MWT, TD-12MAK, TD-12MAT, TD-13MWK, TD-13MWT, TD-13MAK, TD-

13MAT, TD-15MWK, TD-15MWT, TD-15MAK, TD-15MAT, TD-09MR FCC ID : 2BB22-TD-10MWK To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the

- Block Diagram

- Schematics

- Operational Description required to be submitted with this application be permanently withheld from public review. The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. Please contact me if there is any information you may need. Sincerely, Clients signature:

Clients name / title : Bowen Wang / Manager Contact information / address: Farbell Technology Park, Yixian Road, Nanlang, Cuiheng New District, Zhongshan City, Guangdong Province, China, 528451

Guangdong Trudian Technology Co., Ltd. Model Difference 2023-07-26 EUT NAME: Smart Access Control Terminal FCC ID: 2BB22-TD-10MWK MODEL : TD-10MWK, TD-10MWT, TD-10MAK, TD-10MAT, TD-12MWK, TD-12MWT, TD-12MAK, TD-12MAT, TD-13MWK, TD-13MWT, TD-13MAK, TD-13MAT, TD-

15MWK, TD-15MWT, TD-15MAK, TD-15MAT, TD-09MR All the model are the same circuit and RF module, except model names. Regards Sincerely Clients signature:

Clients name / title : Bowen Wang / Manager Contact information / address: Farbell Technology Park, Yixian Road, Nanlang, Cuiheng New District, Zhongshan City, Guangdong Province, China, 528451

Guangdong Trudian Technology Co., Ltd. U.S. Agent Designation for Service of Process

(Applicant and U.S. Agent are Separate Parties) TO: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046, USA ATTENTION: FCC Certification Section 2.911(d)(7) Information Designated U.S. Agent Company Name: AOCE Corporation Inc. FRN: 0033401381 Contact Name: Johnson.wang Address: 6547 N Academy Bivd #2266, Colorado Springs, CO,80918 United States Telephone No: +1-346-582-5234 Email: wwbj2008@126.com This letter is to confirm that we (AOCE Corporation Inc.) have accepted the responsibility to act as the Designated U.S. Agent for Service of Process as required by section 47 CFR 2.911(d)(7) on behalf of the Applicant noted below. U.S. Agent Signature:

Date:2023-07-17 fvion PS sy XN ifs | Ww Signed by (Printed Name/Title): ohn) i The Applicant acknowledges that they must maintain an agent for no less than one year after terminating all marketing and importation OR the conclusion of any Commission-related proceeding involving the equipment. The applicant further acknowledges their responsibility to inform the FCC whenever the Designated U.S. Agent information above changes. Applicant Company name: Guangdong Trudian Technology Co., Ltd. FCC ID: 2BB22-TD-1OMWK Contact Name: Bowen Wang Address: Farbell Technology Park, Yixian Road, Nanlang, Cuiheng New District, Zhongshan City, Guangdong Province, China, 528451 Telephone No: +86 18818526433 Email: bowen.wang@trudian.com Applicant Signature: ;

rp . Power Woe Date: 2023-07-17 \

Signed by (Printed Name/Title): Bowen Wang/Manager