GLOW IN THE DARK ORBIT TUMBLER 6+
Carefully remove items from package. ii OPERATING INSTR UCTI ONS iiii The car requires 6 AA (1.5V) alkaline batteries (not included). The battery compartment is on the underside of the vehicle. Loosen the screw using a phillips or cross screwdriver to remove the battery cover. Insert the AA batteries according to the diagram inside the battery tray. Replace battery cover and tighten screws. iiiiii The remote control requires 4 AA (1.5V) alkaline batteries (not included). Loosen the screw at the bottom of the remote using a phillips or cross screwdriver to remove the battery cover. Insert the batteries according to the diagram inside the battery tray. Replace battery cover and tighten screw. Power Switch Battery Compartment Screw Pairing:
The Orbit Tumbler and Remote must be paired before driving. 1. Rotate the remote power knob clockwise to turn on the remote. The status light on Charging the Glow In The Dark Cage:
Place the Orbit Tumbler in direct sunlight for approximately 60 minutes. The cage will now glow in the dark for up to 20 minutes. the antenna cover will pulse. 2. Turn on Orbit Tumbler its lights will ash rapidly. 3. The lights on the Orbit Tumbler and Remote will stop ashing when they are paired. If you have more than one vehicle and remote, you must pair one rst, and then you may pair others. Forward
*Press and Hold Power Knob Left Wheels Status Light Stunt Button Right Wheels SAFETY PRECAUTIONS Avoid water when operating. Do not submerge car or controller in water. Do not use people or animals as obstacles. Do not run car into furniture objects or hard surfaces as this will cause damage to both the objects and car. Keep ngers, hair and loose clothing away from the tires, gears and motor while car is switched to ON. Do not leave car or remote control near sources of heat or under direct sunlight for long periods of time. Remove all batteries when not in use to avoid accidental operation. Adult supervision is recommended when operating car. Thoroughly inspect products before every use. If the product appears worn, frayed/splintered, cracked, or broken in any manner, discontinue use and discard immediately. BATTERY WARNING:
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries. Alkaline batteries are recommended. Use only the specied voltage. Insert batteries using the correct polarity. Always use, replace, and recharge (if applicable) batteries under adult supervision. Do not charge with non-rechargeable batteries. Do not short-circuit the battery supply terminals. Do not dispose of batteries in a re, batteries may explode or leak. Remove batteries before storing. Recycle or dispose of batteries according to federal, state, and local laws. Keep these instructions for future reference. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. KEEP THIS INSTRUCTION MANUAL AS IT CONTAINS IMPORTANT INFORMATION FOR FUTURE REFERENCE. Due to continuous product improvements, the pictures on this manual may differ slightly from the actual product. The artwork and design of this manual are protected by US copyright law and may not be reproduced, distributed, displaced, published or used for any purpose without prior written permission. Altering, removing or reproducing any of the trademark or copyright notices on this package is not permitted. Sharper Image name and logo are registered trademarks. Distributed by and 2020 MerchSource, LLC. Irvine, CA 92618. All rights reserved. Model Number: 1014148 Printed in China FOR TECHNICAL SUPPORT, PLEASE CALL 1-800-374-2744 Reverse
*Press and Hold Spinning Action
*Press and Hold Tumbling When the vehicle is moving forward or backward and push the stunt button, it will cause it to ip over. Note: for best operation, use vehicle on hard rough surface.