OWNER'
S MANUAL indicates indicates Correct of this product Disposal This marking This marking other household other household harm to the environment harm to the environment disposal, disposal, material material return return product product mental mental To return To return systems systems was purchased. was purchased. safe recycling. safe recycling. recycle recycle resources. resources. and collection and collection that this product that this product wastes throughout the wastes throughout the should should EU. To prevent EU. To prevent with with not be disposed not be disposed possible possible it responsibly it responsibly to promote to promote or human health or human health from uncontrolled from uncontrolled the sustainable the sustainable waste waste reuse of reuse of your used device, your used device, or contact or contact use the use the the retailer where the where the the retailer for environ for environ They can take this product They can take this product please please FCC Warning omplies with part 15 of the FCC Rules. Operation is s ubject to the ause harmful interference, and This device c following two c
(2) this device may cause undesired operation. onditions: (1) This must accept an device may not c y interference received, including interference that ply with the limits for a are designed nable protection against harmful mmercial environment. This equipment generates, uses, and can hen the equipmen y and, if not installed and used in ac cordance with the ual, may cause harmful interfere nce to radio communications. FCC Rules. These limits t is nt has been tes ted and found to com rsuant to part 15 of the interference w NOTE 1: This equipme Class A digital device, pu to provide reaso operated in a co radiate radio frequency energ instruction man Operation of this equipment in a re interference in own expense. NOTE 2: Any changes or responsiblefor modifications not compliance could which case the user will be requ ired to correct the interference at his sidential area is likely to cause harmful expressly approved by the party void the users authority to operate the equipment.
&CAUTION read all precautions and Please instructions before in this manual using this equipment. DAILY MAINTERANCE The running belt of the treadmill is imported which was made from special materials with lower coefficient of friction and higher of tensile strength; the running board is with double shock-absorb system and which surface is smooth and hard wearing. Lubricating It can prolong the life of treadmill to keep it in clean situation, so its necessary to clean usually the exposed running board and side foot-board, to wipe running belt by soft cloths with water, please pay attention to prevent the water from the underside of belt and over. The treadmill uses the auto-lubricating system. When the console test the total distance reached the pre-setted distance in the system,the lubricating motor begin to work.During using ,user should check the auto-lubricating system timely. Add the oil quickly if find the oil bottle is empty. If the auto-lubricating system dont work well,please call the dealer quickly. Adjusting to loose or tight belt The running belt was adjusted before it left the factory and after assembling, but after a period of usage, the belt will become loose, this circumstance is out of guarantee to be repaired. The user can adjust it by oneself .the loose belt will slip, but over much tight belt perhaps harms the motor, roller and itself. Solution Remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjust-
ment bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each side of the walking belt 5 to 6 cm off the walking platform. Be careful to keep the walking belt centred. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened. The walking belt is off-centre All the running belt were adjusted before the treadmill left the factory or after assembling,but after a period of usage,the belt will off-centre,this circumstance is from the following causes:
(1) The treadmill is not horizontal.
(2) The feet of user do not stand on the center of belt.
(3) The two feet of user are with different strengths. Solution Usually it can return after several minutes moving, but if it cant, please adjust the bolt which is at the end of treadmill at unit of half-circle by a allen wrench. If the belt slant to left, please adjust the left boltclock-wisely or adjust the right bolt counter clock-wisely(B).If the belt slant to right, its adjusted oppositely(C).Repeat until the walking belt is centred(The side of running belt in the labels green colour)(D). The excentric running belt is out of guarantee .The user adjust it by oneself. More attention:The excentric belt will strictly harm itself,so the user must adjust it once find this circum-
stance. Running Belt Technical Parameter Input voltage 220V15% 50Hz60Hz Motor power 3.0 Hp Max 7 Hp Surrounding temperature 0-40 C Speed scope 1--20Km/h Incline scope 0--15%
Time scope 00:00:00-99:59:59+Min.Sec. Distance scope 0-999+Km Calorie 0-999+Kilocalorie Packing List NO. Cylindrical head hexagon bolt M6*12 Cylindrical head hexagon bolt M6*16 Cylindrical head hexagon bolt M8*85 Cylindrical head hexagon bolt M10*30 11 PCS Spring washer M6black Description Mainframe Electronic watch Electronic watch holder Tray handle Frame of upright pole Spring washer M6 Spring washer M8 Spring washer M10 Plate washer M6 Tool Oil pot Specification Quantity 1 PC 1 PC 1 PC 1 PC 2 PCS 2 PCS 4 PCS 4 PCS 4 PCS 4 PCS 4 PCS 11 PCS 4 PCS 1 SET 1 PC 1 PC 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 More attention: its not over much tight, much better. 9 2