Sun light angles Product details How to use Operation Most suitable 45 Normal Solar chips Window protector Magnetic suction interface Power bank Not recommended Power/Pilot lamp IN Flashlight OUT STATE Short press, Electric 0%~5%
Short press, Electric 5%~50%
Short press, Electric 50%~100%
Light is not ideal when charging outdoors Light is ideal when charging outdoors Wireless charging, charging normal The charging load is full, and the charging load is full Wireless charging, charging anomaly LAMP Red light icker Red light Green light Red/green light
icker Red/green light
ash Blue breathing light Blue light Blue light cker Tag 1. The light is not ideal, proposed to adjust the power angle of paper. Long press button, turn the ashlight on or o. 2. Accessories list Hanergy Solar Power Bank Instructions Certicate X1 X1 X1 Warning The product contains lithium polymer core, which is forbidden to disassemble the shell of the product. The removal of the shell of the product can cause damage, leakage and even explosion. Do not use this product in closed enviornment. Do not tear down the lm shell, it will damage the circuit. Do not use this product in closed enviornment. Do not pierce the lm. Do not to use the product where the temperature is either below -4F or above 122F. FCC ID:2AP9U-Z01 This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 18 of the FCC Rule. IMPORTANT SAFETY INSTRUCTIONS WARNING When using this product, basic precautions should always be followed, including the following:
a) Read all the instructions before using the product. b) To reduce the risk of injury, close supervision is necessary when the product is used near children. c) Do not put ngers or hands into the product. d) Do not expose power bank to rain or snow. e) Use of a power supply or charger not recommended or sold by power pack manufacturer may result in a risk of re or injury to persons. f) Do not use the power bank in excess of its output rating. Overload outputs above rating may result in a risk of re or injury to persons. g) Do not use the power bank that is damaged or modied. Damaged or modied batteries may exhibit unpredictable behavior resulting in re, explosion or risk of injury. h) Do not disassemble the power bank. Take it to a qualied service person when service or repair is required. Incorrect reassembly may result in a risk of re or injury to persons. i) Do not expose a power pack to re or excessive temperature. Exposure to re or temperature above 100C may cause explosion. The temperature of 100C can be replaced by the temperature of 212F. j) Have servicing performed by a qualied repair person using only identical replacement parts. This will ensure that the safety of the product is maintained. k) Switch o the power bank when not in use. SAVE THESE INSTRUCTIONS This device complies with Part 18 of the FCC Rule This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Attention that changes or modication not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this product does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Warning 6 7 This product provides the USB type A interface. Please note that this is not a toy, keep it away from children. It is not recommended to use while A. Rainy, snowing, cloudy B. Under light C. In door 1 2 3 4 5 The performance depends on many factors including sun light angle, weather condition and temperature etc. It is recommended to use the solar lm outdoors and it is advised to avoid shading the lm. Otherwise, it will impact the performance of the charger. When using this product in low light intensity, i.e. indoors, inside the vehicle the output current could be low, hence it cannot charge other equipments. The product temperature may raise/increase during usage. Avoid using this product during rain or snow. Do not use water or any chemical liquid to wipe
(especially corrosive liquids). Do not put the solar lm into the washer. Product information Type:
Chip:
Power Composite interface:
Battery power:
Input voltage:
Output voltage:
NFC Working temperature Dimension Weight HZ-G012011C CIGS 12.0W PLUS IN Magnetic 5000mAh/3.7V 5.0V 2A(Micro USB) 5.0V 2A(USB type-A)(Max) SupportQi5W output
-10+55 20011626(mm) 460g
* Standard Test Conditions (STC):
Cell Temperature at 25C; Solar irradiance intensity of 1000 W/m ; AM1.5 solar reference spectrum (ASTM E892 The solar chip of dierent colors is a unique feature of CIGS exible thin lm chip, power performance is not aected, please prevail in kind. operating guide