Hanma Company Limited HM-R01-RC Remote Controller Instruction This remote controller use EV1527 to control the 2 motors and 1 LED PCB of the searching light. There are 6 buttons as the picture below:
pilot light SOS international distress signal button LEFT ON/OFF button UP RIGHT DOWN 1. On/off buttonpress the button, the motor will be on standby,and other buttons are effective.Press the button one more time, the motor will be dormant,and other buttons are ineffective. 2. SOS international distress signal buttonpress the buttonthe light will flash as international distress signal. Press the button one more time, the light will stop flashing. 3. Button UPpress the buttonthe light will turn upward. Press the button and do not release, the light will turn upward and keep rotating around vertically. Release the button, the light will stop rotating and keep the direction as it is. Hanma Company Limited 4. Button DOWNpress the buttonthe light will turn downward. Press the button and do not release, the light will turn downward and keep rotating around vertically .Release the button, the light will stop rotating and keep the direction as it is. 5.Button LEFTpress the buttonthe light will turn left. Press the button and do not release, the light will turn left and keep rotating around horizontally.Release the button, the light will stop rotating and keep the direction as it is. 6.Button RIGHTpress the buttonthe light will turn right. Press the button and do not release, the light will turn right and keep rotating around horizontally. Release the button, the light will stop rotating and keep the direction as it is. Battery box Battery Battery cover Remote Control Distance30m Battery1pc of battery with 23A 12V Codingpress the ON/OFF button for 3 seconds with power supply, it starts coding and all other memory will be eliminated. Hanma Company Limited FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.