QUICK START GUIDE
HITRON
CGNV5
Check the contents of the box
Step
Make sure you have the following:
Read me
First!
Primero!
Connect to the internet
Connect phone
CGNV5
CABLE ETHERNET
QUICK START GUIDE
Connect the coaxial cable to the connector
Configure la red WiFi
P3300047CN17
Connect power
Connect the coaxial cable from the cable outlet to the
connector of the device.
Connect the power adaptor to the power port and switch to
“ON”.
Connect the phone to the voice port
Connect your computer to the device
Use the phone cord to connec ypur phone to the Voice Port and
wait for a dial tone before using.
Use the Ethernet cable that comes with the device to connect
your computer to one of the LAN ports
STEP
STEP
STEP
STEP
User configuration (optional)
Connect your computer to the wireless network
STEP
Your device has a configuration interface that allows you to
fully control the behavior of the device. In a web browser,
enter the IP of the device in the address bar and make sure
that your PC is on the same subnet as deice. On the screen
that appears, enter the username and password.
Contraseña: #BBAADD@CCFFEE*
IP del dispositivo:
Modo Router: 192.168.1.1
Mode Bridge: 192.168.100.1
STEP
Connect the wireless devices with the correct SSID and password.
If they have not been changed, the default values are indicated on
the sticker on the back of the equipment.
Connect your wireless devise with WPS unction. Enter the setting interface
(refer to step 6), Enter the Wireless page to
Enable WPS and set the AES encryption mode,
then press Save changes.
Press this button to start the WPS Push Button
(PBC) setup process. Press on the PBC button of
your wireless clients within the coverage area
within the two minutes allowed to join the
wireless network.
Installation complete
STEP
Congratulations! You have successfully configured your CGNV5. If you have a problem, see the next section for help identifying the cause.
IP Address
If the CGNV5 successfully connects to the network (see LED Panel) butt you cannot access the internet from a connected computer, it is possible
that the IP address of your computer is not configured correctly. In the network settings of the computer, make sure that is it configured to receive
an IP address automatically (recommended) or that is has a static IP address in the range 192.168.1.2 ~ 192.168.1.253.
For more information, see the help documentation for your operating system.
LED display
Green
Power received and normal.
Power
Dark
No power.
Green-Blinking
The modem is searching for the
DOWNSTREAM Frequency.
Downstream
Green-Steady
Downstream frequency is locked.
Blue-Steady
is successfully engaged in channel bonding
Dark
Not scanning
on the downstream connection.
Green-Blinking
The modem is ranging on the UPSTREAM
Frequency.
Upstream
r
Green-Steady
Blue-Steady
Upstream ranging done. Conectado is
successfully engaged in channel bonding on
Dark
the upstream connection.
Not scanning
Green-Blinking
Green-Steady
Dark
The traffic pass through LAN.
LAN is activated.
LAN is disabled.
LAN
Green-Blinking
Green-Steady
Dark
2.4G
WiFi
(2.4GHz)
The traffic pass through 2.4G WiFi.
2.4G WiFi is activated.
2.4G WiFi is disabled.
Green-Blinking
Green-Steady
Dark
5G
WiFi
(5GHz)
The traffic pass through 5G WiFi.
5G WiFi is activated.
5G WiFi is disabled.
.
Registration in progress (cable interface
acquires IP, time of day, cable modem settings)
Register success.
Not registered.
Green-Blinking
Green-Steady
Dark
Statu
s
Safety warnings
Green
Phone is online.
Green-blinking
Phone is ringing.
LINE
Dark
Phone is offline.
WARNING
Risk of electrical shock. Do not expose the device to water or moisture.
The device is a high-performance communications device designed for home and office environments. Do not use the device outdoors.
Keep the device in an environment between 0°C - 40°C (32°F - 104°F). To avoid overheating, do NOT place any object on top of the device.
Do not restrict the flow of air around the device. The manufacturer assumes no liabilities for damage caused by any improper use of the device.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
DISCLAIMER
The manufacturer assumes no liabilities with respect to the contents of this document. The manufacturer also reserves the right to revise this document or
update the content thereof without any obligation to notify any person of such revisions or amendments. Specifications subject to change without notice.
CAUTION
The cable distribution system should be grounded (earthed) in a accordance with ANS/NFPA 70, the National Electrical Code (NEW), in particular Section
820.93, Grounding of Outer Conductive Shield of a Coaxial Cable.
COPYRIGHT © 2020 HITRON TECHNOLOGIES, INC.
FCC STATEMENTS
FCC STATEMENTS
IC STATEMENTS
FCC STATEMENTS
UL and NOM-019
FCC STATEMENTS
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with
any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures.
This device is going to be operated in 5.15~5.25GHz frequency range, it is restricted in
indoor environment only.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This device complies with Industry Canada license-exempt RSS standard(s). Operation
is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
Pour les produits disponibles aux États-Unis / Canada du marché, seul le canal 1 à 11
peuvent être exploités. Sélection d'autres canaux n'est pas possible.
This device and it's antennas(s) must not be co-located or operating in conjunction with
any other antenna or transmitter except in accordance with IC multi-transmitter product
procedures.
Cet appareil et son antenne (s) ne doit pas être co-localisés ou fonctionnement en
association avec une autre antenne ou transmetteur.
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement
pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable
aux systèmes de satellites mobiles utilisant les mêmes canaux;
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies
pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec
un minimum de 20cm de distance entre la source de rayonnement et votre corps.
Warning:
the cable distribution system should be grounded (earthed) in accordance with ANSI /
NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of
Outer Conductive Shield of a Coaxial Cable.
"CAUTION"
1. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE TO
DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTED.
2. Unambiguous reference to service documentation for instructions for replacement of
fuses replaceable only by service personnel
3. For telecommunication type connectors and terminals not used for connection to the
telecommunication network should be provided with a marking identifying the specific
function or circuit characteristic the connector or terminal is used for.
Connector: RJ-45 'Ethernet 1, 2, 3, 4'
advertencia:
el sistema de distribución de cable debe estar conectado a tierra (masa) de acuerdo
con ANSI / NFPA 70, Código Eléctrico Nacional (NEC), en particular la Sección 820.93,
Conexión a tierra de revestimientos conductores externos de un cable coaxial.
“PRECAUCIÓN"
1. RIESGO DE EXPLOSIÓN SI SE SUSTITUYE LA BATERÍA POR UN TIPO
INCORRECTO PARA ELIMINAR LAS BATERÍAS USADAS SEGÚN LAS
INSTRUCCIONES.
2. Referencia inequívoca a la documentación de servicio para obtener instrucciones
sobre la sustitución de fusibles sustituibles sólo por personal de servicio
3. Para conectores de tipo de telecomunicaciones y terminales no usados para la
conexión a la red de telecomunicaciones deben estar provistos de un marcado
identificación de la función o característica específica del circuito del conector o
terminal se utiliza para.
Conector: RJ-45 'Ethernet 1, 2, 3, 4'
NOM-121
FCC STATEMENTS
La operación de este equipo está sujeta a las siguientes dos condiciones:
(1) es posible que este equipo o dispositivo no cause interferencia perjudicial y
(2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que
pueda causar su operación no deseada.
cUL
FCC STATEMENTS
LISTED
CAUTION:
Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries
According to the Instructions.
The cable distribution system should be grounded (earthed) in accordance with ANSI /
NFPA 70, National Electrical Code (NEC), in particular Section 820.93, Grounding of
Outer Conductive Shield of a Coaxial Cable.
Unambiguous reference to service documentation for instructions for replacement of
fuses replaceable only by service personnel.
For telecommunication type connectors and terminals not used for connection to the
telecommunication network should be provided with a marking identifying the specific
function or circuit characteristic the connector or terminal is used for.
ATTENTION:
Il y a risque d’explosion si la batterie est remplacée par une batterie de type incorrect.
Mettre au rebut les batteries usagées conformément aux instructions.
le système de distribution par câble doit être mis à la terre ( la terre) conformément à la
norme ANSI / NFPA 70 , National Electrical Code ( NEC ), en particulier l'article 820.93 ,
la terre du blindage conducteur extérieur d'un câble coaxial.
Référence sans ambiguïté à la documentation de service pour obtenir des instructions
pour le remplacement des fusibles remplaçables par un personnel de service.
Pour les connecteurs de type de télécommunication et les terminaux ne sont pas
utilisées pour le raccordement au réseau de télécommunication doivent être pourvus
d'un marquage d'identification de la fonction spécifique ou une caractéristique du
circuit du connecteur ou d'un terminal est utilisé pour.
0440010162N0(2A)