Nokia Pro Wireless Earphones (BH-701) Quick Start Guide Whats in the box EN Nokia Pro Wireless Earphones x 1 Micro USB Cable Quick Start Guide x 1 x 1 Ear Tips x 2 pairs 1 Product overview 6 7 2 4 1 3 5 1 2 3 4 5 6 7 2 Multifunction key Volume up / previous track key Volume down / next track key LED indicator light Microphone Ear n Ear tip Get started Before using Nokia Pro Wireless Earphones, connect the Micro USB cable to a power source to being charging. 1. When battery is low, the earphones will beep and LED indicator light will ash red. 2. Power on: Press and hold Key for 3 seconds until the LED 1 shows a white light. Power o: Press and hold Key for 5 seconds until the LED shows a red light. 1 3 Pair and connect with Bluetooth To go into pairing mode > press and hold key for 3 seconds until the LED ashes red and white alternately. Turn on Bluetooth in your device and choose Nokia Earphones from the Bluetooth menu to connect. 1 1. 2. Nokia Earphones Wearing your earphones For optimal t and audio performance, adjust the ear n and replace the ear tips with the size that best suits for you. 4 Using your earphones Buttons Previous track 1. Volume up Play or pause music Activate voice commands Answer or end calls Reject calls Switch call to device from your earphones Next track Volume down 2 secs x 1 x 1 x 2 x 1 2 secs 2 secs 2 secs x 1 2. Smart Earbuds Function Attrack Seperate Streaming music Incomming call 3. Vibration Notication
- Incomming call (vibration before the ringtone)
- Power on / power o
- Connect between your earphones and device successfully 5 Product and safety information Remote control functions may vary depending on the model of your device and application. Sound track instructions do not respond to iOS devices. Since devices with Bluetooth wireless technology communicate using radio waves, they do not need to be in direct line-of-sight. Bluetooth devices must, however, be within 10 meters (33 feet) of each other, although the connection may be subject to interference from obstructions such as walls or from other electronic devices.
- Frequency Band: 2402 MHz - 2480 MHz
- Maximum Radio Frequency Power: -6~+4dBm For your safety Important: Read these simple guidelines. Not following them may be dangerous or against local laws and regulations. For further info, read the complete user guide. Switch o in restricted areas Switch the device o when a Bluetooth headset use is not allowed or when it may cause interference or danger, for example, in aircraft, in hospitals or near medical equipment, fuel, chemicals, or blasting areas. Obey all instructions in restricted areas. Interference All wireless devices may be susceptible to interference, which could aect performance. Batteries, chargers, and other accessories Use only batteries, chargers, and other accessories approved by HMD Global Oy for use with this device. Do not connect incompatible products. Protect your hearing To prevent possible hearing damage, do not listen at high volume levels for long periods. 6 Hearing Warning: When you use the earphones, your ability to hear outside sounds may be aected. Do not use the earphones where it can endanger your safety. The surface of this product is nickel-free. Small children Your device and its accessories are not toys. They may contain small parts. Keep them out of the reach of small children. Take care of your device Handle your device with care. The following suggestions help you keep your device operational.
- Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that corrode electronic circuits.
- Do not use or store the device in dusty or dirty areas.
- Do not store the device in high temperatures. High temperatures may damage the device or battery.
- Do not store the device in cold temperatures. When the device warms to its normal temperature, moisture can form inside the device and damage it.
- Do not open the device other than as instructed in the user guide.
- Do not drop, knock, or shake the device or the battery. Rough handling can break it.
- Only use a soft, clean, dry cloth to clean the surface of the device.
- Do not paint the device. Paint can prevent proper operation. 7 Recycle Always return your used electronic products, batteries, and packaging materials to dedicated collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of materials. Electrical and electronic products contain a lot of valuable materials, including metals (such as copper, aluminium, steel, and magnesium) and precious metals (such as gold, silver, and palladium). All materials of the device can be recovered as materials and energy. Crossed-out wheelie bin symbol The crossed-out wheeled bin symbol on your product, battery, literature,or packaging reminds you that all electrical and electronic products and batteries must be taken to separate collection at the end of their working life. Do not dispose of these products as unsorted municipal waste: take them for recycling. For info on your nearest recycling point, check with your local waste authority. Battery info Your device has an internal, non-removable, rechargeable battery. Do not attempt to remove the battery, as you may damage the device. The battery can be charged and discharged hundreds of times, but it will eventually wear out. Charging time can vary depending on device capability. Battery safety If left unused, a fully charged battery will lose its charge over time. Always keep the battery between 15C and 25C (59F and 77F) for optimal performance. Extreme temperatures reduce the capacity and lifetime of the battery. A device may temporarily stop working if its battery is too hot or too cold. Do not dispose of batteries in a re as they may explode. Obey local regulations. Recycle when possible. Do not dispose as household waste. Use the battery for its intended purpose only. Improper use of, or use of unapproved or incompatible, batteries may present a risk of re, explosion, or other hazard, and may invalidate any approval or warranty. If you believe the battery is damaged, take it to a service centre or your local shop before continuing to use it. Never use a damaged battery. Do not charge your device during a lightning storm. 8 Implanted medical devices To avoid potential interference, manufacturers of implanted medical devices recommend a minimum separation of 15.3 centimetres (6 inches) between a wireless device and the implanted medical device. Persons who have such devices should:
- Always keep the wireless device more than 15.3 centimetres (6 inches) from the medical device.
- Not carry the wireless device in a breast pocket.
- Switch the wireless device o if there is any reason to suspect that interference is taking place.
- Follow the manufacturer directions for the implanted medical device. If you have any questions about using your wireless device with an implanted medical device, consult your health care provider. 9 Copyrights and other notices The availability of products, features, apps, and services may vary by region. For more info, contact your dealer or your service provider. This device may contain commodities, technology or software subject to export laws and regulations from the US and other countries. Diversion contrary to law is prohibited. The contents of this document are provided as is. Except as required by applicable law, no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability and tness for a particular purpose, are made in relation to the accuracy, reliability or contents of this document. HMD Global reserves the right to revise this document or withdraw it at any time without prior notice. Reproduction, transfer or distribution of part or all of the contents in this document in any form without the prior written permission of HMD Global is prohibited. HMD Global operates a policy of continuous development. HMD Global reserves the right to make changes and improvements to any of the products described in this document without prior notice. Manufacturer and importer in EU: HMD Global Oy, Karaportti 2, 02610 Espoo, Finland. HMD Global Privacy Policy, available at http://www.nokia.com/phones/ privacy, applies to your use of the device. In the unlikely event that this product is faulty, please return it to the store where you purchased it with your proof of purchase. For more information on this or other products please visit www.nokia.com/phones. 2018 HMD Global. All rights reserved. HMD Global Oy is the exclusive licensee of the Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation. The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by HMD Global is under license. All other trademarks are the property of their respective owners. Declaration of Conformity Hereby, HMD Global Oy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found at www.nokia.com/mobile-declaration-of-conformity. 10 FCC Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.