Get Started Nokia 8 Main cameras Audio connector Microphone SIM card/MicroSD card Front camera Microphone Earpiece Fingerprint sensor/Home Charger connector Loudspeaker Microphone Volume keys Power/Lock key TA-1012/TA-1004 DS EN 0.17 1. Insert the SIM and memory card 1. Open the SIM tray and memory card tray by putting the provided tray opener into the hole next to the tray. 2. Put the nano-SIM into slot 1 located on the tray with the contact area face down. If you have a dual SIM variant, you can either put a second SIM or a memory card into slot 2. If you have a single SIM variant, you can only put a memory card into slot 2. 3. Slide the SIM and memory card trays back into the slots. Use only original nano-SIM cards. Use of incompatible SIM cards may damage the card or the device, and may corrupt data stored on the card. 3. Learn more about your new Nokia phone For a printable user guide, online user guide, and troubleshooting help, go to www.nokia.com/
mobile-support. 2. Charge the battery and switch the phone on Plug a compatible charger into a wall outlet, and connect the cable to your phone. Your phone supports the USB-C cable. You can also charge your phone from a computer with a USB cable, but it may take a longer time. If the battery is completely discharged, it may take several minutes before the charging indicator is displayed. To switch your phone on, press and hold the power key until the phone vibrates. The phone guides you through the setup. USB-C USB micro-B Product and Safety info Important: We invite you to read the enclosed instructions before installing your equipment. For valuable information on the safe use of the device and battery, read the Product and safety info booklet before you take your device into use. For important info on the safe use of your device and battery, read the Product and safety info booklet before you take your device into use. You can only use your device on the GSM/GPRS/EDGE 5,8,2,3 850/
900/1800/1900; HSPA 1,2,4,5,8 2100/1900/1700/850/900; LTE 1/
2/3/4/5/7/8/20/28/38/40/41 networks. You need a subscription with a service provider. Important: 4G/LTE might not be supported by your network service provider or by the service provider you are using when traveling. In these cases, you may not be able to make or receive calls, send or receive messages or use mobile data connections. To make sure your device works seamlessly when full 4G/LTE service is not available, it is recommended that you change the highest connection speed from 4G to 3G. To do this, on the home screen, tap Settings > Mobile networks, and switch Preferred network type to 2G/3G. For more info, contact your network service provider. Maximum transmit power GSM 850 GSM 900 DCS 1800 PCS 1900 WCDMA FDD I WCDMA FDD II WCDMA FDD IV WCDMA FDD V WCDMA FDD VIII LTE Band 1 LTE Band 2 LTE Band 3 LTE Band 4 LTE Band 5 LTE Band 7 LTE Band 8 LTE Band 20 LTE Band 28 LTE Band 38 LTE Band 40 LTE Band 41 Bluetooth WLAN 2.4 G WLAN 5 G NFC 32.5 dBm 32.5 dBm 30 dBm 30 dBm 24 dBm 24 dBm 24 dBm 24 dBm 24 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 23 dBm 10 dBm 18 dBm 16 dBm 420 mW Your device has an internal, non-removable rechargeable battery. Do not attempt to remove the battery, as you may damage the device. To replace the battery, take the device to the nearest authorised service facility. Charge your device with FC0300 (EU plug) / FC0301 (UK plug) /
FC0302 (US plug) / FC0303 (AUS plug) / FC0311 (India plug) / FC0304
(CN plug) charger, depending on the plug type of your country. HMD Global may make additional battery or charger models available for this device. Charging time can vary depending on device capability. Third-party chargers that comply with the applicable USB requirements, and that can connect to your device USB connector, may also be compatible. Some of the accessories mentioned in this user guide, such as charger, headset, or data cable, may be sold separately. Note: The device is restricted to indoor use only when operating in the 5150 to 5350 MHz frequency range in the following countries:The surface of the device is nickel-free. AT EE IT PT BE FI LV RO BG FR LT SK HR DE LU SI CY EL MT ES CZ HU NL SE DK IE PL UK Theoretical talk time: Up to 23.5 hours. Theoretical standby time: Up to 8.7 days (display off) Use only compatible memory cards approved for use with this device. Incompatible cards may damage the card and the device and corrupt data stored on the card. Note: Pre-installed system software and apps use a significant part of memory space. Keep a safe distance when using the flash. Do not use the flash on people or animals at close range. Do not cover the flash while taking a photo. Certification information
(SAR) This mobile device meets guidelines for exposure to radio waves as set forth by the Council of Europe (CE) and the Federal Communications Commission (FCC). Refer to the following. European RF Exposure Information Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organization ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health. The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit for mobile devices is 2.0 W/kg and the highest SAR value for this device when tested at the ear is 0.711 W/kg*. As mobile devices offer a range of functions, they can be used in other positions, such as on the body. In this case, the highest tested SAR value is 1.330 W/kg* at the separation distance of 0.5 cm from the body. For electronic safety, maintain the separation distance with accessories containing no metal, that position handset a minimum of the above distance. Use of other accessories may not ensure compliance with RF exposure guidelines.
*The tests are carried out in accordance with international guidelines for testing. FCC RF Exposure Information Your handset is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The guidelines are based on standards that were developed by independent scientific organization through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons, regardless of age and health. The exposure standard for wireless handsets employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/kg. The tests are performed in positions and locations (e.g. at the ear and worn on the body) as required by the FCC for each model. The highest SAR value for this model handset as reported to the FCC when tested for use at the ear is 1.09 W/kg, and when worn on the body in a holder or carry case, is 0.49 W/kg. Body-worn Operation; This device was tested for typical body-worn operations with the handset kept 1.5 cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 1.5 cm separation distance between the users body and the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. The FCC has granted an Equipment Authorization for this model handset with all reported SAR levels evaluated as in compliance with the FCC RF emission guidelines. SAR information on this model handset is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/ after searching on FCC ID 2AJOTTA-1012 and FCC ID 2AJOTTA-1004. Additional information on Specific Absorption Rates (SAR) can be found on the FCC website at www.fcc.gov/general/radio-frequency-
safety-0. To send data or messages, a good connection to the network is needed. Sending may be delayed until such a connection is available. Follow the separation distance instructions until the sending is finished. During general use, the SAR values are usually well below the values stated above. This is because, for purposes of system efficiency and to minimise interference on the network, the operating power of your mobile is automatically decreased when full power is not needed for the call. The lower the power output, the lower the SAR value. Device models may have different versions and more than one value. Component and design changes may occur over time and some changes could affect SAR values. For more info, go to www.sar-tick.com. Note that mobile devices may be transmitting even if you are not making a voice call. Your mobile device is also designed to meet the United States Federal Communications Commission (FCC) and Industry Canada SAR
(IC) guidelines. FCC ratings for your device and more information on SAR can be found at http://transition.fcc.gov/oet/rfsafety/
sar.html. Information on IC SAR can be found at http://www.ic.gc.ca. The World Health Organization (WHO) has stated that current scientific information does not indicate the need for any special precautions when using mobile devices. If you are interested in reducing your exposure, they recommend you limit your usage or use a hands-free kit to keep the device away from your head and body. For more information and explanations and discussions on RF exposure, go to the WHO website at www.who.int/peh-emf/en. This device has an electronic label for certification information. To access it, select Settings > About Phone > Certification. Electrical information of the device 2017 HMD Global. All rights reserved. HMD Global Oy is the exclusive licensee of the Nokia brand for phones & tablets. Nokia is a registered trademark of Nokia Corporation. Product Supplier Model Charger Mobile phone HMD Global TA-1004/DS, TA-1012/SS FC0302 The following electrical characteristics apply to HMD Global FC0302 chargers only:
Input Output 100-240 Vca, 50-60 Hz, 0-500 mA 5,0 Vcc 0-2500 mA 9,0 Vcc 0-2000 mA 12,0 Vcc 0-1500 mA Rechargeable battery supplier HMD Global Phone power consumption 3,8 mW Copyrights and other notices Declaration of Conformity Hereby, HMD Global Oy declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found at www.nokia.com/
mobile-declaration-of-conformity. FCC notice:
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For more info, go to www.fcc.gov/engineering-
technology/electromagnetic-compatibility-division/radio-
frequency-safety/faq/rf-safety. Any changes or modifications not expressly approved by HMD Global could void the users authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The list of importers in Mexico can be found in the Spanish version of this guide. Importer (this information applies only in Mexico):
Grand Cel S.A. de C.V. 106 Avenida Via Gustavo Baz, Int. 302 Colonia Cervecera Modelo Naucalpan de Jurez Edo de Mxico CP 53330 RFC: GCE1410146Y9 PEGASO PCS S.A. DE C.V Prolongacin Paseo de la Reforma No. 1200 Piso 14 Colonia Cruz Manca Delegacin Cuajimalpa de Morelos Mxico, Ciudad de Mexico C.P. 05349 RFC PPC980624U16 PARKTEL MEXICO, S.A. DE C.V. Leibnitz 185 Colonia Anzures 11590 CDMX RFC PME170503EK0 PACIFIC. COM. MX SA DE CV Versalles 63 Colonia Jurez Delegacin Cuauhtmoc CP 06600 Mxico DF. RFC PCM020219JQ6 Made in China Qualcomm and Snapdragon are trademarks of Qualcomm Incorporated, registered in the United States and other countries. ZEISS, the ZEISS logo, Tessar and T* are registered trademarks of Carl Zeiss AG used under license of Carl Zeiss Vision GmbH.