Outdoor IOT Gateway Installation Guide 1 WARNING:
MUST not install or remove GPS, LoRa or LTE Antenna when DC power is applied to the Gateway. It may damage the device. For un-connected N Type Antenna Port, MUST install a " N Type Connector Cap" to prevent water getting into the device. 2 Our mounting bracket design will be able to fix in two different locations, which is antenna pole and wall. Mounting bracket is also be able to fix in two direction, Vertical and Horizontal as well. Bracket fix in the gateway for first step 1. On Wall locking the expansion nail for bracket. (Maximum 40Kg.cm torque for M5 nuts.) 3 After locking the nuts, Reverse 3~4 turns nuts on wall. Hang on the IOT gateway then locking the nuts again. 4 2. On a Pole
(Maximum 55Kg.cm torque for hose clamp) Grounding Cable 5 Due to IoT Gateway has been certified with IP67 that SI can install with no any waterproof protection. But We still recommend that insert 3M 2166 waterproofing tape on antenna port could enhance reliability and prevent intentionally destroy in field. 6 3. DHCP Setup WARNING:
MUST not install or remove GPS, LoRa or LTE Antenna when DC power is applied to the Gateway. It may damage the device. DHCP setup with 2 x 1dBi LoRa Antenna (LoRa Antenna 1 is Optional) 7 4. Setup with High Gain (8dBi) LoRa Antenna 8dBi Antenna Antenna Mounting Accessory 8 Hardware Specification:
Item WiFi GPS Ethernet DC PWR Technical Information IEEE 802.11 b/g/n 2.4 GHz 1575.42 MHz 100/1000 Mbps Max 60W, POE 802.3af compliant Power Consumption 40W max Antenna IP Code UV Resistance 2 N-type external LoRA antenna 1 N-type external LTE antenna 1 N-type external active GPS antenna IP67 0.77 w/m2 @340nm Operation Temperature &Humidity
-20~70 , 20% ~90%
Dimension Weight Regulatory 269 184 85 mm 2.4 kg MAX FCC LoRaWAN 1.0 (GW2.1) Technical Information Frequency Band Tx/Rx Tx Power Rx Sensitivity @ SF12 Sectorization ADR Geo-localization RF Channel Scanning Higher grade SAW filter LoRa Channels Class A,B,C end-device Data Rate 902-928 MHz 26.85 dBm
-138 dBm Omni Yes Yes, GPS, GLONASS, BeiDou Yes Yes 8 Yes 980 bps to 21900 bps Improvement of coexistence with LTE Yes LTE modem LTE modem Band Available upon request Available upon request 9 Software Specification:
Item Backhaul Connection VPN Technical Information Ethernet / LTE / WiFi OpenVPN / Strongswan LoRa GW Application LoRa packet forward, uplink/downlink FW upgrade Link Monitor Configuration Preserved in Flash Remote Server side FW upgrade / Local GUI upgrade Healthy status report Backup & restore / dynamic & permanent setting
/ Reset to default Web/GUI Setup / Status report ThingPark LRR integration LoRa packet forwarding LoRa location without GPS (MCG022E) Use Differential Time of Arrival(DTOA) for location calculation Triangulation LBS Zero-touch provisioning IPSec (3DES,AES,SHA) P&P (Plug and Play) Transmission features Management and manageability Outdoor accuracy < 50M Yes Yes Yes L2 Yes 10 Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is Increase the separation between the equipment and receiver. connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. RF Modules installed in this product must not be co-located or operating in conjunction with any other antenna or transmitters, except when installed in accordance with FCC multi-transmitter product guidelines. Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. 11