Contact Information:
Website:www.glocalme.com Phone Number:+852 8191 2660 or +86 400 822 1581 E-mai:support@uCloudlink.com Facebook:GlocalMe HK GlocalMe International Twitter:@GlocalMeOnline WeChat:jkmwifi Address:Unit D.16F,Chenknang plaza 250 Hennessy Road,wanchai HongKong 1.Product Illustration 01:Proximity Sensor 02:Earpiece 03:LCD Touch Display 04:LED Indicator 05:Microphone 06:USB (Port)
(Indicator) Status:Red-Low Battery Yellow-Normal Green-High Battery 1.Product Illustration 4 |
Li 07:Speaker 08:Power Button 09:Volume + Button 10:Volume - Button 11:SIM Slot 1 12:SIM Slot 2 13:Micro USB(Input):Chargers with an output of SY== 1A are recommended 2.Operation Procedure fee Reig
(ot 1.Start up Press and hold the power button " for 3 seconds and enter the login-in interface after a proper start up . or select Advanced Mode as shown in Picture 1 to enter the Login interface 2.Operation Procedure 2.Register GlocalMe Please Login to enter the Login interface.Login with existing GlocalMe account 3. Introduction to Status Displayed 999.99MB ory a rene 01.Battery level 03.Remaining data 05.Charging mode(Plan & Non-plan) 07.Balance/Days to go of package 09.Application 11, Hotspot information cea 02.SIM card signal strength 04. WiFi hotspot name 06.Rate/Package name 08.Account information 10.Shop 4, Product Introduction Brand: GlocalMe Model: G2 Inside the box: GlocalMe G2, Quick start manual, Data cable. Technical Specifications
*LTE FDD: Band 1/3/5/7/8/17/20
*LTETOD: Band 39/40/41
*WCDMA: Band 1/2/5/8
*GSM: 1900/1800/900/850 MHZ
*HSUPA Max Uplink Speed:S5O0Mbps
*HSDPA Max Downlink Speed:150 Mbps internet Protocol: IEEE802.11b/gin
*Screen Size: 3.5 inch
*Standard USB 2.0 port
*Micro USB port
*Battery Capacity: 6000mAh
*input/Output: DC SV =1A 5.FAQ 1.How long does it take to be fully charged?
About 7.5 hours. 2.How long it can work continuously?
15 hours after a full charge. 3.How to change the Wi-Fi name and password?
Go to My Hotspot, make changes and save. 4.How to use it as a charger?
Discharging starts as the data cable is inserted to the standard USB port. 5.What to do if you lost your device?
Contact our customer service to freeze or suspend your account in order to protect your account balance on time. 6.How many devices can be connected to GlocalMe G2 at the same time?
5 devices. 7.How long does it take to connect to the internet after starting up?
Normally 1-2 minutes. It may take up to 10 minutes to start up for the first time in a country. 8.Why the device couldn't be started even with battery left?
Low battery maybe. Please charge again. 9.What to do if it crashes?
Press the power button for 15 seconds to restart it. For more information, please go to www.glocalme.com 6.Warning Specific Absorption Rate (SAR) information.SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value, in general, the closer you are to a wireless base station antenna, the lower the power output. Before a new device can be made available for sale to the public, it must be tested and certified by the FCC that it does not exceed the exposure limit established by the FCC, Tests for each device are performed in positions and locations as required by the FCC. For body worn operation, this device has been tested and meets the FCC RF exposure guidelines when used with an accessory designated for this product or when used with an accessory that contains no metal and that positions the device a minimum of 1.0 cm from the body. This device complies with part 15 of the FCC Rules. Operationis subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause. 6.Warning Undesired operation.Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment to an outlet on a different circuit to the receiver.
--Consult the dealer or an experienced radio/TV technician for help.