TWIST Wireless Earphones MODEL: MBH522 ee FCC INFORMATION:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is fo guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turing the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on the circuit different from that ta which the receiver is connected, Consult the dealer or an experienced radio/TV technician for help. FCC NOTICE:
To assure continued compliance, follow the attached installation instructions and use only shielded cables when connecting to other devices. Modifications not authorized by the manufacturer may void user's authority to operate this device. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. LOCATION OF CONTROLS 1.4% Button 2.0 Button 3.= Button 4.LED Indicators 5.Microphone 6.Rubber Cover 7.Micro USB Port (For Charging only) 2 The unit has a built-in Li-ion rechargeable battery, charge it before first timeuse or when itis drained as follows:
Open the Rubber Cover on the unit
. Connect the small plug from the supplied USB Connection Cable to the Micro USB Port Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port on the Personal Computer or USB Charger (Computer and USB Charger not included) When charging, the Red Charging Indicator on the small plug from the unit then close unit will illuminate. When charging is complete, the Red Indicator will tum off and the Blue Indicator will illuminate. After charging, disconnect the small plug from the unit then close the rubber Cover. NOTES:
Your battery will last longer if you following these simple guidelines for caring and storing:
A. Before first time use, recharge the unit approximately 4 hours until the unitis fully charged. 8. Charge and store the unit within the temperature range of 5C - 35C (40F - 95F). C. Do not overcharge (longer than 24 hours). Excessive charging or running the Unit until battery fully drains will damage battery. Battery life will be extended if you keop the battery fully charged D. Battery life naturally shortens slowly over time. E. The rechargeable battery incorporated in this product is not user replaceable. OPERATION BT(Bluetooth) Pairing:
For first time use or re-pairing the unit to. a new BT Device, paiting it as below:
1, Press and holding the Q Button on the unit approximately 6 seconds until the Red and Blue Indicators on the unit illuminate and blink. 2. Power on the external BT Device and enter to BT searching mode. Start pairing following the on screen instructions from the external BT Device. When paired, the Red LED Indicator will tum off and the Blue LED Indicator will become slow blinking. 3. If pairing is complete you may now play music and answer the phone with your external BT Device. 4. During playback:
Press the Q Button to pause: press again to resume normal playback.
@ Press and release the a or Buttons to adjust volume level as de:
@ Press and holding the a or = Buttons to skip tracks, 5. If the unit is paired to a Cell Phone and a calll is incoming during an active music session:
Press the Q Button then speak to the Microphone to answer the call. When your call is complete, press the Q Button to disconnect or end the call and resume to music playback. Or, press and holding the Q Button approximately 1 second to decline the incoming phone then resume to music playback. 6. To shut off the unil, press and holding the Q Button approximately 3 seconds until the Red and Blue Indicators is illuminate and blink then release the button. Notes:
When the extemal BT Device searched the unit, our model number MBH522 will appear on the display of external BT Device. if while pairing you are asked for a code please try "0000" or "1234", Normal operation after paired:
1. Power on the external BT Device and enter to BT mode. 2. Press and holding the Q Button on the unit approximately 1 second until the Blue Indicators on the unit illuminate and blink then release the button. 3. Wail a few seconds until the unit automatically pair to the BT Device. The Red LED Indicator will tum off and the Blue LED Indicator will become slow blinking. 4. If pairing is complete you may now play music and answer the phone with your extemal BT Device. Check the following before requesting service TROUBLESHOOTING SYMPTOM Can't power on POSSIBLE CAUSE Built-in batterydrained POSSIBLE SOLUTION Recharge the battery as page 3 No sound or sound weak BT not functioning Volume of the unit was set to minimum position Increase the volume by press the Button on the unit Volume level of paired device is in low level Volume level too high Rise the volume level of the paired device Reduce the volume level by press the Button on the unit Volume level of the paireddevice too high The external BT Device had NOT paired to the unit The external BT device too far from the unit Reduce the volume level of the paired device Pair the extemal BT Device to the unil as page 4 Place the extemal BT device close to the unit GENERAL SPECIFICATIONS:
Power source: ..... Built-in DC===3.7V, 60mAh (0.22 WH) rechargeable Li-ion Battery, Recharge by DC=== 5V through the Micro USB Port Impedance of the Earbuds 16 Q per Channel Audio power 5 mW per Channel (Total 10 mW) BT Operation Distance: 32 Feet in open area PACKAGE INCLUDES:
1 x Owner's Manual 1x USB Connection Cable (For Charging only) SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE ear ee Craig Electronics Inc. warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 180 days from date of purchase, If service is required, please return the product lo the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier's check or Money Order for $3 (to cover shipping and handling costs) payable to Craig Electronics Inc. For consumers in Canada, please make sure that the cashier check or money order is redeemable through a U.S. bank. Ship your product freight pre-paid. Your unit will be repaired, replaced or if the unit can not be repaired or replaced, a refund will be forwarded to you within four weeks of receipt of your unit. Please ship your unit to:
RF waming for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Craig Electronics Inc. 1160 NW 163 Drive Miami, Fl 33169 This warranty is void if the product has been: a) Used in @ commercial application or rental. b) Damaged through misuse, negligence, or abuse. c) Modified or repaired by anyone other than an authorized Craig Electronics Inc. service center. d) Damaged because it is improperly connected to any other equipment. Note: This warranty does nat cover: a) Ordinary adjustments as outlined in the Owner's Manual which can be performed by the customer. b) Damage to equipment not properly connected to the product. c) Any cost incurred in shipping the product for repair. d) Damage to the product not used in the USA This warranty is not transferable and anly applies to the original purchase. Any implied warranties, including the warranty of merchantability, are limited in duration to the period of this expressed warranty and no warranty whether expressed or implied shall apply to the product thereafter. Under no circumstance shall Craig Electronics Inc. be liable for any loss or consequential damage arising out of the use of this product. This warranty gives specific legal rights However, you may have other rights which may vary from state to state. Some states do not allow limitations on implied warranties or exclusion of consequential damage. Therefore, these restrictions may not apply to you. This product has been manufactured by and is sold under the responsibility of Craig Electronics Ine., and Craig Electronics Inc. is the warrantor in relation to this product. MAGNAVOX and SMART. VERY SMART are registered trademarks of Koninklike Philips N.V. and are used under license from Koninklijke Philips N.V. To Obtain Service on your Product emall:service@craigelectronics.com Printed in China MBH522_WC_E0GG1_BOUS