FCC ID: QISR226 Mobile WiFi

Safety Manual Vodafone Mobile Wi-Fi Read the Safety Information section of this safety manual below Do not use hand-held while driving Switch off in explosive environments Avoid contact with liquid, keep dry Do not use while re-fuelling Do not try and disassemble Small parts may cause a choking hazard For body-worn operation maintain antenna separation of 1.5 cm Do not rely on this device for emergency communications Keep away from pacemakers and other personal medical devices Do not dispose of in a fire Only use approved accessories Switch off when instructed in hospitals and medical facilities Avoid contact with magnetic media Switch off when instructed in aircrafts and airports Avoid Extreme Temperatures RF Exposure Your device contains a transmitter and a receiver. When it is ON, it receives and transmits RF energy. When your device is in use, the system handling your connection controls the power level at which your device transmits. Specific Absorption Rate (SAR) Your wireless device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organisation ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health. The guidelines use a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit for wireless devices is 2 watts/kilogram (W/kg) and the highest SAR value for this device when tested complied with this limit. Body worn operation Important safety information regarding radio frequency radiation

(RF) exposure To ensure compliance with RF exposure guidelines the device must be used with a minimum of 1.5 cm separation from the body. Failure to observe these instructions could result in your RF exposure exceeding the relevant guideline limits. CE Approval (European Union) The wireless device is approved to be used in the member states of the EU. The manufacturer declares that the wireless device is in compliance with the essential requirements and other relevant provisions of the Radio and Telecommunications Terminal Equipment Directive 1999/5/EC (R&TTE Directive). FCC Statement FCC Compliance (when US bands are supported) Federal Communications Commission Notice (United States):

Before a wireless device model is available for sale to the public, it must be tested and certified to the FCC that it does not exceed the limit established by the government-adopted requirement for safe exposure. The SAR limit for battery operated standalone wireless routers adopted by the USA is 1.6 watts/kilogram (W/kg) averaged over one gram of tissue. The highest SAR value reported to the FCC for this device type was compliant with this limit. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Caution: Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Distraction Driving Full attention must be given to driving at all times in order to reduce the risk of an accident. Using this device while driving causes distraction and can lead to an accident. You must comply with local laws and regulations restricting the use of wireless devices while driving. Operating machinery Full attention must be given to operating the machinery in order to reduce the risk of an accident. Product Handling You alone are responsible for how you use your device and any consequences of its use. You must always switch off your device wherever the use of a mobile phone is prohibited. If your device has clip-on covers, do not use it without the covers attached and do not remove or change them while using the device. Use of your device is subject to safety measures designed to protect users and their environment. Always treat your device and its accessories with care and keep it in a clean and dust-free place. Do not expose your device or its accessories to open flames or lit tobacco products. Faulty and Damaged Products Do not attempt to disassemble the device or its accessory. Only qualified personnel must service or repair the device or its accessory. If your device or its accessory has been submerged in water, punctured, or subjected to a severe fall, do not use it until you have taken it to be checked at an authorised service centre. Interference Care must be taken when using the device in close proximity to personal medical devices, such as pacemakers and hearing aids. Pacemakers Pacemaker manufacturers recommend that a minimum separation of 15 cm be maintained between a device and a pacemaker to avoid potential interference with the pacemaker. Hearing Aids People with hearing aids or other cochlear implants may experience interfering noises when using wireless devices or when one is nearby. The level of interference will depend on the type of hearing device and the distance from the interference source, increasing the separation between them may reduce the interference. You may also consult your hearing aid manufacturer to discuss alternatives. Medical devices Please consult your doctor and the device manufacturer to determine if operation of your device may interfere with the operation of your medical device. Hospitals Switch off your wireless device when requested to do so in hospitals, clinics or health care facilities. These requests are designed to prevent possible interference with sensitive medical equipment. Aircraft Switch off your wireless device whenever you are instructed to do so by airport or airline staff. Consult the airline staff about the use of wireless devices on board the aircraft. If your device offers a flight mode this must be enabled prior to boarding an aircraft. Interference in cars Please note that because of possible interference to electronic equipment, some vehicle manufacturers forbid the use of devices in their vehicles unless an external antenna is included in the installation. Explosive environments Petrol stations and explosive atmospheres In locations with potentially explosive atmospheres, obey all posted signs to turn off wireless devices such as your device or other radio equipment. Areas with potentially explosive atmospheres include fuelling areas, below decks on boats, fuel or chemical transfer or storage facilities, areas where the air contains chemicals or particles, such as grain, dust, or metal powders. Blasting Caps and Areas Turn off your device or wireless device when in a blasting area or in areas posted turn off two-way radios or electronic devices to avoid interfering with blasting operations. Do not expose your device or its accessories to liquid, moisture or high humidity. Do not drop, throw or try to bend your device or its accessories. Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its accessories. Do not paint your device or its accessories. Do not attempt to disassemble your device or its accessories:

only authorised personnel must do so. Do not expose your device or its accessories to extreme temperatures, minimum 5 and maximum +55 degrees Celsius. For optimal performance operate within a range of minimum 0 and maximum +35 degrees Celsius. Do not use your device in an enclosed environment or where heat dissipation is poor. Prolonged use in such space may cause excessive heat and raise ambient temperature, which will lead to automatic shutdown of your device or the disconnection of the mobile network connection for your safety. To use your device normally again after such shutdown, cool it in a well-ventilated place before turning it on. Please check local regulations for disposal of electronic products. Do not carry your device in your back pocket as it could break when you sit down. Do not operate the device where ventilation is restricted -

for example, do not operate inside a jacket pocket, inside a handbag or in any confined space. Small Children Do not leave your device and its accessories within the reach of small children or allow them to play with it. They could hurt themselves or others, or could accidentally damage the device. Your device contains small parts with sharp edges that may cause an injury or which could become detached and create a choking hazard. Air Bags Do not place this device in the area over an air bag or in the air bag deployment area. Store the device safely before driving your vehicle. Emergency Situations This device, like any wireless device, operates using radio signals, which cannot guarantee connection in all conditions. Therefore, you must never rely solely on any wireless device for emergency communications. Device Heating Your device may become warm during charging and during normal use. WEEE Approval The wireless device is approved to be used in the member states of the EU. The manufacturer declares that the wireless device is in compliance with the essential requirements and other relevant provisions of the Waste Electrical and Electronic Equipment Directive 2012/19/EU (WEEE Directive). Electrical Safety Accessories Only use approved accessories. Do not connect with incompatible products or accessories. Connection to a Car Seek professional advice when connecting a device interface to the vehicle electrical system. Mobile Wi-Fi PSI_0414_140x220_en-GB

Quickstart Guide Vodafone Mobile Wi-Fi R226 Welcome to the world of mobile communications 1 Welcome 2 Device overview 3 Getting started 5 Mobile Wi-Fi Web app 6 Web app overview 7 Current network panel 8 Mobile Wi-Fi Monitor app 9 Hints and tips 10 Glossary Welcome Licenses Notice Your Vodafone Mobile Wi-Fi creates a personal portable Wi-Fi network. Use it to share your secure mobile broadband internet connection with other Wi-Fi-enabled devices, such as computers, Apple iPhone, iPad or iPod touch, Android smartphones and tablets like the Samsung Galaxy Tab, or mobile gaming devices like Nintendo DSi. You can use battery, mains or USB to power your Vodafone Mobile Wi-Fi. This exibility makes it easy to position your Vodafone Mobile Wi-Fi to get the best mobile coverage. Your Vodafone Mobile Wi-Fi uses open source programs licensed under the GNU GPL

(Version 2.0), BSD (Version 3.0), OpenSSL, Zlib/libpng, LGPL and Apache License. You can download the source code free of charge from: http://vodafone.com/r226 for a period of three years from the distribution of this product. Copyright Huawei Technologies Co., Ltd. 2014. All Rights Reserved Your Vodafone Mobile Wi-Fi is made exclusively for Vodafone by Huawei. No part of this guide may be reproduced or transmitted in any form or by any means without prior written consent of Huawei. 1 Device overview 1 Tip:

To save power the display is dimmed after 18 seconds, and switches off after a further 6 seconds. The display can be switched on by briefly touching the poweron/off button. The display will also switch on whenever the status of the device changes. 2 1 2 3 4 5 Menu key Status display Test socket Micro USB socket Power on/off 2 4 5 3 Bearer Wi-Fi status and number of users Unread messages Network signal Battery Network signal:

Network operator or additional information Indicative cumulative upload & download data volume Connect duration Roaming indicator Connecting to network Excellent - not connected Excellent - connected Unable to connect Battery:

Fully charged Discharged Step 1 Insert your SIM and optionally a MicroSD card. Remove back cover Insert SIM Insert MicroSD card Replace back cover micro SIM micro S D micro SIM micro S D Step 2 Plug your Vodafone Mobile Wi-Fi into the mains* or your computer to charge it while you are using it. Getting started Tip:

Charge your Mobile Wi-Fi fully (mains: 3 hours) before using it in battery mode.

*Please only use the correct charger for your region HW-050200X3W, where x will be one of U, E, B, A, or J, depending on your region. For details about a specific charger, please contact your mobile network operator. 3 Getting started Step 3 Press and hold the power button for 3 seconds to switch on your Vodafone Mobile Wi-Fi. It will begin connecting to the mobile broadband network. Step 4 You may need to enter your PIN to unlock your SIM. Also, when your Vodafone Mobile Wi-Fi connects to the mobile network for the rst time, you may be asked to activate your SIM. Activation is not always necessary, so you may not see this. Step 5 On your computer or device, select your Vodafone Mobile Wi-Fi networks name

(its SSID) from the list of available networks, click Connect and enter the secure Wi-Fi network key (the WPA2 password). The name and key are on the back cover of your Vodafone Mobile Wi-Fi and also on a printed reminder card. Congratulations - you are connected to the internet via Vodafone Mobile Wi-Fi. 4 Mobile Wi-Fi Web app Tip:

Save the addresses for your Mobile Wi-Fi as favourites in your web browser. To check the status of your mobile broadband and Wi-Fi networks, manage SMS text messages or change the settings of your Mobile Wi-Fi, you can use the Vodafone Mobile Wi-Fi Web app:

Connect to your Vodafone Mobile Wi-Fi via Wi-Fi or with a USB cable If you installed your Vodafone Mobile Wi-Fi via USB, double-click the Vodafone Mobile Wi-Fi icon that was created on your desktop Alternatively - and particularly if you did not install via USB - open http://VodafoneMobile.wi or http://192.168.0.1 in your web browser. To use the Vodafone Mobile Wi-Fi Web app via a USB cable or via Wi-Fi, you need:

A computer with at least Windows XP An Apple Mac with at least OS X 10.6 Snow Leopard. SP3, or You can also manage your Vodafone Mobile Wi-Fi via its Wi-Fi network, but not via a USB cable, using:

8 RT, or Linux or Windows iPhone, iPad, iPod touch, or any other smartphone or tablet. 5 Web app overview 1 2 3 4 5 6 7 Navigation tabs: Select Mobile Wi-Fi, Storage, SMS or Account view Navigation bar: Select an area within each view Current network panel: Status of mobile broadband network, Wi-Fi network, battery and connected devices Content area: Content for current area Context help: Help for current area Language selection: Defaults to browser language Login/Logout: For advanced settings. The default password is admin. 1 6 7 3 2 4 5 6 Current network panel The Current network panel appears on the right-hand side of every view in the Mobile Wi-Fi Web app, giving you a quick summary of the status of your Mobile Wi-Fi. Below it are additional panels for battery, Wi-Fi and the status of other devices sharing your Wi-Fi network. 7 Mobile Wi-Fi Monitor app If you have an Apple iOS or Android device, you can also check the status of your Mobile Wi-Fi using the Vodafone Mobile Wi-Fi Monitor app. Download the app from the iTunes or Google Play app stores. iPad / tablet iPhone / smartphone 8 Hints and tips Wi-Fi security Please ensure that the Wi-Fi security settings meet your personal requirements. To change the admin password, open the Vodafone Mobile Wi-Fi Web app:

Enter admin into the Password eld and click Login Select Router on the Navigation bar Select Router Settings from the left-hand Menu bar. To change your Wi-Fi network name (SSID) and the key:

Select Wi-Fi on the Navigation bar Select Security from the left-hand Menu bar. Further Support Select Help on the Navigation bar in the Vodafone Mobile Wi-Fi Web app Select Support from the left-hand Menu. The Content area will show how to contact your mobile network operator. For a full user guide including further hints and tips, visit:

http://vodafone.com/r226 9 Glossary Bearer Communication method used for data transport over the mobile network, eg. 3G Broadband, HSPA, 3G, etc. Home network The network of the mobile operator who provided your SIM. Roaming You can use your mobile device on any other mobile network that has a roaming agreement with your operator, whether in your country or abroad. SIM Your Subscriber Identity Module is the small plastic chip that you will have received together with your mobile contract. Your SIM has gold contacts on one side. WPA2 An alternative name for the Wi-Fi network key. On Macs with OS X this is called WPA2 personal. 10 Notes 11 Notes 12 The term Mobile Broadband together with the birds design is a trademark of GSMC Limited. Vodafone 2014. Vodafone and the Vodafone logos are trade marks of the Vodafone Group. Any product or company names mentioned herein may be the trade marks of their respective owners. R226 Mobile Wi Fi QSG 05/14_en_GB