FCC ID: QISAF15 Tripod Selfie Stick

Tripod Sele Stick

(Wireless Version) Quick Start Guide Connecting to your phone 1 2 Press and hold the camera button on the sele stick for 2 seconds to enter Bluetooth pairing mode. Enable Bluetooth on your phone search for available devices. Select AF15. If the sele stick successfully pairs with your phone, the green indicator will be on for 3 seconds and off. English Camera button 1 English Using the sele stick 1 Expand the sele stick. 2

(Optional) Open the tripod at the bottom, push the pole upwards, and place the tripod on a horizontal level surface. 2 3 Attach your phone on the sele stick. English 4 Set the volume button on your phone to act as the shutter button. Use the remote control to take a photo. 3 English Replacing the remote control battery Remove the Bluetooth remote control from the tripod. Push against the battery cover in the direction shown by the arrow and replace the battery. 1 2 4 3 Powering off the sele stick Press and hold the camera button on the sele stick for 3 seconds until the green indicator light turns off. English Note:

If you do not use the remote control for 3 minutes, it will automatically enter sleep mode and disconnect from your phone. The remote control will be powered off if you do not use it for 6 hours. The Bluetooth range for the remote control is 10 meters. When your are using the sele stick, the red indicator of the sele stick will blink if the battery level is lower than 20%. Please replace the battery in time. 5 The statements should be displayed in the user manual:

changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help 6 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 7

1 Photographs - EUT Constructional Details Test model No.: AF15

1 Photographs - EUT Constructional Details Test model No.: AF15 This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspx and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Companys findings at the time of its intervention only and within the limits of Clients instructions, if any. The Companys sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only. This document is issued by the Company subject to its General Conditions of Service printed overleaf, available on request or accessible at http://www.sgs.com/en/Terms-and-Conditions.aspx and, for electronic format documents, subject to Terms and Conditions for Electronic Documents at http://www.sgs.com/en/Terms-and-Conditions/Terms-e-Document.aspx. Attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined therein. Any holder of this document is advised that information contained hereon reflects the Companys findings at the time of its intervention only and within the limits of Clients instructions, if any. The Companys sole responsibility is to its Client and this document does not exonerate parties to a transaction from exercising all their rights and obligations under the transaction documents. This document cannot be reproduced except in full, without prior written approval of the Company. Any unauthorized alteration, forgery or falsification of the content or appearance of this document is unlawful and offenders may be prosecuted to the fullest extent of the law. Unless otherwise stated the results shown in this test report refer only to the sample(s) tested and such sample(s) are retained for 30 days only.

FCC ID:QISAF15 FCC ID:QISAF15 15mm FCC ID:QISAF15 2.7mm

Huawei Technologies Co.,Ltd. QISAF15 Request for Confidentiality Federal Communications Commission 2017-03-01 Oakland Mills Road Columbia MD 21046 Subject:

FCC ID:

To Whom It May Concern:

Pursuant to the provisions of Sections 0.457 and 0.459 of the Commissions rules (47 CFR 0.457, 0.459), we are requesting the Commission to withhold the following attachments as confidential document from public disclosure indefinitely. Schematic Diagram Block Diagram Operational Description Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market.

*****************************************************************************

Additionally, the applicant requests the following documents be held confidential until the device is marketed or 180 days from the grant date, whichever is less. If the device is marketed within 180 days of the Grant Date, the applicant will notify the TCB per FCC KDB 726920 D01 Confidentiality Request Procedures. External Photos Internal Photos Test Setup Photos User Manual

******************************************************************************

It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. Best Regards Zhang Xinghai 18_Confidentiality Letter V1.0 EMC Laboratory Manager Huawei Technologies Co., Ltd. E-mail: zhangxinghai@huawei.com Tel: 0086-0755-28970299 Fax: 0086-0755-89650226 18_Confidentiality Letter V1.0

Huawei Technologies Co.,Ltd. Federal Communications Commission 2017-02-27 Oakland Mills Road Columbia MD 21046 Letter of Authorization To whom it may concern:

We the undersigned, hereby authorize SGS-CSTC Standards Technical Services Co., Ltd. (SGS) Shenzhen Branch and Sade Luo in SGS-CSTC Standards Technical Services Co., Ltd. (SGS) Shenzhen Branch to act on our behalf in all manners relating to application for equipment authorization, including signing of all documents relating to these matters. Any and all acts carried out by the agent on our behalf shall have the same affect as acts of our own. I, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from Huawei Technologies Co., Ltd. Sincerely, For and Behalf of:

Huawei Technologies Co., Ltd. Zhang Xinghai EMC Laboratory Manager E-mail: zhangxinghai@huawei.com Tel: 0086-0755-28970299 Fax: 0086-0755-89650226 20_Authorization Letter V1.0