The product name is Bluetooth voice remote control model name is RC-48 Product description:
instructions device nameRC-48 BACK ] key] and [
Press and hold the [
HOME] key on the remote control at the same time for about 3 seconds to work the indicator flashing, indicating that you have entered pairing mode. Turn on Host Bluetooth - click host Bluetooth - Search for devices - Connect to the "RC-48" device name and connect. If pairing is successful, the red light of the remote control stays on for 3 seconds; if pairing fails after 30 seconds, the red dot goes out Equipment. power alarm When the battery power is lower than 2.2V, Every time the user presses a key, Press any key, the red light flflashes for 3 s , and the frequency is 1 Hz Back connection When there is pairing information, press any key to send the corresponding infrared code and send the backlink broadcast for 5s(the POWER key and the combination key do not send the backlink broadcast). The reconnection was successful and the indicator light went out. The remote control and the projector should remain connected at 4m for at least 2 hours without any disconnection. The remote control and the projector should remain connected for at least 1 hour at a distance of 6 meters without any disconnection. 4. sleep and wake up Bluetooth sleep mode: The Bluetooth sleep time is 1 hour. When Bluetooth is in sleep mode, the function is normal: When operating the remote control in Bluetooth sleep mode, the first key press can normally respond to the infrared function, and the second key press can normally respond to the Bluetooth function. OTA When the TV is turned on, the upgrade fifile of the remote controller is detected. If the upgrade fifile exists, the remote controller performs OTA upgrade, and the LED lamp flflashes. At this time, the remote controller can't be used, and any buttons don't respond. After the upgrade is successful, the LED light stops flflashing, and the remote controller can be used normally at this time. If the upgrade fails, it will be detected and upgraded again at the next boot. After OTA fails, the LED light stops flflashing, and the remote controller returns to the old version for normal operation. 6.Blue tooth remote control PID/VID vendor:0x0B7A.product:0x0001 reasonable frequency harmful FCC Warnning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide protection againstharmful interference in a residential installation. This equipment generates, with energy uses and can radiateradio and, maycause interference the there thatinterference occur is equipment cause determined by turning the equipmentoff interference Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is harmfulinterference to radio or television reception, which can be user in communications. installation. instructions, guarantee does accordance However, this If thefollowing measures:
radio a encouraged if to in particular installed correct more used one and and will not not the on, the try no by or to to of is connected. Consult the dealer or an experienced radio/TV technician for help. Any Caution:
could void your authority to operate this equipment. modications changes this or to device not explicitly approved by manufacturer 15 part with complies device This conditions:
(1)This interference received, including interference that may cause undesired operation. interference, Operation harmful subject device device Rules. cause may and FCC this not the
(2) to of is the following two must accept any complies equipment FCC This environment. should between the radiator and your body. equipment with This radiation be installed exposure and limits operated set with forth for an minimum uncontrolled 0cm distance
