Client: Hunter Engineering Company Model: 45-1637 Standards: FCC 15.249/IC RSS-210 IDs: LS3-45-1637/2938A-451637 Report #: 2017285 Rhein Tech Laboratories, Inc. 360 Herndon Parkway Suite 1400 Herndon, VA 20170 http://www.rheintech.com Appendix K: Manual Please refer to the following page. Page 27 of 35 This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment. RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. Tread DepthTool: 221-731-1 Contains FCC ID: LS3-45-1443 IC: 2938A-451443 Model: 45-1443
-OR-
Model 45-1637 IC: 2938A-451637 Contains FCC ID: LS3-45-1637 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes: (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Specific Precautions/Power Source North America The PC aligner is intended to operate from a power source that will apply 120 VAC (nominal) 50/60 Hz between the supply conductors of the power cordset. Other Regions The PC aligner is intended to operate from a power source that will apply 230 VAC (nominal) 50/60 Hz between the supply conductors of the power cordset. The power supply cordset, supplied with this equipment, may need modification to allow connection to the power supply mains. Your Hunter service representative will install the proper plug for your location. A protective ground connection, through the grounding conductor in the power cord, is essential for safe operation. Use only a power cord that is in good condition. FUSING:
To avoid fire hazard, use only the fuse specified for your product. EQUIPMENT SERVICE:
This equipment contains no user serviceable parts. All repairs must be referred to a qualified Hunter Service Representative. PROVISIONS FOR LIFTING AND CARRYING:
No provision has been made for lifting or carrying this equipment. The unit must be moved by rolling it on its casters. Equipment Specifications Electrical VOLTAGE:
AMPERAGE:
WATTAGE:
120/230 volts (nominal) 6/3 amps 720 watts Atmospherics TEMPERATURE:
RELATIVE HUMIDITY:
ALTITUDE:
+32F to +122F (0C to +50C) Up to 95% Non-condensing Up to 10,000 ft. (3048 m) Explanation of Symbols These symbols appear on the equipment. 18 GETTING STARTED