Smart Sensor 1loop-1.0 1.Press and hold the power button for 1.5 seconds,the middle green LED light in on, it means turned on successfully. 2.Turn on the bluetooth and APP, select my device, and connect the right sensor, then selectStart, and after overing the workout, selectEnd Exercise. 3.Charging the sensor by USB charge cable(power voltage 5V 1A). The middle LED shows different colors which represent as following battery power rate: Red: 0-20%;Orange: 20-50%; Green:
more than 50%.(Note: charging voltage need to stable.) After the sensor is disconnected from charging, connect to APP to check the power percentage. It takes about 1 hour from 0 battery to 100% full. 4.Different color LED lights means different range of tension values, as follow:
1 green LEDs: 0.5-5kgs 2 green LEDs: 5-15kgs 3 orange LEDs: 15-30kgs 4 orange LEDs: 30-45kgs 5 red LEDs: 45kgs 5. Usage for reference:
6.Warning: Children under 5 years old are not recommended to play. If you want to use, please use it under adult guidance. FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.