TRANSMITTER E1201C ANSLUTA USER INSTRUCTION A. Features 1. Easy and simple to use. 2. Blinking blue LED indicates signal transmission status. B. Diagram & Descriptions ii i No. Description i ii Function The indicator blinks to indicate signal transmission status. indicator 1 OFF1 ON Switch on and off the appliances connected to channel 1 receiver E1201 C. Operation 1. Configure Press theON/OFF Learning Code button on the receiver until the LED Indicator blinks. Then press any one of the four OFF buttons until the red LED Indicator goes off. The receiver is trained to respond to the corresponding channel. 2. Control
: 2X AAA
: 20 meters max. (in the open air) Press the ON or OFF button to switch on or off the appliance connected to the receiver trained to the corresponding channel. D. Specifications 1. Battery 2. Frequency : 433.92 MHz 3. Distance E. Holder IKEA of Sweden, AB Manufactory: Everflourish Electrical Co., Ltd. Adress:Renjiu Village, Wuxiang Town, Yinzhou Ningbo 315111 P.R. China This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication. Conformment la rglementation d'Industrie Canada, le prsent metteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou infrieur) approuv pour l'metteur par Industrie Canada. Dans le but de rduire les risques de brouillage radiolectrique l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonne quivalente
(p.i.r.e.) ne dpasse pas l'intensit ncessaire l'tablissement d'une communication satisfaisante.