Wireless 360 Speaker User Guide Please read these instructions completely before operating this product TDKperformance.com A360 Wireless 360 Speaker Guide d'utilisation Veuillez lire l'ensemble des instructions ci-dessous avant d'utiliser ce produit. TDKperformance.com A360 AC CONNECTION/RECHARGING THE BATTERY OPERATION 1. Select the appropriate plug for your country and connect it to the AC power adapter. Turning the A360 On and Off:
1. For AC operation: Press the Power/Volume control u on the main unit to turn the power on. 2. For DC operation: Slide the Battery switch al to the ON position. Press the Power/Volume control u; the unit will turn on the previous source and volume. 3. To turn the power off, press the Power/Volume control u. 2. Connect the AC power adapter jack to the DC IN jack X on the rear of the unit and then connect the plug to a 100V-240V wall outlet. This unit has a built-in rechargeable battery that will automatically be charged as long as the unit is plugged in. If the battery is low, the Battery indicator v will turn on. The Battery indicator will blink red when low. It will be solid red when charging. Note: The battery will provide approximately 6 hours of operation at normal listening level. Notes:
Only use the supplied AC adapter. Remove both the DC plug and AC-IN plug to disconnect AC adapter when not in use. Disconnect the AC cord to use with DC power (rechargeable battery). Replacing the Rechargeable Battery:
If the battery does not supply enough power (see Rechargeable Battery Notes below), order a replacement battery at www.tdkperformance.com and remove the four screws on the left side of the unit. Disconnect the connector and remove the battery. Then connect the new battery and reinsert the four screws. Rechargeable Battery Notes:
Each time you charge and discharge the battery (charge cycles), battery capacity slightly diminishes. Rechargeable batteries have a limited number of charge cycles and need to be replaced eventually. You may wish to replace your battery when, or before, the battery does not supply enough power to function your device. Also, proper disposal is essential from environmental and safety point of view. Putting any battery directly in the trash will harm the environment. Do not incinerate. LOCATION OF CONTROLS 3 4 5 6 7 11 12 1 2 8 9 10 1. Power/Volume Control 2. Low Battery Indicator 3. Carrying Handle 4. Bluetooth and Aux Source Indicators 5. Treble/Bass Button 6. Treble/Bass Indicators 7. Source/Select Button 8. USB Charge Jack 9. DC IN Jack 10. Rubber Flap 11. AUX Jack 12. Battery OFF/ON Switch Pairing a Bluetooth Device 1. Turn the A360 on; the LED(s) around the Power/Volume control will light and the previously listened to source and volume will be selected. 2. Press and hold the Source/Select button V until the Bluetooth indicator blinks rapidly to make the A360 discoverable. 3. On the Bluetooth device, enable Bluetooth and select A360 from the Device List. If the Bluetooth device asks for a passkey, use 0000. Some Bluetooth devices will ask you to accept the connection. If the units are paired properly, the speaker will beep and the Bluetooth indicator will light solid blue. If it failed, the Bluetooth indicator will blink slowly. IMPORTANT: After step 3, you have two minutes to pair the units. Note: After you pair a device, the A360 will remember it for future use. Using a Bluetooth Device 1. Turn the A360 on; the LED(s) around the Power/Volume control will light and the previously listened to source and volume will be selected 2. With a unit paired (see previous section), press the Source/Select button V so the Bluetooth indicator lights. 3. Operate your Bluetooth device and its sound will be heard through the A360s speakers. 4. Adjust the volume by rotating the Power/Volume control u on the A360, or the Volume control on the Bluetooth device, and adjust the Bass and Treble as described later in this guide. AUX Jack (Rear of A360) 1. Insert one end of an audio cable (not included) into the LINE OUT or Headphone jack on your external audio unit and the other end into the AUX jack ak on the rear of the A360, under the flap. 2. To listen to the external audio unit, turn the A360 on and press the Source/Select button V once so the AUX indicator lights to select the Line In mode. 3. Start playback of the external unit and the external audio units output sound will be heard through the A360s speakers. 4. Adjust the volume using the Power/Volume control u on the A360, or the Volume control on the Bluetooth device, and adjust the Bass and Treble as described later in this guide. Charging a USB Device with the A360s USB Jack Connect your device via USB to the USB jack W on the A360. Your device will charge when the A360 is connected to AC power. Your device will also charge during operation in DC mode if Battery OFF/ON switch al is ON. Note: USB charging will significantly reduce battery life in DC mode. Setting the Treble and Bass 1. TREBLE: Press the Treble/Bass button y until the Treble Indicator lights. Adjust the setting using the Power/Volume control u. Power/Volume control u. 2. BASS: Press the Treble/Bass button y until the Bass Indicator lights. Adjust the setting using the Note: After five seconds, the unit will save the Bass/Treble settings and revert to Volume selection mode. Auto Power Off If the unit has no audio signal or a USB device is not charging, for 20 minutes, the unit will turn itself off. To wake the unit up, simply press the Power/Volume control u. Splash Resistant The A360 is splash resistant, but cannot be submerged in water or be subject to constant flow of water. In order to ensure the product is splash resistant, close the rubber flap on the rear of the A360. To properly close flap, fully insert center rubber dongle (on inside of flap at) into the DC IN jack X until flap center is flush. Insert the other dongle into USB jack W, then smooth out entire flap until flap is flush with the sides of the A360. Troubleshooting If the A360 is not producing sound, adjust the volume level on your digital music device to high. SPECIFICATIONS AND COMPATIBILITY GENERAL:
Power Source (AC) ............. Input: 100-240V AC, 50/60Hz,
........................................ 1.2 A max, Output: 19 V DC, 2A Dimensions ........................... 6 (W) x 6 (H) x 6 (D) inches
................................... 15.2 (W) x 15.2 (H) x 15.2 (D) cm Weight ...................................................... 4.4 lbs / 2.0 kg Speakers ............................... 4 x 1 inch full-range drivers,
..............................................................4 inch subwoofer Speaker Power Output .......... 2 W x 4 + 15 W (subwoofer) Wireless Audio .............................. Bluetooth version 2.1,
.................................................. A2DP profile, AAC Codec Line-input Audio .........................3.5 mm stereo jack up to
....................................................... 2.5 Vrms input signal USB Port. ................................ 5.0 V @ 0.5 A charge only Specifications are subject to change without notice. The TDK Life on Record Logo is a trademark of TDK Corporation and is used under license. All other trademarks and logos are property of their respective owners. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Imation Corp is under license. 36953002A Wireless 360 Speaker User Guide Please read these instructions completely before operating this product TDKperformance.com A360 Wireless 360 Speaker Guide d'utilisation Veuillez lire l'ensemble des instructions ci-dessous avant d'utiliser ce produit. TDKperformance.com A360 CE Declaration of Conformity Declaracin de Conformidad de CE We, Imation Corp., 1 Imation Way, Oakdale, MN 55125 USA, declare that the product(s):
Product Name: Wireless 360 Speaker Product Model(s): A360 in accordance with EMC Directive 2004/108/EC, per the following norm(s) or document(s):
Regulations EN 55013: 2001 + A1:2003 + A2:2006 EN 55020: 2007 + A11:2011 EN 61000-3-2:2006 + A2:2009 EN 61000-3-3:2008 in accordance with the R&TTE Directive 1999/5/EC, per the following norm(s) or document(s):
Regulations EN 300 328 v1.8.1:2012 EN 301-489-1 v1.9.2:2011 EN 301-489-17 v2.2.1:2012 EN 62479:2010 in accordance with the Low Voltage Directive 2006/95/EC, per the following norm(s) or document(s):
Regulations EN 60065, IEC 60065 in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC, per the following norm(s) or document(s):
Regulations EC No. 1275/2008, EN62301 in accordance with the Restriction of Certain Hazardous Substances Directive 2011/65/EU, per the following norm(s) or document(s):
Regulations EN 62321:2008 CK Wong Quality Engineering Manager, Compliance Engineering Imation Corp., Oakdale, MN 55128 USA 15 July 2013 TO BE TRANS-
LATED INTO SPANISH We, Imation Corp., 1 Imation Way, Oakdale, MN 55125 USA, declare that the product(s):
Product Name: Wireless 360 Speaker Product Model(s): A360 in accordance with EMC Directive 2004/108/EC, per the following norm(s) or document(s):
Regulations EN 55013: 2001 + A1:2003 + A2:2006 EN 55020: 2007 + A11:2011 EN 61000-3-2:2006 + A2:2009 EN 61000-3-3:2008 in accordance with the R&TTE Directive 1999/5/
EC, per the following norm(s) or document(s):
Regulations EN 300 328 v1.8.1:2012 EN 301-489-1 v1.9.2:2011 EN 301-489-17 v2.2.1:2012 EN 62479:2010 in accordance with the Low Voltage Directive 2006/95/EC, per the following norm(s) or document(s):
Regulations EN 60065, IEC 60065 in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/
EC, per the following norm(s) or document(s):
Regulations EC No. 1275/2008, EN62301 in accordance with the Restriction of Certain Hazardous Substances Directive 2011/65/EU, per the following norm(s) or document(s):
Regulations EN 62321:2008 CK Wong Imation Enterprises Corp. 1 Imation Way, Oakdale, MN 55128-3414 USA www.tdkperformance.com Imation Europe B.V. Planeetbaan 4 2132 HZ Hoofddorp The Netherlands www.tdkperformance.eu Imation Singapore Pte. Ltd. Unit 02-02 New Tech Park 151 Lorong Chuan Singapore 556741 www.tdkperformance.com Imation ANZ Pty Ltd Unit 2, 1 Coronation Avenue Kings Park, NSW 2148 www.tdkperformance.com.au 13251202 www.tdk-media.com.cn 6427 www.tdk-media.com.hk Technical Assistance / Assistance technique / Technische Hilfe / Technische assistentie /
Assistenza tecnica / Asistencia tcnica / Assistncia tcnica / /
Pomoc techniczna / Technick pomoc / /
/ /
US ......................................................................................................................800-285-2783 DE/AT/CH .....................................................................................................+49 2131 226 311 IT .................................................................................................................+39 022 1043 818 ES/PT .............................................................................................................+34 900 993 166 UK/IE ....................................................................................................... +44 (0) 1344 402201 NL/Other EU ............................................................................................. +31 (0) 23 521 2605 SG ......................................................................................................................65-6499-7199 AU/NZ ...................................................................................................................800-225-013 JP .......................................................................................................................0120-81-0544 CN ..................................................................................................................8621-6121-2122
..............................................................................................................02-2012-9999 HK .....................................................................................................................852-2161-2888