FCC ID: 2AIZN-YYS-X6836 Mobile Phone

Infinix HOT 40 X6836 User Manual(F&I) Explosion diagram specification FL(CTP+LCM) F HSG ASM F CAM 32M REC PCBA MB FP FPC MYLAR PS RUBBER 1 3 5 7 9 11 13 15 MAIN WATERPROOF FRAME 17 19 21 23 25 27 29 31 33 35 37 MOTOR LINEA R CAM CON FOAM R CAM CON FABRIC 8W SCREW L3.5 R CAM DECO PC R FLASH DECO R CAM LENS 50M R CAM LENS 8W EARPHONE RUBBER R CAM FRAME 2M PCBA SUB REC DECO R CAM 50M R CAM 2M R CAM 8W COAXIAL CABLE SIM CARD HOLDER PCBA COPPER A PCBA GRAPHITE FILM 2 4 6 8 10 12 14 16 18 MAIN WATERPROOF MYLAR 20 MI HOUSING 22 24 26 28 30 32 34 36 38 BAT COVER ASM R CAM DECO PMMA R CAM RUBBER 8W R CAM LENS 2M SCREW L2.0 USB RUBBER PCBA COPPER C PCBA COPPER B SPK 1 39 41 BATTERY SIDE FP FPC SIDE KEY 40 42 MAIN FPCA Know your phone 1. Front camera 2. Volume + key 3. Volume - key 4. Power key & side fingerprint sensor 5. NFC 2 SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation. 2 Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). Use only INFINIX charger and cables. Other chargers or cables may damage the device. This will invalidate your phone warranty. 3 FCC Caution Labelling requirements. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. interference in a residential Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. 4 Specific Absorption Rate (SAR) information:

This mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA

(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types:

X6836 (FCC ID: 2AIZN-X6836) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 1.00W/kg and when properly worn on the body is 0.55 W/kg. Body-worn Operation This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 1.0 cm must be maintained between the users body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. 5 For DTS patents, see http://patents.dts.com. Manufactured under license from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol together are registered trademarks or trademarks of DTS, Inc. in the United States and/or other countries. DTS, Inc. All Rights Reserved. Operating SystemAndroidTM Android is a trademark of Google LLC. 6

Int UHI IMEI:

IMEI:

VC:x 251 DIN:X FINIXx LTT XXXXAXXXXXXAX XXXXXXXXXXXX XXXXX 6+8 J | FCC Il ae q te XXX MAD El: :00000000000000K 22 XXXXXX 256+8J_} FCC ID:2AlZ i) ue

N:XXXX MADE IN X6831 XXX XXX

):2AIZN-YYS-X E IN CHINA LZ N-YYS-X6836 CHINA ie

IMEI: XxxXXXXXXXXXXXX Ol par ic]

(6836 256+8 J ber Starlit Black Ela) SETCTER ATT TESTA 7 X6836 25648 J ae) Color: Starlit Black fm |

IMEI: xxxXXXXXXXXXXXX rT

Ap N n pplication NFC Name and antenna m address of t manufacture the er Model numbe M Type of Freq er of the ant tenna a the antenna quency Ant Dim tenna:

mensions(unit:

: mm) Huizhou S SPEED Wir reless Techn nology Co., Ltd. No. SX-01-

Tech Zone

-02, Shangx e, Huizhou SPD-X Dongjiang xia District, City, Guang gdong Prov C X6836-NFC g High-

vince FPC

.56MHz 13

INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong Tel.: +86-0755-61803856 Fax:755-33979211 E-mail: jerry.liu@infinixmobility.com FCC Authorization Date: 2023-10-25 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Agent Authorization To whom it may concern:

We, INFINIX MOBILITY LIMITED hereby authorizes China Certification ICT Co., Ltd

(Dongguan) to act on its behalf in all matters relating to application for Equipment authorization, including the signing of all documents relating to these matters. All acts carried out by China Certification ICT Co., Ltd (Dongguan) on our behalf shall have the same effect as our own action. We, the undersigned, hereby certify that we are not subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. This authorization is valid until further written notice from the applicant. Sincerely Yours, Signature Jerry Liu Certified Engineer QA-FR-170-B

INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong Tel.: +86-0755-61803856 Fax:755-33979211 E-mail: jerry.liu@infinixmobility.com Date: 2023-10-25 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Dear Sir/Madam, The Main chip, model: MT6769V installed in our product Mobile Phone, model: X6836, FCC ID: 2AIZN-YYS-X6836), this chip supports LTE function, but for marketing purpose, this chip only supports LTE B2/B4/B5/B7/B12/B13/B17/B25/B26/B38/B40(Lower:

2305-2315MHz; Upper: 2350-2360MHz)/B41/B66, not support other LTE bands. The other LTE bands was disabled to use by manufacture in the software, the end user has no capability to activate it. The RF chip, model: MT6631N installed in our product Mobile Phone, model: X6836, FCC ID: 2AIZN-YYS-X6836, supports 5G Wi-Fi function, but for marketing purpose, this chip only supports 5G Wi-Fi(5150-5250 MHz; 5725-5850 MHz). The 5G Wi-Fi

(5250-5350 MHz, 5470-5725 MHz) was disabled to use by manufacture in the software and for BLE 2M, only supports 2404-2478MHz, the 2402MHz and 2480MHz was also disabled. The end user has no capability to activate it. Sincerely Yours, Signature Jerry Liu Certified Engineer

INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong Tel.: +86-0755-61803856 Fax:755-33979211 E-mail: jerry.liu@infinixmobility.com Attestation Letter Date: 2023-10-25 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(i) Filing FCC ID: 2AIZN-YYS-X6836 INFINIX MOBILITY LIMITED certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely Yours, Signature Jerry Liu Certified Engineer INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong CFR 47 2.911(d)(5)(i) Attestation Letter

INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong Tel.: +86-0755-61803856 Fax:755-33979211 E-mail: jerry.liu@infinixmobility.com Attestation Letter Date: 2023-10-26 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(5)(ii) Filing FCC ID: 2AIZN-YYS-X6836 INFINIX MOBILITY LIMITED certifies that as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely Yours, Signature Jerry Liu Certified Engineer INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong CFR 47 2.911 (d)(5)(ii) Attestation Letter

INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT, Hong Kong Tel.: +86-0755-61803856 Fax:755-33979211 E-mail: jerry.liu@infinixmobility.com FCC Confidential Authorization Date: 2023-10-25 FEDERAL COMMUNICATIONS COMMISSIONS Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Confidentiality Request regarding application for certification of FCC ID: 2AIZN-YYS-X6836 In accordance with Sections 0.457 and 0.459 of the Commissions Rules, INFINIX MOBILITY LIMITED hereby requests long-term confidential treatment of information accompanying this application as outlined below:

Block Diagram Schematics Operation Description Part list/Tune up Procedure (for licensed device) Software Security Description As well as short-term confidential treatment of information accompanying this application for a period of 180 days after grant is issued as outlined below:

Internal Photos Users Manual External Photos Test Set-up Photos The above materials contain proprietary and confidential information not customarily released to the public. The public disclosure of these materials provides unjustified benefits to its competitors in the market. Sincerely Yours, Signature Jerry Liu Certified Engineer

U.S. AGENT LETTER OF ATTESTATION Date: 2023-10-24 FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements CFR 47 2.911(d)(7) Filing FCC ID: 2AIZN-YYS-X6836 INFINIX MOBILITY LIMITED certifies that, as of the date of the filing of the application, Iconsigh Inc. is our designated U.S. agent for service of process for the above referenced FCC ID. INFINIX MOBILITY LIMITED accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Iconsigh Inc. accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced FCC ID. Designated U.S. Agent Information:

Company Name: Iconsigh Inc. Address: 2310 Homestead Road, Suite C1, Los Altos, CA, 94024, USA FRN: 0033398652 Tel.: +1 (408) 320-9867 Email: benjamin.kaur@iconsigh.com Signed by (printed name): Benjamin Kaur Signature:

Applicant: INFINIX MOBILITY LIMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-

25 SHAN MEI STREET FOTAN NT HONGKONG FRN: 0025707605 Tel: 86-755-61803856 Email: jerry.liu@infinixmobility.com Signed by (printed name): Jerry Liu Signature: