FCC ID: 2AH2IIBS06 Card Beacon

INGICS TECHNOLOGY Guide Ver.0b iBS06 User Guide Introduction The document is a guide for iBS06. To quickly verify it, please download INGICS iBS01 Tag Utility APP from below link(Android only):

https://play.google.com/store/apps/details?id=com.ingics.tag.igstagcong Overview Operation Basically, iBS06 will always transmit BLE payload in the congured time interval(by default is 5s) after power on. The transmitted BLE payload/message is then received and uploaded to the internet/cloud server by the beacon gateway, such as iGS01S or iGS03W/M/E.. Power on Two CR2012 batteries are pre-installed in each iBS06 beacon at shipment. Please remove the isolation plastic sheet to power on it. You will see the LED ash when powered on. At power on, the user can congure it within 20 seconds. INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 1 INGICS TECHNOLOGY Power off Just pull out the battery slot to power off iBS06. LED Description Power on

( Start of Conguration mode) LED behavior Red blinking End of Conguration mode Green blinking Beacon connected for conguration Green ON Verifying 1. Power on iBS06 2. Open iBS01 Tag Utility APP and Press START SCAN. 3. Wait for a while, you should see the BLE payload of iBS06 received by the APP. Below is an explanation of the payload shown in the APP. INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 2 INGICS TECHNOLOGY Battery Level iBS06 uses two pieces of CR2012 coin battery as the power source. It consumes only a little power and keeps working for a long time. Below is a suggestion for translating the battery voltage to the remaining capacity at room temperature. Capacity Voltage High Middle Low

>2.9V

>2.7V

>2.6V Change battery

<=2.6V Remember, a proper ltering on the voltage is necessary. Change the battery 1. Pull out the battery slot 2. Change the new batteries.

*PLEASE MAKE SURE THE POLARITY IS CORRECT. INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 3 INGICS TECHNOLOGY 3. Plug the battery slot into iBS06.

*PLEASE MAKE SURE THE POLARITY IS CORRECT.. Conguration When powered on, iBS06 will be in conguration mode for 20 sec. Users can use iBS01 Tag Utility to scan and connect iBS06 to congure the transmit power and ADV(advertising) interval. Steps 1. Power on iBS06

(if iBS06 is already powered on, please power off it rst then power on again) 2. Press the CONFIG icon on the up-right corner of the utility within 20 secs. Select iBS06 for conguration. 3. In the SETTING page, you can congure TX power and ADV interval. After conguring, press SAVE and DISCONNECT for the parameters to take effect. Parameters In iBS06, there are two parameters that can be congured. a. TX power: +4 dBm ~ -20dBm. b. ADV Interval: From 100 ms~60 min. INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 4 INGICS TECHNOLOGY NFC(MIFARE) location Waste Electrical and Electronic Equipment Recycling Our product is compliant with the WEEE directive for re-use/recovery/recycling. This cross-out wheeled-bin symbol is a reminder that this product should not be treated as household waste. Instead hand it over to the appropriate collection point for the recycling of electrical and electronic equipment in accordance with local environmental regulations for waste disposal. Since our product is not sold directly to the end user and generally it is a part of our customers solution, our customer is recognized as a professional seller. Our customer has the responsibility to comply with the requirement of the directive too. To help our customers, when necessary, we will provide a WEEE compliant assessment report for registering and communicating with the local authorities and recycling agency. INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 5 INGICS TECHNOLOGY Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 0.5 cm from all persons and must not be co-

located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NCC Revision History DATE REVISION CHANGES Mar 18, 2022 Jun 7, 2022 0a 0b Initial release Add Statement section INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 6 INGICS TECHNOLOGY INGICS TECHNOLOGY CO., LTD. SUPPORT@INGICS.COM WWW.INGICS.COM 7

X X X X X X

X X X 6 0 S B I I 2 H A 2

D I x x x x x x x x x x x x x x C C F i n a w a T n i e d a M X X X X X X

X X X 6 0 S B I I 2 H A 2

D I x x x x x x x x x x x x x x C C F i n a w a T n i e d a M

INGICS TECHNOLOGY CO., LTD.2F., No.15-2, Changshou St., Shulin Dist., New Taipei City 238,Taiwan (R.O.C.)Federal Communications CommissionAuthorization and Evaluation DivisionEquipment Authorization Branch7435 Oakland Mills RoadColumbia, MD 210466/14/2022To whom it may concern:We, the undersigned, hereby authorize Eurofins Product Service GmbH to act on our behalf in allmatters relating to applications for equipment authorization FCC ID: 2AH2IIBS06 including the signingof all documents related to these matters. Any and all acts carried out by Eurofins Product Service GmbH on our behalf shall have the sameeffect as acts of our own.By signing this form, we agree to Eurofins current valid General Terms and Conditions (AGB),Testingand Certification Regulations (PZO) which can be viewed on following website www.eurofins.de/ee orretrieved on request.We also hereby certify that no party to this application is subject to a denial of benefits, including FCCbenefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862.Sincerely, SignatureJK FanPresidentINGICS TECHNOLOGY CO., LTD.

INGICS TECHNOLOGY CO., LTD.2F., No.15-2, Changshou St., Shulin Dist., New Taipei City 238, Taiwan (R.O.C.)Federal Communications CommissionEquipment Authorization Branch7435 Oakland Mills RoadColumbia, MD 21046 Date: 2022-06-07Request for Long-Term ConfidentialityCompany name: INGICS TECHNOLOGY CO., LTD.FCC ID: 2AH2IIBS06FCC Part 15 CertificationTo whom it may concern:In accordance with 0.457(d) and 0.459 of CFR 47, INGICS TECHNOLOGY CO., LTD. hereby requests Long-Term confidentiality of all Block Diagrams, Schematics, Operational Description attachments for the subject application.These documents contain detailed system and equipment description and relatedinformation about the product which INGICS TECHNOLOGY CO., LTD. considers to beproprietary, confidential and a custom design and otherwise would not release to thegeneral public. Since the design is a basis from which future technological products willevolve, INGICS TECHNOLOGY CO., LTD. considers that this information would be ofbenefit to its competitors and that the disclosure of the information in these documentswould give competitors an unfair advantage in the market.Sincerely, SignatureName: JK FanTitle: PresidentCompany: INGICS TECHNOLOGY CO., LTD.