_____________________________________________________________________________________________________ User Manual Product Family:
Range of use:
Low Cost K-Band Transceiver Security- / Door- applications IPS-265_F Module Number:
_____________________________________________________________________________________________________ Description:
radar-based motion detector available in different frequency ranges: Standard; _F and _UK variants advanced PHEMT-oscillator with low current consumption split transmit and receive path for maximum gain dual (stereo channel) operation very small outline dimensions Block Diagram:
Oscillator
I/Q-Mixer Tx Rx S1 S2 Environmental Tests and Handling Precautions:
This InnoSenT sensor is sensitive to damage from ESD. Normal precautions as usually applied to CMOS devices are sufficient when handling the device. Touching the signal output pins has to be avoided at any time before soldering or plugging the device into a motherboard Applying multimeters e.g. for resistance measurement between any of the connector pins may cause damage to the module. 1 von 3 DATA SHEET IPS-265_F 11-01-2011 Version 0.3 Electrical Characteristics:
Symbol min. typ. max. units comment Parameter Transmitter transmit frequency temperature drift frequency output power positive supply voltage positive supply current Receiver I/Q-balance IF-output Environment operating temperature outline dimensions Antenna antenna pattern (-3 dB) side lobe suppression Mechanical Outlines:
2 von 3 f IPS-265_F f P out Vcc Icc amplitude phase voltage offset OP T 24.075 60
-300
-20
-1 16 5 30 90
~ 25 x 25 x 7 (12.7) horizontal vertical horizontal vertical 80 32 13 13 24.175 GHz 40 6 120 300 60 MHz/C dBm V mA db mV C mm dB dB compare drawing azimuth elevation azimuth elevation DATA SHEET IPS-265_F 11-01-2011 Version 0.3 Interface:
The sensor provides a 2.54 mm grid, single row pin header (square pin 0.635 mm). Pin 1 2 3 4 5 Function NC VCC IF1 GND IF2 Description not connected supply voltage 5V signal 1 output GND signal 2 output Certification and environment protection:
InnoSenT GmbH has established and applies a quality system for:
Development, production and sales of radar sensors for commercial and industrial sensors An audit was performed, Report No. 010350 Proof has been furnished that the requirements according to DIN EN ISO 9001:2000 are fulfilled. This InnoSenT product is compliant to the restriction of hazardous substances
(RoHs European Union directive 2002/95/EG). FCC approval This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications made to this equipment not expressly approved by InnoSenT GmbH may void the FCC authorization to operate this equipment. Manufacturers of mobile or fixed devices incorporating IPS-265_F modules are authorized to use the FCC Grants and IC Certificates of the IPS-265_F modules for their own final products according to the conditions referenced in these documents. In this case, the FCC label of the module shall be visible from the outside, or the host device shall bear a second label stating "Contains FCC ID: UXS2" and "Contains IC: 5904A-UXS2". Contact Information:
InnoSenT GmbH Am Roedertor 30 97499 Donnersdorf Germany Phone: +49 (0) 9528-9518-0 Fax:
+49 (0) 9528-9518-99 E-Mail:
Web:
info@InnoSenT.de www.InnoSenT.de 3 von 3 DATA SHEET IPS-265_F 11-01-2011 Version 0.3