User Manual Product Family: K-Band Transceivers K-Band Transceiver with two integrated patch antennas IPM-165_US radar-based motion detector centered @ 24.125 GHz advanced PHEMT-oscillator with low current consumption This InnoSenT Sensor is sensitive to damage from ESD. Normal precautions as usually applied to CMOS devices are sufficient when handling the device. Touching the signal output pins has to be avoided at any time before soldering or plugging the device into a motherboard. Description:
- mono (single channel) operation
Handling Precautions:
very small outline dimensions Absolute Maximum Ratings:
Parameter supply voltage operating temperature (out of spec) storage temperature Electrical Characteristics:
Parameter transmit frequency output power (EIRP) temperature drift antenna pattern Tx (3dB) side lobe suppression IF output supply voltage supply current operating temperature outline dimensions Symbol ftransmit Pout Df horizontal vertical horizontal vertical voltage offset VCC ICC TOP Symbol VCC TOP TSTG Rating 5.25
- 40 / + 85
+ 90 Units V C C min. 24.075 typ. 24.125 max. 24.175 16
- 1 80 32 13 13
-300 4.75 5.0 30
- 20
~ 25 x 25 x 7 300 5.25 40
+ 60 units GHz dBm MHz/C dB dB mV V mA C mm comment azimuth elevation azimuth elevation Interface:
The sensor provides a 2.54mm grid, single row pin header (square pin 0.635mm) Pin # Description 1 2 3 VCC IF1 GND In/Out Comment input output signal output input analog ground supply voltage (+5 V) Version 1.0 2007-02-22 IPM-165_US page 1 of 3 Mechanical Outlines:
(all dimensions in mm) Approved pulsing conditions to fulfill the FCC requieremts:
ASK modulation with 10kHz and 10% dutycycle (on-time 10s min.) Warning: Any other pulsing condition with less than 10s on-time may void the FCC authorization to operate this equipment. Certification and environment protection:
InnoSenT GmbH has established and applies a quality system for:
Development, production and sales of radar sensors for commercial and industrial sensors An audit was performed, Report No. 010350 Proof has been furnished that the requirements according to DIN EN ISO 9001:2000 are fulfilled. This InnoSenT product is compliant to the restriction of hazardous substances
(RoHs European Union directive 2002/95/EG). FCC approval Operation is subject to the following two conditions:
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications made to this equipment not expressly approved by InnoSenT GmbH may void the FCC authorization to operate this equipment. Manufacturers of mobile or fixed devices incorporating IPM-165 modules are authorized to use the FCC Grants and IC Certificates of the IPM-165 modules for their own final products according to the conditions referenced in these documents. In this case, the FCC label of the module shall be visible from the outside, or the host device shall bear a second label stating "Contains FCC ID: UXS-IPM165" and "Contains IC: 6902A-
IPM165". Version 1.0 2007-02-22 IPM-165_US page 2 of 3 Phone: +49 (0) 9528-9518-0 Fax:
+49 (0) 9528-9518-99 E-Mail: info@InnoSenT.de Web: www.InnoSenT.de Contact Information:
InnoSenT GmbH Am Roedertor 30 97499 Donnersdorf Germany Version 1.0 2007-02-22 IPM-165_US page 3 of 3