How to assemble and install Link it a Link it Reader b Cradle Serial Port Keyboard Port Serial Port Cable Power Connecter Cable
To assemble Link it Reader and Cradle in vertical direction
To connect Serial Port Cable Connector with Com 1 or Com 2 port of P.C
To separate Connector of Keyboard from P.C.
To connect Power Connector with Keyboard Port of P.C. and to connect Connector of Keyboard with the end of Power Connector.
To insert Card into Link it Reader as shown in left side picture.
To remove Card from Link it Reader with Link it Reader being fixed by hand. Components of Link it Cautions
Link it Reader
Cradle
RS-232C Cable and Power Cable
Users Guide Link it Power
DC5V/100mA Inquiry about Link it and A/S Insis Co., Ltd. Tel.) 02-3421-0800 Fax.) 02-3421-0805 http://www.insis.net
To avoid installing Link it in humid or dusty or corrosive gas circumstances
To keep Link it far away from fire.
Do not give vibration or impact upon Link it
Do brush the outside of Link it with dry rag, inflammable materials such as not with alcohol or benzene, etc.
Do not dismantle Lint it at discretion as its composed of electronic precision circuits.
Be cautious not to infiltrate water or coffee into the inside of Link it..
To call A/S center of Insis Co., Ltd. for any inquiry or breakdown. Welcome to Smart Card World FCC NOTICE Caution :Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. Welcome to Smart Card World