CONFIDENTIAL 9 Important Application Information UniStone Important Application Information 9.1 Figure 9-1 Reference design Reference design schematics Product Specification 208 T3130-8XV10T4-7600, 2006-12-18
*n.p. means that the component is not mounted (i.e. not placed) UniStone CONFIDENTIAL Important Application Information PBA 31308 is intended to be installed inside an end user equipment. PBA 31308 is Bluetoooth, R&TTA and FCC qualified with the reference design described in Figure 9-
1 togheter with the following antenna:
Make gigaAnt Model Titanis Peak antenna gain Impedance 4 - 4.4 dBi 50 ohm Manufacturers of mobile, fixed or portable devices incorporating this device are advised to clarify any regulatory questions and to have their complete product tested and approved for compliance (FCC or other when applicable). There are no parts in PBA 31308 that can be modified by the user except modifications of the device BD data and loading of SW patches. Any changes or modifications made to this device that are not expressly approved by Infineon, may void the users authority to operate the equipment. FCC Class B digital devices regulatory notice 9.2 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 1 or more of the following measures:
Reorient or relocate the antenna Connect the equipment into an outlet on a circuit different from that to which the Increase the separation between the equipment and receiver receiver is connected Consult the dealer or an experienced radio or television technician for help FCC Wireless notice 9.3 This product emits radio frequency energy, but the radiated output power of this device is far below the FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that the potential for human contact with the antenna during normal operation is minimized. To meet the FCC's RF exposure rules and regulations:
Product Specification 209 T3130-8XV10T4-7600, 2006-12-18 CONFIDENTIAL Important Application Information UniStone The system antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The system antenna(s) used for this module must not exceed 4 dBi. Users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any regulatory questions and to have their complete product tested and approved for FCC compliance. FCC Interference Statement 9.4 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Identifier 9.5 FCC ID: Q2331308 European R&TTE declaration of conformity 9.6 Hereby, Infineon Technology AG, declares that the Bluetooth module PBA 31308 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. As a result of the the conformity assessment procedure described in Annex III of the Directive 1999/5/EC, this equipment will be labelled as follows:
0682 PBA31308 in the specified reference design can be used in the following countries:
Austria, belgium, Cyprus, Czech republic, Denmark Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Poland, Portugal, Slovakia, Slovenia, Spain, Sweden, The Netherlands, United Kingdom, Switzerland, Norway, Iceland Product Specification 210 T3130-8XV10T4-7600, 2006-12-18 CONFIDENTIAL Important Application Information UniStone Product Specification 211 T3130-8XV10T4-7600, 2006-12-18 UniStone CONFIDENTIAL 9.7 PBA31308 comply with the regulatory requirements of Industry canada (IC), license:
Industry Canada Certification Important Application Information IC: 6850A-31308 Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any regulatory questions and ensure compliance for SAR and/or RF exposure limits. Users can obtain Canadian information on RF exposure and compliance from www.ic.gc.ca This device has been designed to operate with the antenna listed in section 8.1 above , having a maximum gain of 4.0 to 4.5 dBi. Antennas not included in this list or having a gain greater than 4.0 dB are strictly prohibited for use with this device. The required antenna impedance is 50 ohms. The antenna used for this transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter. Label design of the host product 9.8 It is recommended to include the following information on the host product label:
Contains transmitter Module FCC ID: Q2331308 / IC: 6850A-31308 Product Specification 212 T3130-8XV10T4-7600, 2006-12-18