iON MICRA Recessed Transmitter A DAMITIONS setcre tering ary roses, mate wie that waccesah tharamegion trcepten tevt haw teen conducted A CAUTION: ssrrtny caumons rst ot frm, expos aod burma. Do nt rrcharge, chunaerrse, beat shove 212F (HOO"C) ot inonerate, Binpow of cued bettenes promartly. Ceep away from chicren MOUNTING (See Figure 1) 1. Mark the selected location for the transmitter on the frame of the window. 2. Mark the lotation forthe magnet on the window sash, directly opposite the transmitter location. Before drilling any holes, make sure that the successful Goo Go transminion receptin tests have been conducted as-called for in the JON MICRA traninitter section. (see page back) 2. Drill holes at the location marked, for the transmitter (3/4" diameter, no more than 1/3* deep). 4 Insert the transmitter Into the hole so that the cap is flush with the surface. Make sure the antenna goes into the cavily as straight as DO NOT hammer the transmitter or the magnet in place with hard blows. Press thern inte their respective holes bry bared. The ION MICRA inet a santaprene case that, once placed, ts designed to selt-seal in the mounting hole. However, if desired, a thin bead of silicon may be applied for additional moisture pratection, Nagse?
fishes Pert 15. Ope
| Thes device may not cane hard amerlererse TO THE INSTALLER Regular maintenance and ingpection (at least annually) by the installer and frequent testing by the user are vital to continuous satitactory operation of any alarm system, The installer should assume the retgonsibility of developing and offering a regular maintenance program to the user, as well as acquainting the uver with the proper operation and limitations of the alarm system ard itt component parts. Recommendations mut be included for a specific program af frequent testing (at boast weekly) to insure the system's operation at ail times REFER TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER / CONTROL WITH WHICH THIS DEVICE IS USED, FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM, BATTERY INSTALLATION & REPLACEMENT 1. Remove the transmitter from the window by inverting the flat blade of a small screwdriver into the pry-slot on the cap end and twisting slightly counterclockwise. The tranumitter must be remaved from the window complete in onder to refit the tranamitier properly back into the hole once the internal battery has been replaced. 2. Using the flat blade of a email screwdriver in the pry-slot again, separate the white cap from fhe orange bave with a slight ave twist Once open, slike the cap with the transmitter PC board assembly apart from the orange bave. Pull the antenna through the hole in the orange bane just enough to allow the battery to be replaced. Do not pull the antenna completely cut of the orange bave. 3. Remove the old battery from it's battery holder on the battam of the PC board. US Patent No. 6,737,969 Copyright 2005 ION Digital LLF STEP 3&4 STEP S& 6 4. Obterve correct polarity (see Figure J Step 3 4 4) and invert the fresh battery into the battery holder [positive polarity indicator is shown on the battery holder). 5. Slide the cap with the PC board assembly back into its orange base by penily pulling on the antenna, eating the traremitter cap into place. 6, Snap the transmitter cap back onte the orange base, locking it into place. 7. Placing th Into the cavity first, the into. its-origanal mounting hobe in the window. Ge sure to point the "SON"
graphic on the cap in the same direction ai the TON! graphic on the accompanying sath-mounted magnet. a Toll Free 1-800-407-4389 4 eww ion-digital com : o THE SENSE OF SECURITY