FCC ID:LK4GB-1000 GB-1000 Iwill four ports thin server THIN SERVER CPU GTL CHIPSET PCI SLOT LAN ULTRA 160(Optional) ATA66 IDE*2 FDD KEYBOARD PS/2 MOUSE Hardware A20gate CPU FAN SYS FAN DOC USB 2S, 1P POWER CON. LAN LED SCSI 68PIN FORNT CON. CMOS CLEAR PCB SIZE HDD DEVICE POWER SUPPLY ACPI A PGA370 1 VIA693A+596B 1 W/RISER CARD INTEL82559 * 4 N/A YES YES YES W/CABLE N/A YES 1 2 DIP32*1 OR SMD32*2 1 YES ATX 20PIN FORNT+BACK N/A RESET+IDE+POWER YES 24*17CM N/A 180W 5V 16A/12V 7A N/A 1 User manual 4-8 OFF ON OFF ON OFF ON OFF ON OFF ON ratio 3-7 ON ON ON ON ON OFF OFF OFF OFF OFF 2-6 OFF ON ON OFF OFF ON ON OFF OFF ON 1-5 ON OFF OFF OFF OFF ON ON ON ON OFF Fan Connector JP1 FAN1 JP11 FAN2 JP12 FAN3 JP13 FAN4 CPU ratio JP3 3.5X 4X 4.5X 5X 5.5X 6X 6.5 7X 7.5X 8X FSB speed JP5 FSB 66Mhz 100Mhz 133Mhz FORNT PANEL JP6 RESET:1-2 POWER LED: 3-4 IDE LED:5-6 CMOS RAM CLEAN JP7 1-2 NORMAL 2-3 CLEAN (MUST ON POWER-OFF SETTING) JP5 (OTHER OFF) 8-7,6-5(DEFAULT) 8-7 OFF 2 JP8 OTHER OFF 1-2 ON 3-4 ON 5-6 ON JP9 OTHER OFF 1-2 ON 3-4 ON 5-6 ON DOC SELECTOR JP8 (SMD TYPE U23,24) ADDRESS C800-C9FF D000-D1FF D800-D9FF DOC SELECTOR JP9 (DIP TYPE U21) ADDRESS C800-C9FF D000-D1FF D800-D9FF LAN PORT LED JP10 LAN PORT 1 LAN PORT 2 LAN PORT 3 LAN PORT 4 P S/2 keyboard connector J6 1 2 3 4 5 Keyboard Data NC GND VCC Keyboard Clock ACTIVE/LINK 2-4 6-8 10-12 14-16 100MBPS 1-3 5-7 9-11 13-15 3 FCC GUIDELINES This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Use only shielded cables to connect I/O devices to this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Information to User:
F Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. Shielded interface cable, if any, must be used in order to comply with emission limits. IBM AT and PS/2 are registered trademarks of International Business Machines Corporation. Microsoft and Windows are registered trademarks of Microsoft Corporation in the United States and/or other countries. All other trademarks are trademarks of their respective holders. 3100504464 Version 1.0 November 1999 Printed in China